Philips Multigroom Grooming kit QG3030
Contents
1. is very delicate Do not clean the foil with the brush as this can cause damage Blow and or shake out any hair that has accumulated in the attachment Clean the outside and inside of the attachment with the brush supplied Fig 16 Wl Place the attachment back onto the appliance gee Replacem en t ee Only replace worn or damaged attachments or combs with original Philips replacement attachments or combs that are available from your dealer or an authorised Philips service centre If you have any difficulties obtaining replacement attachments or combs for your appliance contact the Philips Consumer Care Centre in your country or consult the worldwide guarantee leaflet gee Environment m Do not throw away the appliance with the normal household waste at the end of its life but hand it in at an official collection point for recycling By doing this you help to preserve the environment Fig 17 The built in rechargeable battery contains substances that may pollute the environment Always remove the battery before you discard and hand in the appliance at an official collection point Dispose of the battery at an official collection point for batteries If you have trouble removing the battery you can also take the appliance to a Philips service centre The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way Fig 18 Removing the rechargeable battery Remo2. play with the appliance Caution Use charge and store the appliance at a temperature between 15 C and 35 C Only use the adapter supplied to charge the appliance If the adapter is damaged always have it replaced with one of the original type in order to avoid a hazard Do not use an attachment or comb if it Is damaged or broken as this may cause injury This appliance is only intended for trimming the human beard moustache and sideburns shaving the human beard line and contouring human scalp hair Do not use it for any other purpose Ifthe appliance is subjected to a major change in temperature pressure or humidity let the appliance acclimatise for 30 minutes before you use It Do not place the beard trimming comb on the precision attachment Compliance with standards This Philips appliance complies with all standards regarding electromagnetic fields EMF If handled properly and according to the instructions In this user manual the appliance is safe to use based on scientific evidence available today m Char gi Ge Charge the appliance fully before you use it for the first time or after a long period of disuse It takes approx 10 hours to charge the battery fully A fully charged appliance has a cordless operating time of up to 35 minutes When you charge the appliance for 3 hours you can use it for 15 minutes The appliance does not run from the mains Make sure the appliance is swit
3. Register your product and get support at www philips com welcome OG3030 PHILIPS Se ENGLISH mm ntroduction ma Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your product at www philips com welcome m General description Fig 1 ees 2D Contour Tracking beard trimming comb flexible Micro shaver Precision attachment Trimming attachment Appliance plug Adapter Charging light Cleaning brush Socket for appliance plug On off slide Release button Hair length selector THFA IATTMMONBD gt gee MM portant Read this user manual carefully before you use the appliance and save it for future reference Danger Make sure the adapter and the appliance do not get wet Warning Check if the voltage indicated on the adapter and on the appliance corresponds to the local mains voltage b efore you connect the appliance The adapter contains a transformer Do not cut off the adapter to replace it with another plug as this causes a hazardous situation This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not
4. ched off during charging Insert the appliance plug directly into the appliance Fig 2 D The charging light on the adapter indicates that the appliance is charging Fig 3 Optimising the lifetime of the rechargeable battery Do not leave the appliance connected to the mains for more than 24 hours Discharge the battery completely twice a year by letting the motor run until it stops Then fully recharge the battery ge rim min g Preparing for trimming Make sure that the hair is dry and clean Comb the hair in the direction of growth with a comb Beard trimming with comb Put the beard trimming comb on the trimming attachment and push it home click Fig 4 Press the hair length selector and slide it to the desired setting see table below Fig 5 D The selected setting appears in the window to the left of the hair length selector Note When you trim for the first time start at the highest setting 9 to familiarise yourself with the appliance Note Using setting 1 with the comb installed results in a stubble look Settings of beard trimming comb 2mm 4mm 6mm 8mm 10mm 12mm 14mm 16mm o EF n OR UO ES WwW lH 18mm To trim in the most effective way move the appliance slowly against the direction of hair growth Fig 6 Do not move the appliance too fast Make smooth and gentle movements and make sure the surface of the comb always stays in contact with the skin Regularl
5. ld the appliance with the teeth of the trimming attachment pointing towards the skin Fig 10 Defining beard moustache and sideburns To remove the comb press the hair length selector 1 and slide the comb upwards 2 Fig 7 Press the release button 1 and pull the trimming attachment off the appliance 2 Fig 11 Put the precision attachment on the appliance click Fig 12 BD Hold the appliance upright when you use the precision attachment Fig 13 m Shaving Shaving with the micro shaver attachment Before you use the micro shaver attachment always check it for damage or wear If the foil or cutter is damaged or worn do not use the attachment as injury may occur Replace the foil or the cutter before you use the attachment Put the micro shaver attachment on the appliance Fig 14 Gently press the micro shaver attachment onto the skin Do not press too hard Shave along contoured edges to remove any stubble and to create a smooth well defined beard line m Cleaning m Do not clean the appliance with water or a moist cloth Never use scouring pads abrasive cleaning agents or aggressive liquids such as alcohol petrol or acetone to clean the appliance Make sure the appliance is switched off and disconnected from the mains Remove the comb and or attachment Separate the top part of the micro shaver attachment from its body Fig 15 Avoid touching the shaving foil as it
6. ve the adapter from the wall socket and pull the appliance plug out of the appliance Let the appliance run until the motor stops Insert a screwdriver in the groove next to the shaft at the top of the appliance Turn the screwdriver to separate the two housing halves Fig 19 Lift the battery out of the housing with a screwdriver Twist the connecting wires until they break Fig 20 Do not connect the appliance to the mains again you have removed the battery gee Guarantee and service EEE If you need service or information or if you have a problem please visit the Philips website at www philips com or contact the Philips Consumer Care Centre in your country you find its phone number in the worldwide guarantee leaflet If there is no Consumer Care Centre in your country go to your local Philips dealer
7. y remove the comb to blow and or shake out hair that has accumulated You have to set the trimming length again after you have removed the comb Beard trimming without comb Trimming without the comb results in a very short stubble beard Be careful when you use the appliance without the comb because the trimming attachment removes every hair it touches To remove the comb press the hair length selector 1 and slide the comb upwards 2 Fig 7 Never pull at the flexible top of the comb Always pull at the bottom part Make well controlled movements and touch your beard only lightly with the trimming attachment Contouring scalp hair without comb Use the appliance without the comb to contour scalp hair edges Be careful when you use the appliance without the comb because the trimming attachment removes every hair it touches To remove the comb press the hair length selector 1 and slide the comb upwards 2 Fig 7 Never pull at the flexible top of the comb Always pull at the bottom part Make well controlled movements and touch the scalp hair contours only lightly with the trimming attachment To shape the contours round the ears tilt the appliance in such a way that only one edge of the trimming attachment touches the hair ends Fig 8 To contour the nape hairline hold the appliance with the teeth of the trimming attachment pointing towards the skin Fig 9 To contour the sideburns ho
Download Pdf Manuals
Related Search