SCOTT i-PX 12 Helin
Contents
1. Remote control ON STANDBY gt Il PLAY PAUSE CLK SET Clock set MENU access iPod iPhone menu DISPLAY SHUFFLE AL SET Alarm set SNOOZE SLEEP ALBUM A V CHAPTER REPEAT AL MODE MENU A 44 Skip Fast REW FWD TIME SELECT PLAYLIST VOLUME POWER SUPPLY AC power supply Plug the AC mains adapter into a 100 240V AC 50 60Hz mains outlet and the other end of the cord into the DC 5V jack at the side of the unit Battery power supply Inserting the batteries Open the battery compartment on the bottom of the unit by pressing on the catch and removing the cover Insert 4 x AA LRO6 batteries alkaline batteries are recommended into the battery compartment following the polarity as shown on the diagram inside the compartment Replace the battery compartment cover Note It is not possible to recharge the iPod if the unit is being powered by batteries Installing the remote control battery 1 Remove the battery compartment cover lt CR2025 on the bottom of the remote control by E N pushing the tab to the right while c H removing the cover aiii Insert a 3V lithium battery CR2025 or equivalent following the polarity as shown on the diagram inside the compartment Replace the battery compartment cover GB 3 Note The remote control battery normally lasts for about one year although it depends o2. SCOTT i PX12 PORTABLE SPEAKERS for iPod and iPhone Instruction Manual CE PRECAUTIONS Follow the instructions below to ensure the product is used safely and correctly LOCATION e Do not use the unit in places which are extremely hot cold dusty or humid e Place the unit on a flat level surface e Do not restrict the airflow around the unit by placing it in a place with poor ventilation covering it with a cloth or placing it on a carpet Do not place the unit close to heat sources e Use the unit only in moderate climates not in tropical climates Do not expose the unit to rain or splash with water e Do not place objects filled with liquids such as vases on the unit SAFETY e When connecting and disconnecting the AC power adapter take hold of the plug and not the cord Pulling the cord may damage it and may be dangerous e The plug must be easily accessible e When you are not going to use the unit for a long period of time disconnect the adapter from the AC mains outlet AC VOLTAGE e Before use check that the rated voltage of your unit matches your local voltage CONDENSATION e The unit may not work properly if it has condensation inside Unplug the unit for 1 to 2 hours before turning the power back on or gradually heat the room up and dry the unit before use e Ensure a space of at least 5 cm around the app
3. 3 No Video output 3 1 Check the cable connections 3 2 Your iPod iPhone TV output must be On TECHNICAL SPECIFICATIONS R M S output power 4W 2x2 W Power consumption 12 W Speakers 2x2 1 4 4 Ohms AC adapter Input AC 100 240V 50 60Hz Output DC 5V Batteries DC 6V 4 x 1 5V 4 x AA LROG batteries Dimensions 38 H x 260 W x 174 D mm Weight 0 55 Kg Note Due to continuing improvements the technical specifications are subject to change without notice
4. NU button to access the iPod iPhone menu Use the A V and SELECT buttons on the remote control to navigate through the menu Use the SELECT button to confirm your selections 8 Alternatively you can use the controls on your iPod iPhone Note When a phone call comes in on your iPhone the music stops playing automatically so that you can hear your phone ringing The iPod iPhone s internal battery charges until it is fully charged Adjust the volume using the volume control button on the unit To prevent sound distortion during playback on this unit the EQ function in your iPod iPhone must be set to Off The unit is not designed for playing or charging an iPodshuffle but it is possible to connect the iPod s line out or headphones jack to the LINE IN jack on the unit Watching a video on your iPod iPhone If there are videos on your iPod iPhone you can watch them on an external device aTV for example via the 3 5 mm AV OUT jack at the side of the unit using an RCA cable not supplied Operations are the same as for Listening to your iPod iPhone Note Make sure the AV cable not supplied is compatible for your iPod iPhone LINE IN FUNCTION This unit has an LINE IN jack which allows you to connect it to an external audio device such as an MP3 player or earlier iPod model 1 Connect a 3 5mm stereo connection cable not supplied to the LINE IN jack on the side of the unit and the line out headphones jack on your exter
5. aratus to enable sufficient ventilation e Do not cover the ventilation openings BATTERIES e Pay attention to the environmental aspects of battery disposal CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with ATTENTION To reduce the risk of The exclamation mark an arrowhead symbol Jelectric shock do not remove the within the triangle is a within a triangle is a cover there are no user serviceable warning sign alerting the warning sign alerting the parts inside the unit Refer all user to the presence of user to the presence of servicing to qualified personnel important instructions dangerous voltage accompanying the inside the unit product TABLE OF CONTENTS PRECAUTIONS TABLE OF CONTENTS BOX CONTENTS BOX CONTENTS 1 Unit 4 Instruction manual 2 Remote control with battery 5 Pouch 3 AC adapter Unit 1 CLK SET Clock set button 2 Docking station for iPod iPhone 3 AL SET Alarm set button 4 SNOOZE button 5 6 7 8 VOLUME button Infrared remote control sensor Speakers 2x Battery compartment DC 5V jack AV OUT jack LINE IN jack ON STANDBY Play Pause button LCD display DISPLAY button SLEEP button ALARM MODE button ARTICULATED SPEAKER COMPARTMENT
