Gastroback 98100
Contents
1. is coming out of the outlet operate according fo the instructions Clear a blocking The motor stops running while operating Turn the appliance Off immediately and operate according to the instructions Clear a blocking The attachment blocks up permanently e To ensure that the attachment does not seize never operate it while operating under excessive pressure Operate in a slow and constant pace Do not try to rush the procedure by pushing down the food e May be the dough is too dry Add some water to the dough but pay attention not adding too much water The attachment moves or loosened while The attachment is not correctly assembled or not securely locked to operating the attachment access Turn the appliance OU immediately Operate according to the instructions Assemble the Pasta Attachment The food leaks out at the side of the The ring nut is not screwed on tight enough Turn the appliance ring nut Off immediately and then pull the plug Tighten the ring nut but do not overwind the thread If the problem still occurs disassemble and clean the appliance Storage Always clean the appliance and attachment before storing see Care and Cleaning Ensure to store the appliance and attachment where it is clean dry and safe from frost direct sunlight and inadmissible strain mechanical or electric shock heat moisture and where it is out of reach of young children Place the appliance and attach2. loosen the ring nut picture B 4 Take the screen and the scroll out of the housing Care and Cleaning Clean the appliance directly after use and do not leave any food dry on the surfaces of the appliance WARNING To avoid injuries to persons and damage always switch Off the appliance wait for the motor fo stop completely and unplug the appliance immediately after operation and before disassembling or cleaning the appliance With the appliance connected to the power supply keep hands hair clothing as well as spatula and other utensils away from feed chute to prevent injury and or damage to the appliance DO NOT place the appliance accessories or power cord in an automatic dishwasher Do not immerse the motor housing or power cord in any liquids or spill any liquids on it Always wipe off spilled liquids immediately CAUTION Do not use abrasive cleaners cleaning pads corrosive chemicals disinfectants bleach or any sharp or hard objects i e metal scouring pads for cleaning for this could damage the surfaces Carefully clean the appliance with a damped sponge or cloth and warm soapy water 1 Switch OFF speed control into OfF position wait for the motor to stop completely and unplug the appliance from the power outlet 2 Disassemble the attachment regarding the instructions Disassemble the Pasta Attachment and remove food residues on the scroll and the feed chute Use the handle of the provided span
3. the first 15 cm of curled pasta may be gently pulled away from the screen and again passed through the attachment Increase to speed 3 5 When the pasta has reached the desired length gently pull away from screen Lay pasta down and separate immediately Place the pasta on a paper towel to dry if desired NOTE Do not pile extruded pasta up as this strands will stick together NOTE Whenever you wish to change screens the appliance must be turned Off and the ring nut must be unscrewed and removed The machine may be briefly switched on speed 1 to eject the screen to enable an alternative screen to be fitted act according to the instructions Assemble the Pasta Attachment The ring nut must be repositioned and tightened clockwise by hand 6 Switch OFF the appliance after use and disconnect the power supply cable from the mains socket 7 As soon as the last bit is processed turn the appliance OFF and pull the plug 8 Clean and disassemble the appliance right after use and make sure that no leftover food desiccate on the appliance Work according to the instructions Care and cleaning Dissemble the Pasta Attachment l Switch Off the appliance after use and disconnect the power supply cable from the mains socket 2 Press down the attachment ejector picture A and pull the Pasta Attachment out off the access opening 3 Take off the ring nut by turning it anticlockwise You can use the provided spanner to
4. GASTROBACK Instructions for use Pasta Attachment Accessory Design Stand Mixer Advanced Read all provided instructions before first usage Art Nr 98100 Model and attachments are subject to change Carefully read all provided instructions before you start running the appliance and pay regard to the warnings mentioned in these instructions Important Instructions e The appliance is designed for normal household quantities Do not operate or store the appliance outdoors or in damp or wet areas e Before use always make sure that the appliance and accessory is properly and completely assembled Always IMMEDIATELY unplug the appliance after each operation and before assembling or disassembling accessories Always ensure that the accessories are engaged firmly before connecting the appliance to the mains power supply see Operation Always handle the entire appliance and the tools with care and without violence e Do not grab into the assembled attachment with your hands or any other objects when the appliance is connected to the poweroutlet e CAUTION Do not block the ventilation slits on the back of the appliance and do not use the appliance in continuous operation for more than 10 minutes to avoid overheating If processing large quantities of food regularly interrupt operation and unplug the appliance for a few minutes to let the motor cool down e ATTENTION Avoid contact the moving parts Keep hands hair c
