AMX MXA-HST
Contents
1. Overview The MXA HST Modero X Series Bluetooth Handset FG5968 17 is an optional accessory for use with the Modero X Series Touch Panels The handset allows wireless Bluetooth audio communication through the touch panel while the handset s Charging Cradle allows recharging either with a USB connection to the touch panel or via the included electrical adapter Indicator Light Volume Up Volume Down Buttons Multi Function Button Mute Button Front Back FIG 1 MXA HST Handset Product Specifications MXA HST Specifications DC 5V 500mA v2 1 EDR Class 2 Headset v1 2 HandsFree v1 5 Range of Frequency 2 4GHz Spectrum Nominal Charging Time Within 8 hours Talk Time Up to 35 hours Standby Time Up to 200 hours Dimensions HWD e Handset 6 88 x 1 62 x 0 77 17 46 cm x 4 12 cm x 1 95 cm e Charging Cradle 1 93 x 3 64 3 01 5 06 cm x 9 25 cm x 7 65 cm e Handset 0 2 lbs 90 72 g e Charging Cradle 0 2 lbs 90 72 g e CE e Bluetooth e FCC part 15 Class A e MXA IPA International Power Adapter Accessory Kit FG5968 31 e MXA BT Bluetooth USB Adaptor FG5968 19 Power Requirements Bluetooth Specification Bluetooth Profiles Supported Certifications Other AMX Equipment Safety and Battery Charging Information Safety Information e Do not dismantle open or shred the battery e Do not short circuit the battery Do not store batteries haphazardly in a box or2. AMX All rights reserved AMX and the AMX logo are registered trademarks of AMX AMX reserves the right to alter specifications without notice at any time 3000 RESEARCH DRIVE RICHARDSON TX 75082 e 800 222 0193 fax 469 624 7153 technical support 800 932 6993 e www amx com Using the MXA HST with a Modero X Series Touch Panel Using the MXA HST with a Modero X Series Touch Panel Power ON Press and hold Short beep through Flash white light MFB for 2 the earphone 3 times seconds Power OFF Press and hold MFB for 2 times and then seconds turns off Standby Wake Up N A N A Flash white light every 10 seconds Fully Fully Charged NA Solid white Solid white light Low ce beep through Flash red oe the al Out of Out of battery NA fall All lights turn off turn off a A of range E a beep through CL blue light the o for 5 seconds Pairing Press and hold Flash white and MFB for 8 blue lights seconds alternately Incoming Call N A Ringtone through the Blinking blue light earphone Answer End a call Press MFB once Two step up tones Flash white light for Answer every 10 seconds Two step down tones for Hang up Adjust Volume Press VOL UP Short beep through N A and VOL DOWN the earphone Last Number Redial Press MFB twice Reject Incoming Call Hold VOL UP or Short beep N A VOL DOWN for 2 seconds Press Mute Two step down tone Solid red light button once for Mute On wit
3. and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate the receiving antenna e Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected e Consult the dealer or an experienced radio TV technician for help Indicator Light Status The indicator light on the back of the MXA HST FIG 1 flashes and changes color based on the handset s current status Indicator Light Status Fully Charged OFF STATE Charging ON STATE Fully Charged ON STATE C Out of Range Solid blue for 5 seconds Getting Started To use your MXA HST Bluetooth handset 1 Ensure that your handset is fully charged 2 Ensure that you have installed an MXA BT Bluetooth USB Adaptor FG5968 19 to the USB port of your touch panel NOTE An MXA BT Bluetooth USB Adaptor is necessary to use the MXA HST with a Modero X Series touch panel 3 Ensure that you have the latest Modero X Ser
4. drawer where they may short circuit each other or be short circuited by conduc tive materials e Do not remove a battery from its original packaging until required for use e Do not expose batteries to heat or fire Avoid storage in direct sunlight e Do not subject the batteries to mechanical shock e Inthe event of a cell leaking do not allow the liquid to come in contact with the skin or eyes If contact has been made wash the affected area with copious amounts of water and seek medical advice e Equipment should be designed to prohibit the incorrect insertion of the battery and its connector e Store the batteries in a dry place with the temperature between 32 F 0 C and 104 F 40 C Installation Guide MXA HST Modero X Series Bluetooth Handset e Secondary batteries give their best performance when they are operated at normal room temperature 68 F 5 20 5 C CAUTION Risk of explosion if battery is replaced by an incorrect type Dispose of used batteries according to the instructions Charging e Use only with approved charger e Charge with a constant voltage constant current battery charger circuit with the following parameters Maximum charge voltage 5 2 0 5 VDC Maximum charge current 120 mA Charging temperature range 2 5 deg C to 37 5 deg C 2 5 deg C Disposal e When disposing of batteries keep cells or batteries of different electrochemical systems separate from each other e Rec
