Quooker Q7-MODERN-BRCH faucet
Contents
1. nut and the loose metal ring Push the tap through the hole in the sink Fit the rubber ring between the tap and the sink 2 Tightening Screws Set the tap to the desired position and tighten the screws in the sink nut Only if necessary D A hex head bolt key width 2 mm enables the tap to be twisted if neces sary Loosen the hex head bolt Viewed from above turn it clockwise as far as the stop Then turn back a few degrees Quooker a o C freely up and down Then retighten the hex head bolt so that the tap outlet is able to move Connecting water e N B The Quooker operates under water supply pressure and must always be fitted with the inlet combination supplied e The Quooker boiling water tap must be connected according to the locally applicable regulations e Position the inlet combination at such a height that the difference in height between it and the drain is the maximum possible to allow the expansion water to run off see D4 1 Cutting through 1 2 cold water pipe Cut through the cold water pipe at a suitable point 2 Making space for T piece 3 Connecting T piece Position the T piece between the pipe sections and tighten the clamping nuts 4 Fitting the inlet combination Connect the inlet combination to the T piece with a copper tube 15 mm Screw the transparent funnel in the2. heating element is heating If the mains lead is damaged it should be replaced by the manufacturer their agent or a qualified technician to prevent a hazard 1 Connecting tank Place the Quooker in position and 2 connect it to the inlet combination with the fibre ring supplied 2 Connecting tap Connect the other short hose to the tap in the same way with the fibre ring supplied 3 Flushing tank Open the Quooker tap Now open the main tap and the tap of the inlet combination Check for leaks Flush the Quooker through for a few minutes until the water is clear Black water will flow out first This is Norit carbon from the filter and is incidentally completely harmless 4 Electrical connection To connect the indicator lamp insert the plug into the hole provided Connect the tank to an earthed socket and do not switch it on until the tank is filled with water The Q button on top of the tank is the on off switch After the Quooker has heated up the entire content of boiling water must be flushed out once before use Disconnecting the tank CRE Oo O0 On off 1 Switch off Set
3. Installation guide VAQ Before installing read this guide first Introduction The operation of the Quooker The Quooker system consists of a small tank under the sink which is connected to the boiling water tap This tank is connected to the water by a so called inlet combination The water is heated electrically to approx 110 C and is kept at this temperature When boiling water is drawn off cold water flows into the tank at the same time and is automatically heated Before the water leaves the tank it is purified by the HiTAC water filter High Temperature Activated Carbon If the entire content is used in one go the heating time is ten to fifteen minutes depending on the electrical power see technical specifications Different tanks are available the PRO3 VAQ 1600 W and the PRO7 VAQ 3000 W All Quooker taps are fitted with a childproof push and turn handle and are also vertically adjustable and insulated Installation maintenance and warranty The Quooker can be installed wherever there is a water supply and a socket The Quooker comes with a handy installation kit including the required inlet combination for easy fitting and is maintenance free The HiTAC filter cartridge has to be replaced about once every five years when any lime scale that has built is also removed from the tank The warranty period is two years and covers supply of parts only This does not include labour costs Please note that under no ci
4. hole in the inlet combination provided for this purpose Connecting drain The Quooker tank releases expansion water via the inlet combination during heating this water is being fed into the grey funnel The funnel can easily be connected to the drain by means of the drain hose supplied The drilling kit also supplied can be used to make a connection to the drain pipe Try to keep the difference in height between the inlet combination and the connection to the drain as large as possible to keep the drain water from flowing back 2 as high as possible 1 Drilling hole Using the drill bit supplied drill and tap in one operation a threaded hole in the grey PVC drain pipe Drill slowly so that the PVC does not melt Turn back anticlockwise to preserve the thread 2 Screwing in nipple First try to screw the nipple in the hole before fitting permanently with PVC glue 3 Hose to drain Slide the drain hose over the PVC nipple 4 Hose on inlet combination Connect the other side of the hose with a suspended bend to the funnel of the inlet combination This will create a water lock to prevent smells from the drain pipe Connecting tank N B Do not switch on the Quooker until the tank is filled with water The Quooker tank is supplied with a 3 core mains cord with earthed plug The Quooker tap is fitted with an indicator lamp which indicates whether or not the
5. oker drill bit fibre rings PVC nipple and drain hose Quooker brochure Installation guide and tips for use B Blo Overview of Quooker installation It is recommended that you install the Quooker in the following order A Drill hole B Fit tap C Connect water D Connect drain E Connect tank Drilling hole When the outlet is in its lowest position it projects approx 25 cm below the sink e The tap should be located in one corner of the basin s e N B It must be possible to move the tap outlet freely up and down Bear this in mind when fitting the inlet combination sockets and the like e The radius of the outlet is a good 16 cm from the centre of the tap hole which determines how far the outlet extends into the basin Q Mixer tap Quooker tap 1 Drilling hole Allowing for the basin and the mixer tap select a suitable location for the Quooker tap see examples Using the correct drill bit drill a hole of 32 35 mm in the sink Maximum thickness 50 iz 70 Hole 32 35 d 50 Max 256 Basin Dimensions in mm Fitting tap e N B The total length of the boiling water hose is only 50 cm The tank must therefore be fitted close to the tap An extension hose is available but is not normally required 1 Tap through sink Loosen the brass sink nut Clinch the loop in the hose and remove the sink
6. rcumstances should the Quooker be connected to a descaling system that reduces the pH level of the water as this will void the warranty Technical specifications Tanktype PRO3 VAO PRO7 VAO Voltage 230 V 230 V Wattage 1600 W 3000 W Capacity 3 litres 7 litres Heating up time cold tank 10 mins 15 mins Standby power consumption 10 W 10 W Tank height 40 cm 47 cm Tank diameter 15 cm 20 cm Tap hole size 32 mm 32 mm Max working pressure 10 bar 10 bar Safety features maximum temperature pressure relief valve 10 bar Water shut off valve ceramic HiTAC water filter High Temperature Activated Carbon life expectation approx 5 years Approval WRAS certificate no 0601100 Declaration of conformity Peteri B V Staalstraat 13 2984 AJ Ridderkerk The Netherlands herewith declares on our own responsibility that the products Quooker PRO3 VAQ and PRO7 VAQ are in accordance with the conditions of the following Directives 72 23 EEC Low voltage Directive 89 336 EEC Electromagnetic Compatibility Directive 97 23 EG Pressure Equipment Directive and are in conformity with the following standards EN 60335 1 02 A11 04 A1 04 EN 60335 2 21 03 A1 05 EN 60335 2 15 03 EN 50366 03 Electromagnetic Fields The Netherlands Ridderkerk 19 08 2008 Niels Peteri Managing director Content OO 01 BB Wh of the pack Quooker tank Quooker tap Quooker inlet combination Quo
7. the power switch off and remove the plug from the outlet 2 Draining Open the Quooker tap and leave the water running until it is cold 10 15 C ATTENTION initially the water will be extremely hot 3 Isolating Close the main water valve or the stop valve of the inlet combination Check that the Quooker is depressurised by opening the Quooker tap again If it is depressurised no water will flow out of it 4 Disconnecting Unscrew the hoses and pull the LED cable from the top cover Drain the unit into the sink www quooker co uk QUOOKER UK LTD 3 Waterpark Hall Montpellier Mews Salford M7 4ZY UK P 44 0 207 9233355 F 44 0 207 9001590 Internet quooker co uk E mail info quooker co uk Q uooker THE BOILING WATER TAP UK 30 005 03 V02
Download Pdf Manuals
Related Search