Home
Peerless HL4UN-002-Q10 flat panel desk mount
Contents
1. slope nut as shown in figure 3 2 Repeat with remaining 1 4 20 x 1 3 4 carriage bolt A Fasten two plastic caps G AP TIGHTENING SLOPE NUT G FIGURE 3 1 FIGURE 3 2 NOTE Do not overtighten slope nut D plate may distort Installation of Security Screws for Base Screen Assembly Thread two M4 x 16 phillips pan trilobe screws B to bottom display attachment holes as shown in fig 4 1 CD Remove the two M4 x 16 phillips pan trilobe screws B and attach display screen to display base using two M4 x 16 mm socket pin screws I or M4 x 12 mm socket pin screws E with 8 flat washers F as shown in figure 4 2 Tighten with 4 mm security allen wrench H Use TV supplied screws for remaining holes A WARNING BOTTOM OF DESKTOP e If screws don t get three complete turns in the screen inserts or if screws bottom out and bracket is still not tightly secured damage may occur to screen or product may fail NOTE Screws are installed using bottom NOTE Display and base may appear two display mounting locations different than illustrated DISPLAY SCREEN DISPLAY SCREEN DISPLAY BASE fig 4 1 F fig 4 2 2of2 ISSUED 06 03 11 SHEET 120 9110 1 2011 Peerless Industries Inc All rights reserved All other brand and product names are trademarks or registered trademarks of their respective owners
2. peerless Installation and Assembly Lock Down Hardware for Display Base Stands Model HL4UN 002 HL4UN 002 Q10 Parts Li st HL4UN 002 HL4UN 002 Q10 Description Part i Part 1 4 20 x 1 3 4 carriage bolt M4 x 16 mm phillips trilobe screw M4 x 16 mm socket pin screw 1 4 20 sloped nut M4 x 12 mm socket pin screw 8 flat washer plastic cap 4 mm allen wrench TOOLS NEEDED e drill e 9 32 drill bit e 5 8 open box wrench Measure distance between center lines of cut outs in Insert two 1 4 20 x 1 3 4 carriage bolts A bottom of display base Use measurement to mark 2 into bottom of display base as shown in detail 1 location of holes at point 1 and point 2 on table Drill two holes using a 9 32 drill bit NOTE Display and base may appear different than illustrated POINT 1 eee MEASURE DISTANCE ett Pee cee POINT 2 DETAIL 1 BOTTOM OF BASE 1 of 2 ISSUED 06 03 11 SHEET 120 9110 1 Hand tighten slope nut D through 1 4 20 x 1 3 4 carriage bolt A until snug against bottom of desktop surface Thread another slope nut D upside down about two turns from first slope nut D Insert an open box wrench between both slope nuts D and tighten NOTE Avoid jamming both slope nuts D together doing so may make it difficult to remove slope nut used for tightening first slope nut D as shown in figure 3 1 After slope nut is secure remove bottom
Download Pdf Manuals
Related Search
Related Contents
TM50 Touch User Guide - Magellan and Spectra SP Welcome to the heart of this website. The manual infos are updated KCA-R71FM Mode d`emploi - Leroy Merlin Embedded computer system for control and sensors Manual del Propietario DIG-220 Copyright © All rights reserved.
Failed to retrieve file