Chief FSM4241 flat panel wall mount
Contents
1. place see Figure 5 10 24 Screw pene 0 375 Predrill Hole pai a t Locked Unlocked SS Outer Mounting Holes Insert anchor into predrilled hole Anchor Barb Stops anchor rotation Turn 10 24 screw clockwise until anchor fully seats against back side of wall a i N CW Center Mounting Holes Figure 4 Figure 5 Figure 3 F gt 42 ap They a2. F MANUFACTURING INC 1 800 582 6480 Fax 1 877 894 6918 Email chief chiefmfg com C AUTION Minimum Sheetrock Thickness 1 2 Inch Drywall Installation Procedures 1 Using the wall bracket as a template at the desired mounting location mark the location of the four outer mounting holes 2 Using a 3 8 inch drill drill four pilot holes to a minimum depth of 1 1 2 at the locations marked in Step 1 3 Install an anchor bolt in one of the pilot holes and tighten anchor bolt until it is fully seated see Figure 3 4 Remove and retain bolt from anchor and repeat Step 3 and 4 for three remaining anchor bolts Install 25 ID X 56 OD flat washer on each of four bolts removed from anchors 6 Using four bolts with washers installed secure wall bracket to wall Wood Stud Installation Procedures 1 Locate stud and using wall bracket as a template at the desired height mark the location of the two center mounting holes 2 Install a flat washer on each of the two wood screws 3 Using the two wood screws with flat washers installed secure wall bracket to wall Mounting Display with Interface Bracket to Wall Bracket 1 Make sure the latching flag on the mounting bracket is in the unlocked position see Figure 4 2 Place your small flat panel display with interface bracket attached onto the wall bracket making sure it is securely seated 3 Lower the latching flag on the wall bracket locking small flat panel display in
3. INSTALLATION INSTRUCTIONS FSM SERIES SMALL FLAT PANEL DISPLAY STATIC WALL MOUNT Exclusive Q2 Mounting System Prior to assembly unpack carton completely and verify contents If you are missing any of the following components please contact Customer Service at 1 800 582 6480 Figure 1 1 FSM Wall Bracket 4 Drywall Anchor 2 Wood Screw 4 Washer Flat 25 ID X 56 OD BEFORE PROCEEDING READ INSTALLATION INSTRUCTIONS COMPLETELY BEFORE PROCEEDING READ INSTALLATION INSTRUCTIONS COMPLETELY WARNING IMPROPER INSTALLATION MAY RESULT IN SERIOUS PERSONAL INJURY C AUTION When mounting Chief Manufacturing accessories the structural system and mounting method MUST be capable of supporting 5 times the combined weight of the total installation The maximum weight to be installed on the FSM is 45 pounds 20 4 Kg in wood stud and 30 pounds 13 60 kg in drywall Flat Panel Displays are Extremely Fragile CAUTION If Monitor Uses a Screw Size Other Than M4 X 10mm M4 X 20mm DO NOT USE M4 Screws Provided Monitor Damage Could Occur Interface Bracket Installation 1 See installation procedures accompanying your mounting bracket Optional Latching Flag Placement 1 Remove Phillips head screw Nylock nut and latching flag see Figure 2 2 Reposition latching flag and secure using Phillips head screw Nylock nut y Move latch Remove screw lt and nut ea a 8804 000046 RevA Figure 2 o 3 2 28 07 CHIE
Download Pdf Manuals
Related Search