Metra 99-5720 mounting kit
Contents
1. A Strip wire ends back 1 2 B Twist ends together C Solder D Tape Locate the factory wiring harness in the dash Metra recommends making connections as shown using the supplied wire harness Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit Right Front Right Front Left Front Left Front Right Rear Right Rear Left Rear Left Rear Orange White Blue White NOTE Ground head unit to vehicle DIN HEAD UNITS Slide the DIN cage into the Integrated Mounting Kit and secure by bending the metal locking tabs down Slide the aftermarket head unit into the cage until secure see Fig B Rev 12 21 07 amp Shaft and 99 5720 DIN unit provisions INSTALLATION INSTRUCTIONS amp Various mounting depth alternatives gt Incorporates factory climate controls into installation APPLICATIONS CAR PAGE KIT COMPONENTS FORD Escort 1997 04 Escort ZX2 1998 04 Integrated Mounting Kit ZX2 2003 04 cc ccccccccccececcececeueaees 1 3 MERCURY Tracer 1997 99 c ccccccccececceceeeenes 1 3 Speaker Harness TOOLS REQUIRED 86 5618 Head unit removal keys a e Torx head screwdriver Cutting tool 1 800 221 0932 www metraonline com COPYRIGHT 2001 07 METRA ELECTRONICS CORPORATION ALL VEHICLES Disconnect the negative battery terminal to prevent an accide2. ntal short circuit Reach under the driver s side dash and unclip the temperature control cable Using Metra s 86 5618 pull the factory radio climate control panel from the dash Disconnect the switch power harness antenna plug radio speaker power harnesses and vacuum hose harness BACK VIEW OF INTEGRATED CONTROL PANEL Turn the integrated control panel over and disconnect the vent control harness A fan speed control harness B and defroster harness C Unclip the main switch harness from the side of the factory unit This harness connects the fan speed control harness vent control harness and defroster harness Turn the factory climate control dials into a vertical position and pull the dials off see Fig A Unclip the vent control switch and remove Remove 2 torx head screws securing the temperature control switch and fan speed control switch and remove see Fig B Mount the switches to the back of the Integrated Mounting Kit with the same torx head screws see Fig C Holding the climate control dials in a vertical position insert the dials onto the posts of the mounted switches and secure see Fig D Make all wiring connections to the Integrated Mounting Kit and snap the assembly into the sub dash Reach under the driver s side dash and re attach the temperature control cable Cut and remove the shaded portion of the sub dash lip see Fig A
Download Pdf Manuals
Related Search