Nokia BH-217
Contents
1. To place the headset into the clip or cradle slide the headset into place 14 To remove the headset slide it out Install the car cradle When you install the cradle in a car make sure it does not interfere with or hinder the steering or braking systems or other systems used in the operation of the vehicle for example airbags or disturb your field of vision while driving Check that the deployment of the airbag is not blocked or impaired in any way To install the car cradle peel off the protective sheet from the cradle and press the cradle against a flat surface so that it stays firmly in place Do not install the cradle in a place where you might come in contact with it in the event of an accident or collision 8 Copyright 2010 Nokia All rights reserved Use the car cradle When you use the headset with the cradle in a car obey all local laws Always keep your hands free to operate the vehicle while driving Your first consideration while driving should be road safety Only operate the headset or car cradle if it is safe to do so under all driving conditions Periodically check that the adhesive at the bottom of the car cradle is firmly attached especially if the ambient temperature changes a lot It is recommended that you do not leave the car cradle inside the vehicle in direct sunlight or in excessive heat Adjust volume The headset automatically adjusts the volume according to ambient noise2. To manually adjust the Copyright 2010 Nokia All rights reserved volume use the volume controls of the connected device The selected volume level is saved for the device that is currently connected to the headset Calls To make a call use your mobile device in the normal way when the headset is connected to it To redial the number you last called if your mobile device supports this feature with the headset when no call is in progress press the multifunction key twice when the headset is not in the clip or car cradle To activate voice dialling if your mobile device supports this feature with the headset when no call is in progress press and hold the multifunction key for about 2 seconds when the headset is not in he clip or cradle Proceed as described in the user guide of the mobile device o answer a call remove the headset from the clip or cradle If he headset is not in the clip or cradle press the multifunction key 0 reject a call press the multifunction key twice or place he headset into the clip or cradle o end a call place the headset into he clip or cradle or press the multifunction key when the headset is not in the clip or cradle o switch a call between the headset and a compatible connected device press and hold he multifunction key for about 2 seconds Connect to two devices he headset can be connected to wo devices at the same time Pair and connect to two dev
3. Nokia Bluetooth Headset BH 217 Issue 1 0 Copyright 9 2010 Nokia All rights reserved DECLARATION OF CONFORMITY Hereby NOKIA CORPORATION declares that this BH 217 product is in compliance with the essential reguirements and other relevant provisions of Directive 1999 5 EC A copy of the Declaration of Conformity can be found at http Introduction www nokia com phones declaration of conformity C 2150 2010 Nokia All rights reserved Bluetooth is a registered trademark of Bluetooth SIG Inc With the Nokia Bluetooth Headset BH 217 you can make and answer calls hands free with your compatible mobile device Read this user guide carefully before using the headset Also read the user guide for the device that you connect to the headset Le Warning The connector of the clip and car cradle may contain a small amount of nickel Persons who are sensitised to nickel may have symptoms from prolonged skin contact with the connector Bluetooth compatibility The headset is compliant with the Bluetooth Specification 2 1 EDR supporting the Headset Profile 1 1 and Hands Free Profile 1 5 Check with the manufacturers of other devices to determine their compatibility with this device Copyright 2010 Nokia All rights reserved Get started The headset contains the following parts shown on the title page multifunction key 1 earloop 2 indicator light 3 earpiece 4 microph
4. adset is not connected to a charger press the multifunction key when the headset is connected to a mobile device If the indicator light is green the charge level is sufficient If the light is yellow you may need to recharge the battery soon If the light is red recharge the battery When the battery charge is low the headset beeps every 5 minutes the red indicator light flashes and if Copyright 2010 Nokia All rights reserved voice prompts are activated there is an audible notification If voice prompts are activated there is also an audible notification when the battery is completely discharged Switch the headset on Remove the headset from the clip or car cradle If the headset is not in the clip or cradle press the multifunction key The headset beeps and the green indicator light flashes slowly while the headset tries to connect to the last or two last connected devices When the headset is connected to at least one device and is ready for use the blue indicator light flashes slowly If the headset has not been paired with a device it automatically enters pairing mode Switch the headset off Place the headset into the clip or car cradle or press and hold the multifunction key for about 5 seconds The headset beeps and the red indicator light is briefly displayed If the headset is not connected to a device within about 30 minutes it switches off automatically Pair and connect the heads
