Datalogic PowerScan PM8300
Contents
1. Power Number Voltage Current Output 721091900 24 VDC 2 7A 70 W 721092000 36 VDC 2 2A 70 W 721092100 48 VDC 16A 70 W Power Cable e 10 ft 3 05 m L unterminated 18 2 Conductor cable e Red wire positive lead e Black wire negative lead Patents This product is covered by the following patent 5 508 505 Do not put your fingers or hands inside the unit while it is on Surfaces inside the unit are hot and may cause burns Do not use the Heated Holder as a handle it is not intended to support human weight 1 Ifthe Heated Holder is connected to the ignition switch turning the ignition switch on or off will control the heated holder An LED illumi nated from the inside of the holder indicates the power is on 2 Place the scanner into the holder see Figure 2 Push the scanner through the front brushes as far as it will go The brushes should return to their original position 820045314 Rev B December 2011 Page 2 of 22. au D AT ALO G IC PowerScan Heated Holder ww TM Installation Assembly and Operation Installation A Ensure installation is performed by qualified service personnel CAUTION 1 Attach the bracket to your forklift using 4 inch diameter screws and lock washers not provided A Exercise extreme caution when you are working with the forklift battery If handled improperly the current from the DC battery can cause injury or death DANGER 2 Connect the Heated Holder power cable to your forklift battery as follows Strip the holder BLACK negative wire and connect it to the negative battery terminal or to the chassis of the lift Use a proper fastener to ensure good electrical contact such as a wire terminal not provided Strip the holder RED positive wire and connect it to the ignition switch of the forklift Use a proper fastener to ensure good electrical con tact such as a wire terminal not provided If this connection is made directly to the battery s positive terminal provide an inline switch so it can be turned off when not in use If you use an inline switch make sure that its current and voltage ratings are sufficient See the Specifica tions on the following page for the three models Refer to your forklift owner s manual or contact your supplier or electrician for additional information or instructions e The Heated Holder is reverse polarity protected and will not function if connected backwards e Secure a
3. ny excess cable slack to the forklift at one foot intervals AN The Heated Holder is intended for direct current DC connection only Do not connect to a line or AC voltage source CAUTION Assembly 1 Assemble the bracket to the Heated Holder housing with the four mounting screws see Figure 1 Depending on installation requirements you can mount the bracket as shown vertically above the Heated Holder or on the opposite side 2 Ensure that the Heated Holder is mounted with the front brushes towards the operator and bottom brushes downward Front Brushes Holder Housing Forklift Alternate Bracket Positions 4 places Power Cable amp Strain Relief Figure 1 Heated Holder Mounting Diagram Datalogic Scanning Inc e 959 Terry Street Eugene OR 97402 e 541 683 5700 Page 1 of 2 Front Brushes Scanner Figure 2 Inserting the scanner in the Heated Holder Operation A WARNING Specifications Physical e Dimensions 7 7 in 19 6 cm L e 4 8 in 12 2 cm W amp 3 9 in 9 9 cm H Environmental Temperature e Internal operating Operating Solid State Control at 95 105 F 35 40 C e Ambient operating 22 to 104 F 30 to 40 C e Storage 40 to 158 F 40 to 70 C Humidity Ambient 5 to 95 non conducting Vibration MIL STD 810E Method 514 4 Procedure 1 Approvals CE TUV Electrical Model Input Input
Download Pdf Manuals
Related Search