Premier UPD-1072B
Contents
1. using the four 4 M10 bolts firmly tightening the bolts TILT Secure the PSB TBP Universal flat mount to the adapter using the four 4 M10 bolts firmly tightening the bolts Step 5 Raise the display with the PSM FLAT TILT SERIES mount attached to the display and insert the four 4 receiving tabs to the four 4 flanges found on the Universal PSB FBP flat mount Push to the right and down to lock the display Secure the display to the mount by using two 2 6 mm x12 mm Slotted hex screws supplied for additional security WARNING The UPD MOBILE SYSTEM Series cart is designed for movement across smooth Flat Hard carpeted surfaces Extra care must be exercised against tipping when moving the cart on sloped surfaces or over edges Failure to do so could result in serious personal injury NOTE The UPD MOBILE SYSTEM Series mobile carts are designed to carry maximum weight of 175lbs between the combined weight of the display and accessory items CAUTION This cart is intended for use only with the maximum weights indicated Use with appliances heavier than the maximum weight may result in instability causing possible injury STEP 3 4 5 tequires tit WARNING INSTALLATION INSTRUCTIONS The wall ceiling floor Should be capable of supporting a weight of at least five 5 times the projector s or monitor s weight If it cannot the ceiling must be reinforced Proper installation procedure by qualified personnel as outlin2. INSTALLATION INSTRUCTIONS PREMIER MOUNTS UPD SERIES MOBILE CART SYSTEM Step 1 Unpack the UPD cart Place the base on a flat surface Invert the base and insert the casters Step 2 Insert the two 2 2 chrome tubes into the base receiving holes Be sure to loosen t he two 2 socket screws in the base to allow the tubes to be fully seated in the base Once seated firmly tighten the two 2 socket screws against the tubes Do not over tighten If using the Optional PSD 1417 Maximum load weight 18 Lbs Insert the shelf over the chrome tubes adjust the shelf to the height desired make sure to leave enough space for the plasma secure the height by tightening the two 2 socket screws on the back If using the Optional PSD EXT Loosen the two 2 socket screws from the extension top and bottom Insert the extension to the tubes and tighten the bottom socket screws then insert the tubes on top and tighten the socket screws Do not over tighten Note Do not extend any 2 chrome posts beyond 84 high with the PSD EXT collar OPTIONAL CHROME TUBES Step 3 Install the plasma mount adapter over the 2 chrome tubes all ready installed Make sure to secure the adapter in the center of the optional PSD 1417 if applies and the end of the tubes Secure the adapter using two 2 socket screws tighten firmly against the tubes Do not over tighten Step 4 FLAT Secure the PSB FBP Universal flat mount to the PSD SPA adapter
3. ed in the installation instructions must be adhered to Failure to do so could result in serious personal injury UPD SERIES MOBILE CART Supplying the world with For further information or ordering assistance Su pe rior Contact us at the phone address number shown on the front of this page mou nts Progressive Marketing Products Inc 3130 E Miraloma Avenue Anaheim CA 92806 2 Ph 800 368 9700 Fax 800 832 4888 We re tasiomer Driven E mail HA ir Sali Web Henigo epee
Download Pdf Manuals
Related Search