SCOTT i-SX60
Contents
1. 4 RADIO OPERATION esses ede 4 5 PLAYING AN iPod AND CHARGING THE INTERNAL iPod BATTERY 6 AUX IN 7 7 TROUBLESHOOTING GUIDE 8 TECHNICAL SPECIFICATIONS 9 BOX CONTENTS 1 Unit 4 Instruction manual 2 Remote control with battery 5 AC power cord 3 Adapters for different iPod models 7x LOCATION CONTROLS Unit 1 ON STANDBY button 70100 200 we 2 LCD display 3 DBBS Dynamic Base Boost System button 2 4 CLOCK SET button 5 Handle 6 PROG button programming 7 lt gt SKIP REW FWD buttons O 11 8 9 0 AM FM CD iPod AUX switch VOLUME buttons TUNING dial 21 20 19 48 A 11 Speakers 2x z N 12 CD compartment OPEN button 13 CD compartment 14 AC IN socket 15 Battery compartment 16 gt PLAY PAUSE button 17 STOP button 18 Infrared remote sensor 19 REPEAT button 20 Docking station for iPod 21 iPod compartment 24 Headphones jack 49 22 VIDEO OUT jack 25 Cover for connection jacks 23 AUX IN jack 26 FM antenna GB 2 Remote control 1 ON STANDBY 2 STOP 3 MENU PROG menu display programming 4 DBBS Dynamic Bass Boost System 5 REPEAT 6 MENU2. 7 REW FWD 8 SELECT 9 PLAYLIST A V 10 SHUFFLE 11 gt PLAY PAUSE 12 VOLUME 13 ALBUM A V POWER SUPPLY Using AC power supply Insert the AC power cord into the AC mains outlet with a 230V AC 50Hz power source and the other end to the AC IN socket at the back of the unit Using batteries 1 Open the battery compartment 2 Insert 8 x UM2 size batteries not supplied with the polarities matching the engraved markings in the battery compartment Reversed batteries may damage the unit 3 Close the battery compartment Note When AC power is supplied the battery power is cut off automatically When a power failure or interruption occurs and the unit does not have batteries installed the time and preset memories will be backed up for about a minute Installing the remote control Remove the battery compartment cover on the bottom of the remote control by pushing the tab to the right while removing the cover 2 Insert a 3V lithium battery CR2025 or equivalent with the polarity matching the indication inside the battery compartment cover 3 Replace the battery compartment cover Note The remote control battery normally lasts for about one year although it depends on how often and for what operations the remote control is used If the remote control fails to work even when it is operated near the unit replace the battery CR2025 x M s OP
3. SCOTT i SX60 CD BOOMBOX WITH iPod DOCKING STATION 0202 00 0 Instruction Manual PRECAUTIONS Follow the advice below for safe and appropriate operations PLACEMENT Do not use the unit in which are extremely hot cold dusty or humid Place the unit on a flat and even surface Do not restrict the airflow of the unit by placing it in a place with poor airflow by covering it with a cloth or by placing it on a carpet Do not place naked flame such as lighted candles on the apparatus Use the apparatus only in moderate climates not in tropical climates Do not expose the apparatus to dripping or splashing Do not place objects filled with liquids such as vases on the apparatus SAFETY When connecting and disconnecting the AC power cord from the AC mains outlet pull the plug and not the cord itself Pulling the cord may damage it and may be dangerous The mains plug must remain readily operable When you are not going to use the unit for a long period of time disconnect the AC power cord from the AC mains outlet AC VOLTAGE Before use check that the rated voltage of your unit matches your local voltage CONDENSATION When there is condensation inside the unit it may not function normally Let the unit stand for 1 to 2 hours before turn
4. CD R RW Radio Tuning range 87 3 108 MHz 522 1620 kHz FM telescopic antenna built in ferrite bar General Output power 6 W total 2 x 3 AC power 5 6 W 2 x 2 8 W battery power source Power consumption 28 W Speakers 2 x 3 4 Ohms Power source AC 230V 50Hz DC 12V 8 x 1 5V 8 x 2 size batteries Dimensions 211 H x 360 W x 135 D mm Weight 2Kg Note Due to continuing improvements the technical specifications are subject to change without notice Where to place the item Today s furniture is coated with a wide variety of lacquers and synthetic coatings that are treated with an extensive range of cleaning products Therefore the possibility that some of these substances contain components that react adversely to the rubber feet of the item and soften them cannot be completely excluded The rubber feet of the appliance can cause discoloring to furniture surfaces If necessary place the appliance on a non slide surface 9
