Bogen ASTB4 electrical box
Contents
1. Model ASTB4 L A A SERIES SPEAKER N E A R TERMINAL BOOT Description The A Series Terminal Boot is designed to offer added protection against the effects of weather on wires and connections made to NEAR A Series speaker model types A2 A6 and A8 The ASTB4 package contains 4 terminal boots Note The ASTB4 will not fit the NEAR A12 model Installation 1 If necessary trim the tapering boot sleeve to accommodate the size of the wire bundle to be attached to the speaker adjust for a snug fit 2 Slide the narrow end of the boot sleeve over the wires Crimp any lugs onto the wires after inserting the wires through the boot sleeve 3 Secure the wires to the terminals and then slide the terminal boot into place over the terminals pressing it firmly against the terminal strip for a secure fit The boot only fits properly in one orientation Note The A2 speaker model does not allow enough space between the housing and the bracket for the boot sleeve to pass between them Therefore it is important to install the boot while the speaker is in its approximate final tilt position SPEAKER TERMINAL STRIP INPUT WIRES TYPICAL Additional Protection BOOT The terminal boot does not provide a water tight seal for the terminal strip It is only designed to minimize the direct effects of weather on the wires and connections Silicone based caulks can be used to improve the seal of the boot to the speaker terminal area If2. desired apply a bead to the base of the boot before pressing it onto the terminal Silicone sealents with adhesive properties adhere better than pure silicone products The boot sleeve exit can also be sealed however be certain to caulk it so that the caulk can be removed later in case the boot needs to be removed BOGERI COMMUNICATIONS INC Specifications subject to change without notice 50 Spring Street Ramsey NJ 07446 U S A 2002 Bogen Communications Inc Tel 201 934 8500 Fax 201 934 9832 54 2085 01B 1104 www bogen com
Download Pdf Manuals
Related Search