Dual CP1222 car media receiver
Contents
1. mode will be shown by default Press DISP to display the clock then release Press and hold DISP for 2 seconds the clock will begin to flash Press TRACK lt d lt d to adjust the hours and TRACK BP to adjust the minutes Clock settings will be saved after 5 seconds The clock will display 12 hour AM PM time in USA frequency spacing mode PM 10 00 In European frequency spacing mode the clock will display 24 hour time 22 00 Press and hold for more than 2 seconds to RESET the unit upon initial installation The RESET button is located behind the faceplate XD1222 OPERATION General Operation USB Charging Port Select Audio Bass Treble Balance Fader Preset EQ Curves Insert the USB connector of a battery powered USB device into the USB charging port on the front panel which provides 5 volts DC and 1 0 amps The USB device will immediately begin charging Note The USB charging port may not be compatible with every device due to differences in power requirements Note This USB port provides power only and will not playback music from a USB device Press AUDIO to select between Volume default Bass Treble Balance amp Fader fo BASS gt TREBLE gt BALANCE gt cam Press AUDIO until BA appears Rotate the rotary encoder left right to adjust 6 minimum 6 maximum Press AUDIO until TR appears Rotate the rotary encoder left right to adjust 6 minimum 6 maximum Press AUDI2. to continuously repeat selected track Press RPT to cancel Press RDM to play all tracks in random order Press RDM again to cancel Some CD Rs and CD RWs may be incompatible with this unit depending on media type and recording method Note CD R recording sessions must be closed finalized for playback XD1222 OPERATION Troubleshooting Problem Unit will not turn on no power Cause Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Action Check connections for proper voltage 11 16VDC Unit has power but no sound Black wire not connected Fuse blown Speaker wires not connected Check connection to ground Replace fuse Check connections at speakers One or more speaker wires touching each other or touching chassis ground Insulate all bare speaker wires from each other and chassis ground Unit blows fuses Yellow or red wire touching chassis ground Check for pinched wire Speaker wires touching chassis ground Check for pinched wire Incorrect fuse rating Use fuse with correct rating Excessive skipping Unit is not mounted correctly or backstrap is not secure Check mounting sleeve and backstrap support Physical defect in media CD CD R or CD RW Check media for scratches Unit will not accept CD mechanism position out of alignment Press EJECT for 3 seconds to reset a disc C
3. D mechanism position CD transit screws still in place Remove 2 transit screws located on top of the unit Error Codes Error Code Cause Action ER 1 appears on display Disc error Press eject or RESET ER 2 appears on display Mechanism error Press eject or RESET ER 3 appears on display Servo error or disc is in upside down Press eject or RESET XD1222 WARRANTY Limited One Year Warranty This warranty gives you specific legal rights You may also have other rights which vary from state to state Dual Electronics Corp warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase Dual Electronics Corp agrees at our option during the warranty period to repair any defect in material or workmanship or to furnish an equal new renewed or comparable product whichever is deemed necessary in exchange without charges subject to verification of the defect or malfunction and proof of the date of purchase Subsequent replacement products are warranted for the balance of the original warranty period Who is covered This warranty is extended to the original retail purchaser for products purchased and used in the U S A What is covered This warranty covers all defects in material and workmanship in this product The following are not covered installation removal costs damage resulting from accident misuse abuse neglect
