Chief VCM Interface Bracket
Contents
1. Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document o i Chief Manufacturing a division of Milestone AV Technologies 8803 000120 O CH E 8401 Eagle Creek Parkway Savage MN 55378 2008 Milestone AV Technologies a Ta e P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 9 30 08 Our Mounts Your Vision INSTALLATION INSTRUCTIONS Continued A CAUTION Installing a ceiling mount requires the presence of two persons familiar with mechanical installations A third assistant is recommended VCM Housing Seat VCM in HB bracket slots Figure 2 3 Attach VCM housing to your method of support and tighten firmly so the VCM housing is square to the screen 4 With help of assistants lift the projector and install it to the four studs extending from the VCM housing Ensure that the VCM housing is seated in slots on HB bracket See Fi2. INSTALLATION INSTRUCTIONS MODEL HB 29S Custom Projector Bracket Unpack carton and verify contents If any listed parts are missing immediately contact a Chief Customer Service representative by calling 1 800 582 6480 PARTS 1 BRACKET Custom HB 4 NUT Flange Hex 5 16 18 4 SCREW Phillips Machine M6 1 00 x 4 FLAT WASHER Standard Machine 16mm Screw 6mm Toward front of projector Figure 1 INSTALLATION WARNING IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL INJURY All components must be securely fastened to each other and to the ceiling and the ceiling must be capable of supporting five times the total weight of the installation A CAUTION This HB bracket mount is designed to support the weight of only one projector per mount DO NOT attempt to attach more than one projector to the same mount h Place custom HB bracket on underside of the projector and line up the four screw holes on the bracket with the four corresponding holes on the projector Ensure that the side hooks open towards back of the projector See Figure 1 2 Attach HB bracket to projector using four M6 1 00 x 16mm Phillips machine screws through washers and spacers into projector Install each screw partially to make sure all screws are aligned correctly before tightening the screws to the bracket See Figure 1 Continued Milestone AV Technologies and its affiliated corporations and subsidiaries collectively
3. gure 2 5 Tighten the four 5 16 flange nuts See Figure 2 Chief is a registered trademark of Milestone AV Technologies All rights reserved a CHIEF Our Mounts Your Vision
Download Pdf Manuals
Related Search