Metra 99-5800 mounting kit
Contents
1. DIN HEAD UNITS Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs outward Slide the aftermarket head unit into the cage until it snaps into place Strip wire ends back 1 2 A B Twist ends together C Solder D Tape Locate the factory wiring harness in the Re connect the battery terminal and test the unit dash Metra recommends using the for proper operation Snap the head _ unit kit proper mating adaptor and making assembly into the sub dash connections as shown Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit rev 4 10 08 KIT FEATURES Mela Pa Metra Division of METRACORP DIN unit provision nae 99 5800 provision INSTALLATION Pocket provision INSTRUCTIONS KIT COMPONENTS APPLICATIONS Radio Housing CAR PAGE FORD Expedition 1997 98 ccesscssssscesssesssesssrers 1 3 F 150 1997 08 oeconomia i ra 1 3 TOOLS REQUIRED oA 86 5618 Head unit removal keys gt Socket set a Cutting tool lt L 1 800 221 0932 amp www metraonline com Dremel tool COPYRIGHT 2001 METRA ELECTRONICS CORPORATION Disconnect the negative battery terminal to prevent an accidental short circuit Place your index fingers on the inner edges of the a c vents shown above and push inward Grasp the exposed lip of each vent opening and pull out on the r2. adio trim bezel Remove the dash trim bezel The airbag wiring does NOT need to be disconnected Using Metra s 86 5678 pull the factory head unit from the dash and disconnect the wiring Inside edge of sub dash REMOVE THE REAR SUPPORT BRACKET FROM THE DASH CAVITY USING ONE OF THE FOLLOWIING METHODS Remove 1 7mm hex head bolt securing the bottom of the bracket to the back wall of the sub dash and 2 7mm hex head bolts securing the top of the bracket to the inside edge of the sub dash Remove the bracket see Fig A OR Remove 1 7mm hex head bolt securing the bottom of the bracket to the back wall of the sub dash and cut the bracket flush with the top edge of the radio opening Remove the bracket see Fig B IF THE RADIO OPENING IS DESIRED IN THE UPPER POSITION Using a dremel tool cut and remove the shaded portion of the dash cavity plastic see Fig A TO AVOID CUTTING THE DASH CAVITY PLASTIC Trim the points off the mounting clips located on either side of the Radio Housing see Fig B Use the radio opening in the lower position for the remainder of the installation IF AN EQUALIZER WILL NOT BE INCLUDED Skip to step 5 IF AN EQUALIZER WILL BE INCLUDED Cut and remove the pocket shaded from the Radio Housing see Fig A Slide the equalizer into the Housing and secure with plumber s tape see Fig A
Download Pdf Manuals
Related Search