5. h 2 beeps every 10 seconds Two step up tone for Mute Off Long beep through the earphone Flash blue light 2 93 5968 17 REV A U1 UIQ IAA Bud LP
6. ies Panoramic Touch Panel firmware installed on your panel 4 Ensure that you have the latest versions of the AMX Communications Application and the Panel to Panel Video Chat Module uploaded to your network Master These modules are required for full button functionality with intercom and video conferencing NOTE The Modero X Series Panoramic Touch Panel firmware the AMX Communications Application and the Panel to Panel Video Chat Module may be downloaded at www amx com 5 Pair your charged handset with a Modero X Series touch panel For more information please refer to the Pairing the MXA HST with a Modero X Series Touch Panel section on page 2 below Charging the MXA HST The MXA HST comes with a built in rechargeable battery Prior to using the handset for the first time fully charging the battery is highly recommended To charge your handset 1 If you wish to charge your MXA HST via USB insert the USB plug of the Charging Cradle FIG 2 into an available USB port on the Modero X Series touch panel 2 Insert the base of the handset into the Charging Cradle The indicator light on the back of the handset will turn blue while the handset is charging and solid white when it is fully charged The charging indicator will be delayed for a few seconds if the handset has not been used for a long time or the battery is drained NOTE Use only the supplied Charging Cradle and USB charging cable to charge the handset WARNING Do no
7. t use the handset while it is seated in the Charging Cradle NOTE Fully charging the handset may require up to eight hours et ee MMM FIG 2 MXA HST Charging Cradle front Pairing the MXA HST with a Modero X Series Touch Panel To pair your handset with a Modero X Series touch panel 1 Ensure that your handset is off before starting 2 To activate the pairing mode press and hold the handset s Multi Function Button MFB FIG 1 for 8 seconds 3 From the touch panel s Settings Pages pair the device with the touch panel For more information on pairing a Modero X Series touch panel with a Bluetooth device please refer to the Modero X Series Programming Guide available from www amx com 4 Ifthe pairing cannot be completed within two minutes after the pairing mode has been activated the indicator light on the back of the MXA HST will flash blue rapidly five times and then shut off Repeat steps 1 through 3 to pair both devices again Resetting the MXA HST Removing Its Pairing History To reset your MXA HST handset or remove its Bluetooth pairing history 1 While the handset is in OFF mode hold the Volume button and seat the hand set into the Charging Cradle The indicator light will flash blue twice 2 Release the Volume button 3 The indicator light will stay blue again and the handset is reset For full warranty information refer to the AMX Instruction Manual s associated with your Product s 12 12 2012
8. ycle or dispose of this battery in accordance with local regulations 1 When this crossed out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002 96 EC 2 All electrical and electronic products battery should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities 3 The correct disposal of your old appliance battery will help prevent potential negative consequences for the environment and human health For more detailed information about disposal of your old appliance battery please contact your city office waste disposal service or the shop where you purchased the product FCC Notice This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment NOTE This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses
Download Pdf Manuals
Related Search