4. O until B appears Rotate the rotary encoder left right to adjust BL 15 BR 15 B 00 represents equal balance Press AUDIO until F appears Rotate the rotary encoder left right to adjust FF 15 FR 15 F 00 represents equal balance Press EQ to select between CLS POP ROC and OFF default equalization curves Any adjustment to the Bass or Treble settings automatically cancels the current EQ curve Seek Tuning Manual Tuning FM Stereo Mono Band Frequency Spacing Storing and Recalling Station Presets Automatically Store Stations Preset Scan XD1222 OPERATION Tuner Operation Press TUNE lt 4 lt 4 or TUNE BB momentarily to seek the next strong station Press TUNE lt 4 lt 4 or TUNE Bb for more than 2 seconds then release MANU will momentarily appear in the display Press TUNE lt a or TUNE B momentarily to move radio frequency up or down one step at a time Press and hold to advance quickly If tuning is not adjusted for 5 seconds the unit will return to seek tuning mode default AUTO will momentarily appear in the display Press ST MO for more than 2 seconds during FM tuner operation to select mono or stereo default reception of the broadcast signal Press BAND to select between FM1 FM2 FM3 and AM1 AM2 bands Press and hold BAND then press TUNE lt 4 lt 4 to select European frequency spacing Press and hold BAND then press TUNE gt to select USA frequency spacing default Anyti
5. he company any other liability in connection with the sale of this product In no event shall the company be liable for indirect incidental or consequential damages Specifications CD Player Frequency response 20Hz 20kHz Channel separation 1kHz gt 65dB D A converter 1 Bit FM Tuner Tuning range 87 5MHz 107 9MHz Usable sensitivity 12dBf 50dB quieting sensitivity 16dBf Stereo separation 1kHz 40dB Frequency response 30Hz 13kHz AM Tuner Tuning range 530kHz 1710kHz Usable sensitivity 30uV Frequency response 80Hz 2kHz General Operating voltage 11 16 VDC negative ground Speaker output impedance 4 8 ohms Fuse 5 amp AGC Dimensions 7 x 7 x 2 178 x 178 x 51 mm Design and specifications subject to change without notice CEA 2006 Power Standard Specifications reference 14 4VDC 0 2V 20Hz 20kHz Power Output 5 Watts RMS x 4 channels at 4 ohms and lt 1 THD N Signal to noise ratio 75dBA reference 1 watt into 4 ohms Dual Electronics Corp Toll Free 1 866 382 5476 www dualav com 2008 Dual Electronics Corp All rights reserved NSA0608 V01
6. he detachable face for security assurance this head unit has you covered 0009000000 Tune Track Down Eject Tune Track Up EQ Stereo Mono Auxiliary Input Audio Loudness USB Charge AS PS Band Display Faceplate Removal Semi permanent Faceplate Installation Power On Off Mode Loud Auxiliary Input Volume Display Set the Clock 12 24 hour Clock Reset XD1222 OPERATION General Operation Press RELEASE and pull away from the left side to remove To re install insert right side of faceplate first then push left side to secure Remove trim ring and install supplied 1 x 7 32 Phillips head screw through left side of mounting frame into faceplate Press PWR to turn the unit on Inserting a CD will turn the unit on automatically Press PWR to turn the unit off Press MODE to select between AM FM CD or auxiliary input Modes of operation are indicated in the display Press and hold LOUD for 2 seconds to activate and deactivate the loud feature Activating this feature will enhance the bass and treble frequencies when listening to music at low volumes Insert a 3 5mm connector in the front panel AUX port Connect the other end of the 3 5mm connector to the headphone output of an audio device MP3 player etc Press MODE to select AUX mode Adjust volume using the rotary encoder 00 46 Press DISP to display the clock The radio frequency tuner mode and CD track elapsed time CD player
7. ifier or power antenna Insulate wire if not used BLACK Ground Connect to vehicle chassis ground RED Accessory lt a 0 Connect to ignition circuit or switched 12 volt source 5 AMP AGC Fuse Oo i EE YELLOW Memory Connect to battery Right Front Gray Black Gray 2 Left Front White Black White sold separately circuit or constant 12 volt source Right Rear Violet Black Violet Left Rear Green Black Green i RCA Cable IE FUSE When replacing the fuse make sure new fuse is the correct type and amperage Using an incorrect fuse could damage the radio The XD1222 uses one 5 amp AGC fuse located in line Caution Do not attach any speaker leads to ground as severe damage will occur XD1222 OPERATION Control Locations no1zz22 Release Mode Power Rotary Encoder Preset 4 Play Pause Preset 1 Repeat Preset 5 Preset 2 Random Preset 3 Intro Preset 6 Q O The XD1222 has an easy to use interface that provides a rewarding experience as well as support for your favorite tunes Audio CD R and CD RW disc playback ensures compatibility with your music collection and the RCA preamp output provides the right connections to expand your system From its front panel auxiliary input for connecting your MP3 player to t
