Chief CMA151
Contents
1. INSTALLATION INSTRUCTIONS 1 1 2 to 1 NPT Adapter Accessory Model CMA 151 Specifications e Adapts a 1 1 2 NPT threaded fitting to a 1 NPT threaded column e Intended for use with Chief CMA Series accessories and RPA Series mounts NOTE ULL listed assemblies require the use of U L listed components e Weight capacity of 250 lbs 113 kg BEFORE YOU BEGIN WARNING It is the installer s responsibility to make sure all components are properly assembled and installed using the instructions provided Failure to read thoroughly understand and follow all instructions can result in serious personal injury damage to equipment or voiding of factory warranty e If you have any questions about this these instructions or your specific installation contact Chief Manufacturing at 1 800 582 6480 or 952 894 6280 CHIEF MANUFACTURING INC 8803 000073 Rev A I F F 1 800 582 6480 952 894 6280 FAX 952 894 6918 2006 Chief Manufacturing NF 8401 EAGLE CREEK PARKWAY STE 700 www chiefmfg com Ideas Supporting Ideas SAVAGE MINNESOTA 55378 USA 02 06 Model CMA 151 Installation Instructions A IMPORTANT WARNINGS AND CAUTIONS WARNING A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions CAUTION A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions WARNING Exceeding the weigh2. t capacity can result in serious personal injury or damage to equipment It is the installer s responsibility to make sure the combined weight of all components located between the CMA 151 up to and including the display projector does not exceed 250 Ibs 113 kg e The weight capacity of the CMA 151 may be LIMITED to the lowest weight capacity of any other component located between the CMA 151 and the supporting structure DIMENSIONS PARTS After unpacking carton inspect and verify contents See Figure 1 If any listed parts are missing or damaged 22 844 contact Chief Customer Service at 1 800 582 6480 Table 1 Parts Adapter 1 1 2 to 1 NPT Hem COLUMN Threaded 1 NPT 1 rites atsoieg i pi 1 NPT ID FITTING Threaded 1 1 2 NPT required not supplied 1 1 2 NPT ID TOOLS REQUIRED FOR INSTALLATION e Pipe Wrench NOTE Other tools may be required depending on your method of installation Figure 1 Parts INSTALLATION 1 Screw adapter 10 onto 1 NPT threaded column by hand 2 Screw 1 NPT threaded column with adapter 10 into 1 1 2 NPT threaded fitting Tighten securely using pipe wrench
Download Pdf Manuals
Related Search