EK Water Blocks 3831109840009
Contents
1. Put together reservoir and pump and make sure all 4 screws fall into threaded holes on pump Afterwards screw them in with enclosed allen key Final product should look like on picture above step 1 CAUTION Please do not use high force when tightening the mounting screws Applying too much force may damage the mounting screw or threads in the pump and may render the pump useless Released on 4 of November 20092. Installation and mounting manual for EK Reservoir Combo DCP 2 2 4 0 This product is intended for installation only by expert users Please consult with a qualified technician for installation Improper installation may result in damage to your equipment EKWB d o o assumes no liability whatsoever expressed or implied for the use of these products nor their installation The following instructions are subject to change without notice Please visit our web site at www ekwaterblocks com for updates The barb hose fittings require only a small amount of force to screw them in otherwise the high flow fittings might break These fittings do not need to be tightened with much force because the liquid seal is made using o rings EKWB recommends 24 hour leak testing for all EK products before powering on the computer This will eliminate any damages that may occur because of the users improper installation or products imperfections 1 REMOVING SCREWS Take your pump picture represents EK DCP 4 0 out 2 Insert 4 enclosed screws M3x20 1SO7380 into holes After that insert of package and unscrew screws that are holding cover on pump housing DO gasket into the channel as shown on picture bellow NOT open pump as there is no need for doing that Put together reservoir and pump and make sure all 4 screws fall into threaded holes on pump Afterwards screw them in with enclosed allen key Final product should look like on picture above step 1 CAUTION Ple
3. ase do not use high force when tightening the mounting screws Applying too much force may damage the mounting screw or threads in the pump and may render the pump useless Released on 4 of November 2009 Installation and mounting manual for EK Reservoir Combo DCP 2 2 4 0 This product is intended for installation only by expert users Please consult with a qualified technician for installation Improper installation may result in damage to your equipment EKWB d o o assumes no liability whatsoever expressed or implied for the use of these products nor their installation The following instructions are subject to change without notice Please visit our web site at www ekwaterblocks com for updates The barb hose fittings require only a small amount of force to screw them in otherwise the high flow fittings might break These fittings do not need to be tightened with much force because the liquid seal is made using o rings EKWB recommends 24 hour leak testing for all EK products before powering on the computer This will eliminate any damages that may occur because of the users improper installation or products imperfections 1 REMOVING SCREWS Take your pump picture represents EK DCP 4 0 out 2 Insert 4 enclosed screws M3x20 1SO7380 into holes After that insert of package and unscrew screws that are holding cover on pump housing DO gasket into the channel as shown on picture bellow NOT open pump as there is no need for doing that
Download Pdf Manuals
Related Search