5. EN A A RELEASE GB 3 Precautions when using batteries 1 CAUTION Danger of explosion if battery is incorrectly replaced Replace only with the same or equivalent type 2 Do not mix different types of batteries together e g alkaline rechargeable and standard carbon zinc or old batteries with fresh ones 3 Exhausted batteries must be removed to prevent any battery leakage 4 Dispose of batteries properly according to environmental regulations BASIC OPERATION ON Standby mode After connecting the power supply refer to POWER SUPPLY the unit goes to standby mode and the clock time is displayed Press the ON STANDBY button to turn on the unit and press it again to go to standby mode Setting the clock In standby mode hold down the CLOCK SET button on the unit and use the ma button to set the hours and the button to set the minutes Selecting a source When the unit is switched on slide the AM FM CD iPod AUX switch to select one of the following sources CD or iPod AUX VOLUME control Press the VOLUME button to adjust the volume level DBBS Dynamic Bass Boost System function Press the DBBS button to boost the bass effect Connect the headphones Open the connection jacks cover at the back of the unit and plug your headphones not supplied into the headphones jack for private listening The speaker output will be shut off autom
6. atically RADIO OPERATION Listening to the radio 1 When the unit is switched on slide the AM FM CD iPod AUX switch to select AM or FM mode 2 Turn the TUNING dial to receive a radio station The LCD display shows the selected frequency Achieve optimum reception In FM mode extend and position the FM antenna to achieve optimum reception In AM mode orientate the main unit to achieve optimum reception GB 4 CD OPERATION Start playback 1 When the unit is switched on slide the AM FM CD iPod AUX switch to select CD mode 2 Press the OPEN button to open the CD compartment and insert a CD or CD R RW disc into the CD compartment with the label side facing outwards 3 The unit will read the disc and after reading the total number of tracks will be displayed Press the llbutton to start playback from the first track During playback the track number is displayed Pause playback Press the Pll button to pause playback and gt will flash Press it again to resume playback Stop playback Press the W button to stop playback Then you can press the to start playback from the first track Search function Skip to next previous track 1 Press the gt gt I button to skip to the next track 2 Press the 4 button to skip to the previous track Searching within a track During playback hold down the gt gt button to go fast backwards or forwards and then release the button It wil
7. ilities exist Check with your local authority or If at any time in the future you should need to dispose of this product please mm retailer recycling advice Waste Electrical and Electronic Equipment Directive TROUBLESHOOTING GUIDE Problems Recommendations 1 The player display 1 1 Press the ON STANDBY button to go to standby mode does not work and press it again to turn on the unit properly 1 2 Reset by unplugging the AC power cord for few seconds then plug it back in 2 No sound poor 2 1 Check the cable connection sound 2 2 Use the FUNCTION or iPod button to select the correct mode 3 The disc does not 3 1 Place the disc with the label side facing outwards play 3 2 Ensure that the disc is free from scratches and fingerprints 3 3 Only CD and CD R RW discs can be played 3 4 Clean the disc 4 Noise or distorted 4 1 FM mode Extend and position the FM antenna to sound in radio mode achieve the best reception 4 2 AM mode Orientate the unit to achieve optimum reception 5 No sound poor 5 1 Check that you have chosen the correct adapter sound in iPod mode 5 2 The EQ function in your iPod must be set to Off 5 3 Your iPod is not supported by the unit Connect your iPod to the docking station via the AUX IN jack 6 No picture in video 6 1 Set the TV out setting on your iPod to ON out mode GB 8 TECHNICAL SPECIFICATIONS CD compatible discs CD
8. ing the power on or gradually heat the room up and dry the unit before use Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation Ensure that the ventilation is not impeded by covering the ventilation openings with such as newspapers tablecloths curtains etc BATTERIES Pay attention to the environmental aspects of battery disposal CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with ATTENTION To reduce the risk of The exclamation mark arrowhead symbol Jelectric shock do not remove the cover within the triangle is a within the triangle is no user serviceable parts warning sign alerting the warning sign alerting the inside the unit Refer all servicing user to the presence of user to the presence of qualified personnel important instructions dangerous voltage accompanying the inside the unit product In case of malfunction due to electrostatic discharge the apparatus has to be reset by disconnecting it from mains supply THE MARKING PLATE IS LOCATED AT THE BACK OF ENCLOSURE OF THE APPARATUS GB 1 TABLE OF CONTENTS PRECAUTIONS aas 1 TABLE OF 2 BOX CONTENT S ed 2 LOCATION 8 000000 6 2 POWER SUPPLY 5 3 BASIC OPERATION reiniciei