5. achment WARNING Always switch Off the appliance wait until the motor stops completely and unplug the appliance before assembling disassembling the attachment To turn the appliance OFF you have to turn the speed control anticlockwise into the Off position Assemble the Pasta Attachment I Take the housing into your left hand The part with the thread has to face the front and the feed chute has to face upwards 2 Take the scroll into your right hand and place it into the housing The axis has to face the housing when sliding the scroll into the housing picture A NOTE The scroll is correctly located when the scroll is pushed up all the way inside the housing and the end of the axis pokes out of the back end of the housing 3 Fit the desired pasta screen over the axis of the scroll inside the housing picture B Ensuring that the pasta screen is correctly located The side of the screen with the round hole in the middle must face the scroll the side with the number in the middle has to face the ring nut IMPORTANT The pasta screen has two gaps which have to fit into the corresponding lugs of the housing If necessary turn the screen a little bit to make it slide into the right position NOTE The screen will not flush with the rim of the housing when located in the right position 4 Take the ring nut and screw it onto the thread of the housing turning it clockwise picture C You can use the spanner to se
6. as well as spatula and other utensils away from feed chute during operation to prevent injury and or damage to the appliance 4 Switch on the appliance using speed setting 1 Gather hazelnut sized pieces together and drop by hand onto the feed chute The scroll will pick up each piece of dough and self feed through the screen You should be able to see the scroll before adding the next piece of dough To ensure that the pasta is evenly shaped feed the dough through the feed chute at a constant rate IMPORTANT Speed setting 3 is the highest speed setting you are allowed to choose when using the Pasta Attachment IMPORTANT Operate in a slow and constant pace Do not try to rush the procedure by pushing down the dough This way the scroll might gets blocked and stops operating In the unlike event of dough no longer self feeding through the scroll use the handle of the specially designed spanner to assist Turn the appliance Off as long as you use the handle of the spanner for cleaning the blockage Do not use a knife or spoon handle as they may damage the scroll of your Pasta Attachment If no dough is coming out the outlet even though there is still dough in the feed chute turn the appliance Off and work according to the instructions Trouble shooting guide NOTE The Pasta first extruded will always tend to curl in different directions This is quite normal and the pasta will straighten as it continues to be extruded If desired
7. curely tighten the ring nut picture D NOTE Do not tighten the ring nut too much to avoid over winding the thread The Pasta Attachment is now assembled and can be attached to the Design Standmixer Advanced 5 Prop up the attachment access picture E 6 Press down the attachment ejector picture F and slide the Pasta Attachment into the opening Release the attachment ejector and turn the Pasta Attachment slightly so that the shaft engages in the socket with pin of the access opening located in the hole of the attachment The Pasta Attachment is now ready for use picture G To operate the Pasta Attachment WARNING For the case that liquid runs over the appliance while operating turn the appliance Of immediately and pull the plug Clean and dry the appliance according to the instructions Care and cleaning l Prepare the pasta dough 2 Assemble the Pasta Attachment as described attach it to the Design Standmixer Advanced and place a plate or dish in front of the outlet WARNING Always make sure that the appliance is turned Off before plugging in the power supply 3 Plug the power supply cable into a mains socket WARNING Never hold your face or other body parts over the feed chute when the motor is running because little pieces of food could be thrown out of the feed chute Never push the food through the feed chute ATTENTION Avoid contact the moving parts Keep hands hair clothing
8. lf way through mixing The dough will resemble bread crumbs Cook pasta in boiling salt water for approx 5 10 minutes according to the shape of the pasta and your favour aldente or through Accessories for the Design Stand Mixer Advanced You will get the accessories from your specialty retailer Pasta Maker Attachment Art Nr 98100 Meat Grinder Cookie Attachment Art Nr 98101 Food Slicer Shredder Attachment Art Nr 98102 Additional stainless steel bowl Art Nr 98103 GASTROBACK GmbH GewerbestraBe 20 e D 21279 Hollenstedt Germany htto www gastroback de e E Mail info gastroback de