5. er device is connected or make the connection in the Bluetooth menu of the device You may be able to set your device so that the headset connects to it automatically To activate this feature in a Nokia device modify the paired device settings in the Bluetooth menu Change the earpad The headset may be provided with different sized earpads Select the earpad that fits the best and is the most comfortable for your ear To change the earpad pull the current earpad from the earpiece Copyright 2010 Nokia All rights reserved and push the new earpad into place 7 Place the headset on the ear To use the headset with the earloop attach the earloop to it 11 To detach the earloop gently pull it from the headset You can rotate the earpad to keep he headset securely in the ear 8 For ekample if you use the headset on the right ear you may need to rotate the earpad to the right for he best fit If you wear an earring make sure it is not accidentally attached to the earpad 0 place the headset on the ear slide the earloop behind your ear 9 and gently push the earpiece against your ear Point the headset owards your mouth 10 Store in the clip or car cradle When you do not keep the headset on your ear store it in the clip or car cradle When the headset is in the clip or cradle it is switched off When you remove the headset from the clip or cradle the headset automatically switches on
6. et Before using the headset you must pair and connect it to a compatible device You can pair the headset with up to eight devices but you can connect it to a maximum of two devices at a time To pair and connect the headset toa device Make sure your mobile device is switched on and the headset is off If the headset has not been previously paired with a device switch on the headset The headset enters pairing mode and the blue indicator light starts to flash quickly If the headset has been previously paired with a device make sure the headset is switched off and not placed in the clip or car cradle and press and hold the multifunction key for about 5 seconds until the blue indicator light starts to flash quickly Within about 3 minutes activate Bluetooth on your device and set it to search for Bluetooth devices For details see the user guide of your mobile device 6 Copyright 2010 Nokia All rights reserved 4 Select the headset from the list of found devices 5 If necessary enter the passcode 0000 to pair and connect the headset to your device In some devices you may need to make the connection separately after pairing When the headset is connected to at least one device and is ready for use the blue indicator light flashes slowly Basic use To manually connect the headset to the last used device press and hold the multifunction key for about 2 seconds when no oth
7. ices To pair the headset with two devices switch on the headset activate pairing mode and pair it with the first device Switch off the headset activate pairing mode and pair it with the second device To connect the headset to the two devices switch the headset off and back on Handle calls If the headset can connect to two devices at the same time and you use redialling or voice dialling the call is made on the device that you last used to make a call when the headset was connected to it To answer a call on one connected device and end the active call on the other device press the multifunction key 10 Copyright 2010 Nokia All rights reserved To answer a call on one connected device and put the active call on hold on the other device press and hold the multifunction key for about 2seconds To end the active call on one connected device and make the call on hold active on the other device press the multifunction key To switch between the active call on one device and the call on hold on the other device press and hold the multifunction key for about 2 seconds Activate or deactivate voice prompts Make sure the headset is switched off and not placed in the clip or car cradle Press and hold the multifunction key for about 5 seconds and press and hold the multifunction key again for about 2 seconds When you activate the prompts the green indicator light flashes once When you deactiva
8. one 5 and charger connector 6 Before using the headset you must charge the battery and pair the headset with a compatible device Compatible chargers This device is intended for use when supplied with power from the following chargers AC 3 AC 4 AC 5 AC 8 DC 4 and DC 9 The exact charger model number may vary depending on the type of plug The plug variant is identified by one of the following E X AR U A C K or B Charge the battery 1 Connect the charger to a wall outlet 2 Connect the charger cable to the charger connector To charge the headset when it is in the clip or car cradle insert the lower end of the headset into the clip or car cradle 12 and connect the charger cable to the charger connector on the clip or cradle 13 The red indicator light is displayed during charging Charging the battery fully may take up to 2 hours 3 When the battery is fully charged the green indicator light is displayed Disconnect the charger from the headset or 4 Copyright 2010 Nokia All rights reserved from the clip or car cradle then from the wall outlet The fully charged battery has power for up to 5 hours of talk time When you keep the headsetin the clip or car cradle the fully charged battery has power for up to 3 months of standby time When you use the headset without the clip or cradle the standby time is up to 100 hours To check the battery charge when the he
9. te the prompts the yellow light flashes once In both cases there is also an audible notification Clear pairings To clear the pairings from the headset switch off the headset and press and hold the multifunction key for about 8 seconds The headset beeps twice the red and green indicator lights alternate and the headset enters pairing mode Troubleshooting If you cannot connect the headset to your compatible device make sure the headset is charged switched on and paired with the device Copyright 2010 Nokia Alll rights reserved 11
Download Pdf Manuals
Related Search