9. l resume normal playback from that point REPEAT playback Press the REPEAT button repeatedly to select repeat playback mode Press it once to repeat the current track and is displayed Press it twice to repeat all the tracks and REP ALL is displayed Press it a third time to cancel the repeat function PROGRAM playback This function allows you to program up to 20 tracks to be played in the desired order Note Programming only works when playback is stopped Programming CD tracks 1 In STOP mode press the PROG button and the track number PROG 01 will flash 2 Press the 4 gt gt buttons to select a track number 3 Press the PROG button to confirm 4 Repeat steps 2 and 3 to program the other tracks 5 To play the program press the Pll button 6 To clear the program press the button twice open the CD compartment or go to standby mode GB 5 PLAYING AN iPod AND CHARGING THE INTERNAL iPod BATTERY Installing an adapter on the iPod docking station 1 Select the iPod adapter that corresponds to your iPod model from the table below 2 Open the iPod compartment 3 Place the adapter on the docking station in the iPod compartment with the two tabs facing forwards 4 To remove the adapter press the back of the adapter and pull it up Adapter No iPod description Capacity 6 iPod 4 generation 20GB 20GB amp 30GB 7 iPod 4 generation with color dis
10. menu on a docked iPod and use the MENU and SELECT buttons on the remote control to navigate through the iPod s menu Use the SELECT button to confirm your selection Alternatively you can use the controls on your iPod GB 6 RANDOM playback for iPod only Press the SHUFFLE button on the remote control to play the tracks in random order Press the SHUFFLE button again to cancel the function Watch videos or pictures from your iPod If your iPod contains videos or pictures you can view them on an external video device e g TV 1 Open the connection jacks cover 2 Connect the VIDEO IN jack on the external video device to the unit s VIDEO OUT jack with a video cable not supplied to transmit the video signal from your iPod to the external device Next refer to Listening to your iPod The setting TV OUT on your iPod must be set to ON Note The iPod s internal battery charges until it is fully charged Adjust the volume control on the unit to the desired volume level To prevent sound distortion during iPod playback on this unit the EQ function in your iPod must be set to Off The unit is not designed for playing and charging an iPod shuffle but it is possible to connect the iPod s line out or headphones jack to the AUX IN jack on the unit AUX IN FUNCTION This unit has an AUX IN jack which allows you to connect it to an external audio device such as an MP3 player or earlier iPod m
11. odel 1 Open the connection jacks cover and connect a 3 5mm stereo connection cable not supplied to the AUX IN jack at the back of the unit and the out jack on your external audio device 2 When the unit is switched on slide the AM FM CD iPod AUX switch to iPod AUX mode 3 Operate your external audio device as usual to select and play music 4 Adjust the volume controls on both your external audio device and this unit to the desired volume level Note When an iPod is docked and the unit is in iPod mode plugging the connection cable into the AUX IN jack in iPod mode will shut off the sound output from the iPod The unit will automatically switch to AUX mode and the sound will be emitted from the external device connected to the AUX input In AUX mode this unit display cannot show any music information e g track number for your external audio device MAINTENANCE Care and maintenance To clean the casing unplug the unit and wipe off dust and stains with a soft cloth moistened with a mild soap and water solution only Do not use benzene thinner or similar chemicals to clean the casing 7 Cleaning CDs If the music skips or does not play the disc may need cleaning Before playback wipe the disc from the center out with a clean cloth After use store the disc in its case note that waste electrical products should not be disposed of with household waste Please recycle where fac
12. play iPod 4 generation iPod 4 generation with color display 40GB 40GB amp 60GB 8 iPod nano 15 generation iPod nano 274 generation 1GB 2GB amp 4GB 2GB 4GB amp 8GB 9 iPod 57 generation with video iPod classic 30GB 80GB 10 iPod 5 generation with video iPod classic 60GB amp 80GB 160GB 13 iPod nano 3 generation 4GB amp 8GB 14 iPod touch 8 amp 16GB Ensure that you use the adapter corresponding to your iPod in order to ensure that it is installed in a stable way and that the electrical contact is good Listening to your iPod Open the iPod compartment With the correct iPod adapter installed gently dock the iPod without the protective cover into the units docking station For first and second generation iPod nano models use the adjustment system so that the iPod can fit into the docking station When the unit is switched on slide the AM FM CD iPod AUX switch to iPod AUX mode Then press the gt button to start playback Press it again to pause playback Press it again to resume normal playback Press the buttons repeatedly to skip to the previous or next track Press and hold down the buttons to perform a fast search backwards or forwards Use the ALBUM and PLAYLIST buttons on the remote control to navigate through the albums or playlists on a docked iPod Press the MENU PROG button to access the
Download Pdf Manuals
Related Search