8. me frequency spacing is changed all station presets are erased Up to 18 FM stations and 12 AM stations can be stored To store a station select the desired band and station Press and hold the desired preset button for more than 2 seconds When stored the preset number will appear in the display The station can be recalled anytime by pressing the corresponding preset button Press AS PS for more than 2 seconds to automatically store the six strongest stations in the current band Press AS PS momentarily to scan presets 1 6 on the current band pausing for 5 seconds at each Press AS PS again to cancel XD1222 OPERATION CD Player Operation Insert CD Eject CD Track Select Fast Forward and Reverse Pause Intro Repeat Random CD R CD RW Compatibility With the label facing up insert a standard size CD into the CD slot The CD will automatically begin playback Press the EJECT button to stop and eject the CD The unit will change to tuner mode Press TRACK to skip to the beginning of the next track Press TRACK lt 4 lt d to return to the beginning of the current track Pressing TRACK lt lt again skips to the beginning of the previous track Press and hold TRACK Bb or TRACK lt d lt d to fast forward or reverse a track Press I to temporarily stop CD playback Press I again to resume playback Press INT to play the first 10 seconds of each track Press INT to cancel Press RPT
9. product modification improper installation incorrect line voltage unauthorized repair or failure to follow instructions supplied with the product or damage occurring during return shipment of the product 10 What to do 1 Before you call for service check the troubleshooting guide in your owner s manual A slight adjustment of any custom controls may save you a service call 2 If you require service during the warranty period you must carefully pack the product preferably in the original package and ship it by prepaid transportation with a copy of the original receipt from the retailer to an authorized service center 3 Please describe your problem in writing and include your name a return UPS shipping address P O Box not acceptable and a daytime phone number with your shipment 4 For more information and for the location of the nearest authorized service center please contact us by one of the following methods e Call us toll free at 1 866 382 5476 e E mail us at cs dualav com Exclusion of Certain Damages This warranty is exclusive and in lieu of any and all other warranties expressed or implied including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation liability right claim or remedy in contract or tort whether or not arising from the company s negligence actual or imputed No person or representative is authorized to assume for t
10. xoizzz XD1222 INSTALLATION OWNER S MANUAL AM FM CD Receiver with Auxiliary Input USB Charging Port and Detachable Face COMPACT DIGITAL AUDIO Charge Port XD1222 INSTALLATION Preparation Please read entire manual before installation Before You Start e Disconnect negative battery terminal Consult a qualified technician for instructions e Avoid installing the unit where it would be subject to high temperatures such as from direct sunlight or where it would be subject to dust dirt or excessive vibration Getting Started e Remove 2 transit screws located on top of the unit e Insert the supplied keys into the slots as shown and slide the unit out of the mounting sleeve e Install mounting sleeve into opening bending tabs to secure e Connect wiring harness and antenna Consult a qualified technician if you are unsure e Certain vehicles may require an installation kit and or wiring harness adapter sold separately e Test for correct operation and slide into mounting sleeve to secure e Snap trim ring into place HEX BOLT aN aa BOO SY EA 2 x x z a amp jen 7 m 5 MOUNTING SLEEVE TYPICAL MOUNTING METHOD XD1222 INSTALLATION Wiring Diagram Rear Preamp Output Connect to amplifier RCA input e q J E fo Antenna Connector BLUE Remote Turn On Connect to ampl
Download Pdf Manuals
Related Search