Thermalright V-1 Ultra
Contents
1. VI Installation Guide pic 2 pic 3 First insert the white plastic washers 11A B through the included M2 5x7mm screws 12A B and then insert through the designated holes on the back of the VGA card 10A B From the top side of VGA card insert the included black plastic washers 9A B through the M2 5x7mm screws 12A B and then slightly tighten the screws on the black metallic arm plate 7A B Please Note The side with the protruding screw hole on the black metallic arm plate 7A B needs to be facing upward while the protruding screw hole for 8A B needs to be facing downward For most video cards using the 2 short black metallic arm plates 25mm in length should suffice unless the distance between the video card s fixed holes 10 Aand B are greater than the short black metallic plates in length If so consider using the 2 long black metallic arm plates 33mm in length 2 Put the black metallic retention mount 5 around the GPU 13 please refer to Pic 3 and visually make sure that it is aligned and centered to the GPU 3 Using the included M2 5x4mm screws 3A B slightly tighten the black metallic arm plate underneath the long oval shaped slot 6A B on the black metallic retention mount Please note The protruding screw holes 8A B need to be facing downward 4 Slightly tighten the black metallic retention mount and the black metallic arm plate Make sure not to screw in too t2. ight as you need to align the square shaped opening on the black metallic retention mount to the center of the GPU and then use the M2 5x4mm screws 3A B and M2 7X7mm screws 12A B to tighten 5 Apply a thin layer of the thermal paste evenly on the protruding square mount at the bottom of the heat sink pic 4 as well as on the GPU itself Put the heat sink on top of the VGA card at the same time minding the protruding square mount at the bottom of the heat sink as you need to line up to fit through the square shaped opening on the black metallic retention mount Then align the four holes on the heat sink 2A B C D to the 4 screw holes 5A B C D on the black metallic retention mount Finally using the M3x5mm screws 1A B C D to tighten and secure the heat sink on the black metallic retention mount in a crisscross diagonally corner to corner sequence i e 1A 1C and then 1B 1D nVidia GeForce4 VGA Card lon Important Be sure to plug in the fan for the VGA before turning on the computer Thermalri ght 4 Inc www thermalright com
Download Pdf Manuals
Related Search