9. lothing as well as spatula and other utensils away from accessory during operation to prevent injury and or damage to the mixer or the attachment e IMPORTANT Speed setting 3 is the highest speed setting you are allowed to choose when using the Pasta Attachment Please note that dough made too dry or fed through too quickly may cause your Pasta Attachment to break e DO NOT immerse the motor housing or power cord in any liquids or spill any liquids on it e Never leave the appliance unattended when in operational mode Do not leave the appliance unattended while connected to the power supply Always switch Off the appliance and IMMEDIATELY unplug the appliance after operation and if it is not in use cleaning and or assembling or disassembling the processing tools Always grasp the plug to disconnect the appliance from the power outlet The Pasta Attachment SCANAARKRWN gt spanner for the ring nut ring nut spaghetti screen scroll tray housing macaroni screen rigatoni screen tagliatelle screen 10 lasagne screen 11 large macaroni screen 12 Cleaning tool 13 measuring cup 500 gr Pasta Attachment Operating Before first use of the Pasta Attachment Remove all promotional materials and packing as well as any foreign objects but do not remove the model label Before first use and after a long period of storage clean the processing tools in warm soapy water see Care and Cleaning Using the Pasta Att
10. ment on a clean and stable surface where it can not fall Do not place any hard or heavy objects on the appliance or the attachment Notes for disposal Dispose of the appliance must be effected in accordance with the corresponding local regulations and requirements for electrical appliances Please contact your local disposal company Warranty We guarantee that all our products are free of defects at the time of purchase Any demonstrable manufacturing or material defects will be to the exclusion of any further claim and within 2 years after purchasing the appliance free of charge repaired or substituted There is no Warranty claim of the purchaser if the damage or defect of the appliance is caused by inappropriate treatment over loading or installation mistakes The Warranty claim expires if there is any technical interference of a third party without an written agreement The purchaser has to present the sales slip in assertion of claims and has to bear all charges of costs and risk of the transport Recipes Never make more quantity of pasta given in the recipes at any one time otherwise the dough will dry out before it has been extruded NOTE Smaller quantities of pasta may be made by exactly halving these recipes in which case the liquid to be added should reach the lower line 250g on the measuring cup TIP The parts of the Pasta Attachment may first be warmed in a bowl of hot water to assist extruding Dry thoroughly before
11. ner for emptying the feed chute Follow the cleaning instructions step by step 3 Wash all parts thoroughly in hot soapy water Do not use aggressive detergents The parts are not suitable for dishwasher Soak parts with desiccated food leftovers a few minutes in warm soapy water and use a nylon cleaning brush or cleaning sponge and the provided cleaning tool for cleaning Rinse all parts with running water and dry them accurately 4 Wipe the appliance and power cord with a damp soft cloth Take care not to spill or drip water or any other liquids on the appliance 5 Thoroughly dry the appliance and all parts of the appliance and attachment after each cleaning Leave all parts dry naturally where they are out of reach of young children Clear a blocking If the outlet is blocked no dough comes out of the attachment while operating ATTENTION If a blocking occurs turn Off the appliance immediately Clear the problem before turning on the motor again l Turn the appliance Off 2 Turn the motor On speed control 1 3 and Off by turns to loosen the blocking ATTENTION If the motor still does not start running turn the appliance Off pull the plug and clean the appliance Trouble shooting guide Possible problem Easy solution The pasta is not fine enough Use a different pasta screen There are still ingredients in the feed chute The attachment is blocked Turn the appliance Off immediately and but nothing
12. use TIP Spaghetti Tagliatelle and Lasagne may be cooked immediately or allowed to dry before storing in a plastic bag TIP Macaroni Rigatoni and large macaroni must be cooked within 4 hours of extruding otherwise they become very brittle and snap Plain Pasta for 4 6 persons 500g flour 4 eggs water 1 2 teaspoon salt Add salt to the flour in a big bowl Beat eggs in measuring cup provided and add water up to the top line 500g of the measuring cup Add eggs and water to the flour Mix with beater on low speed stopping to scrape the mixture from the sides of the bowl half way through mixing The dough will resemble breadcrumbs Cook pasta in boiling salt water for approx 5 10 minutes according to the shape of the pasta and your favour aldente or through TIP Use wholemeal flour instead of plain flour for wholemeal pasta Herb Pasta for 4 6 persons 500g flour 4 eggs 40ml fresh herbs finely chopped 1 2 teaspoon salt pinch pepper Add herbs to the flour and prepare dough according to the instructions of Plain Pasta Green Pasta for 4 6 persons 500g flour 3 eggs 75g boiled and pureed spinach 1 2 teaspoon salt Add salt to the flour in a big bowl Beat eggs and spinach in measuring cup provided and add if required water up to the top line 500g of the measuring cup Add eggs and spinach to the flour Mix with beater on low speed stopping to scrape the mixture from the sides of the bowl ha
Download Pdf Manuals
Related Search