6. immediately VOLUME control Use the buttons on the unit or the VOLUME buttons on the remote control to adjust the volume level Alarm Time display Press the DISPLAY button to display the alarm time for a few seconds Press it again to return to the clock display PLAYING AN iPod iPhone AND CHARGING THE INTERNAL iPod iPhone BATTERY Installing an adapter on the iPod iPhone docking station 1 Select the iPod adapter that corresponds to your iPod iPhone 2 Place the adapter on the docking station on the top of the unit with the two tabs facing forwards LO 3 To remove the adapter press the back of the adapter _ ae and pull it up Note Make sure that the iPod iPhone adapter is correctly installed on the docking station Listening to your iPod iPhone With the correct iPod iPhone adapter installed gently dock the iPod iPhone without the protective cover into the unit s docking station You can adjust the position of the speakers so that they are facing you Then press the Pll button to start playback Press it again to pause playback Press it again to resume normal playback Press the ma4 buttons repeatedly to skip to the previous or next track Press and hold down the t lt gt 1 buttons to move fast forward or back Use the CHAPTER ALBUM and PLAYLIST buttons on the remote control to navigate through the chapters albums or playlists if available on a docked iPod iPhone Press the ME
7. n how often the remote control is used If the remote control is not working properly replace the battery Precautions when using batteries 1 CAUTION Danger of explosion if battery is incorrectly inserted Replace only with the same or equivalent type 2 Do not mix different types of batteries together e g alkaline rechargeable and carbon zinc or old batteries and fresh ones 3 Exhausted batteries must be removed to prevent possible leakage 4 Dispose of batteries properly in accordance with the environmental regulations in force BASIC OPERATION ON Standby When it is connected to a power supply refer to POWER SUPPLY the unit goes to standby mode and the time is displayed Press the button to turn the unit onand press and hold the button to go back to standby mode Setting the clock 1 In standby mode press and hold down the CLK SET button 2 Press the or TIME lt gt on the remote control buttons to set the hours and press the CLK SET button to confirm 3 Follow step 2 above to set the minutes Using the alarm The unit allows you to wake up to the sound of the buzzer or to music iPod iPhone Setting the alarm time Follow above steps 1 to 3 using the AL SET button instead of CLK SET button Setting the alarm mode After setting the alarm time press the AL MODE button to select a source music 3 Buzzer amp or off Enabling Disabling the alarm function P
8. nal audio device 2 Operate your external audio device as usual to select and play music 3 Adjust the volume controls on both your external audio device and this unit to the desired volume level Note In LINE IN mode this unit cannot display any music information e g track number for your external audio device MAINTENANCE Care and maintenance To clean the casing unplug the unit and wipe off dust and stains with a soft damp cloth Never use benzene thinner or similar chemicals to clean the casing If at any time in the future you want to dispose of this product please note that et electrical products should not be disposed of with household waste Find out where your nearest recycling centre is Consult your local authority or retailer for EE more details Waste Electrical and Electronic Equipment Directive GB 6 TROUBLESHOOTING GUIDE Problems Recommendations 1 The player or display 4 1 Press the C button to go to standby mode and press it is not working again to turn the unit back on again properly 1 2 Reset by unplugging the AC power cord for few seconds then plug it back in 2 No sound poor 2 1 Make sure you are using the right iPod iPhone sound in adapter iPod iPhone mode 2 2 The EQ function in your iPod iPhone must be set to Off 2 3 Your iPod iPhone model is not supported by the unit Connect your iPod iPhone to the docking station via the LINE IN jack 2 4 Check the cable connections
9. ress the AL MODE button repeatedly to enable the alarm function and select an alarm mode or disable the alarm function When the alarm function is on the buzzer or music will come on at the set time To stop the alarm press and hold the button The alarm will sound again at the same time the next day To disable the alarm function press the AL MODE button repeatedly until the alarm mode icon disappears Note e To enable you to wake up gently to the mustic the volume is set to 1 when the alarm goes off and gradually increases up to 23 e If music mode is selected make sure the iPod iPhone is inserted in the docking station Snooze function When the alarm sounds press the SNOOZE button to stop the alarm temporarily and it will sound again after 6 minutes To cancel the SNOOZE function press and hold the X button The alarm will stop and come on again the next day Sleep function This function allows you to program the unit so that the music turns off automati cally after a certain time up to 120 minutes When the unit is switched on press the SLEEP button repeatedly to select a duration between 120 90 60 30 10 and 5 minutes before the unit switches off automatically amp is displayed when this function is activated At the end of the set time the unit turns off automatically To cancel the sleep function before the end of the preset time press and hold the X button to turn off the unit
Download Pdf Manuals
Related Search