Scosche HA1573B mounting kit
Contents
1. MOUNTING THE RADIO CAUTION REAR SUPPORTING THE RADIO ADDS TO THE INSTALLATIONS STRUCTURAL INTEGRITY 5324 REAR 5452 MOUNTING ORAE KIT PANEL RADIO S MOUNTING SLEEVE bet 5459 TRIM RING SCOSCHE HA1573 IN DASH INSTALLATION KIT FOR 2003 UP HONDA ACCORD LOWER DASH POCKET VEHICLES 5324 5452 MOUNTING KIT PANEL 5459 TRIM RING INTRODUCTION PRELIMINARY Thank you for purchasing the Scosche HA1573 Kit This kit was manufactured with the highest of quality standards CAUTION Disconnect your vehicle s negative battery terminal before the installation to help prevent electrical damage We recommend the use of a volt ohm meter over a test light to check wiring A test light or grounded wire probe can cause damage to the vehicle s computer and or diagnostic systems Avoid all factory air bag wiring air bags can accidentally deploy causing serious injury or death NOTES e See your vehicle s instructions for any special tools your installation might require Read all instructions accompanying your car stereo cassette player for proper wiring and mounting instructions FACTORY WIRING CODES For Factory Wiring Codes go to www scosche cars com LIABILITY DISCLAIMER This instruction booklet is based on carefully documented data and research of automobile dash disassembly wire harness codes and information pertaining to installation of this kit HA1573 in 2003 UP Honda Accord Ve2. hicles Scosche Industries Inc can not be held responsible for discrepancies inconsistencies that may occur due to the automobile manufacturing changes or options or damage that may occur in the automobile during the installation of components while using this booklet If you have any further questions call our toll free technical help line at 1 800 621 3695x3 2007 SCOSCHE INDUSTRIES INC SI 05 07 HA1573 3000467 KIT PREPARATION POCKET ASSEMBLY 1 Remove 2 white plastic retaining clips from top brackets on factory pocket panel A ATTACHING THE REAR BRACKET 2 Remove 2 screw brackets from bottom of factory pocket panel Align the two 2 screw emboss locations to the matching locations on pocket When aligned slide 3 Attach 2 white plastic retaining clips to the top brackets on the Scosche kit panel See Illustration A the bracket together Screw the two 2 supplied screws to screw emboss locations 4 Insert 2 screw brackets into openings in Scosche kit panel See Illustration B B ATTACHING THE POCKET Align the pocket to the snaps of kit panel Snap the pocket into place on the back of kit panel ILLUSTRATION A ILLUSTRATION B 5452 MOUNTING KIT PANEL 5324 REAR SUPPORT BRACKET STEREO INSTALLATION TO REMOVE POCKET BELOW FACTORY RADIO 1 Gently pry up to remove shift trim bezel 2 Open ashtray small storage pocket Remove pocket Extract two screws from pocket opening Unplug and remove assembly 3 Ex
3. tract two screws from lower part of large dash storage pocket With pocket door closed pull toward shifter to unsnap clips and remove 4 Extract two 8mm bolts from under radio assembly brackets CONTINUE TO REMOVE FACTORY RADIO 5 From above radio assembly gently pry out on vent hazard panel Continue along both sides of panel gently releasing clips Lift up unplug and remove 6 Extract three screws from top of radio assembly Pull toward shifter to unsnap clips Unplug and remove
Download Pdf Manuals
Related Search