Chief SLB6500
Contents
1. Turn projector upside down 3 Place Interface bracket onto bottom of projector and align four threaded inserts with mounting holes 4 Secure Interface bracket to projector using four M6 x 12mm Phillips pan head screws and four M6 flat washers NOTE If there is interference when installing the bracket due to the design of certain projector models use the nylon spacers and longer M6 x 16mm screws instead of the M6 x 12mm screws and M6 flat washers NOTE Security Screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the All Points Security Kit Chief is a registered trademark of Milestone AV Technologies All rights reserved Milestone AV Technologies and its affiliated corporations and subsidiaries collectively Milestone intend to make this manual accurate and complete However Milestone makes no claim that the information contained herein covers all details conditions or variations nor does it provide for every possible contingency in connection with the installation or use of this product The information contained in this document is subject to change without notice or obligation of any kind Milestone makes no representation of warranty expressed or implied regarding the information contained herein Milestone assumes no responsibility for accuracy completeness or sufficiency of the information contained in this document 8850 000194 Rev01 Oy CH E F C2. INSTALLATION INSTRUCTIONS SLB 6500 and SLM 6500 Interface Brackets SLB and SLM series Interface brackets are designed for use with Chief RPA RPM and Smart Lift series projector mounts See the specific installation instructions provided with the mount for additional installation information Unpack carton and verify kit contents If any listed parts are missing immediately contact a Chief Customer Service representative WARNING IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT substitute hardware Use only hardware supplied by manufacturer 1 Interface Bracket 4 Screw Phillips Pan Head Machine M6 x 12mm 6 10 24 Thumb Nuts 4 Washer Flat M6 1 All Points Security Kit 4 Screw Phillips Pan Head Machine M6 x 16mm 1 5 32 Hex Key 4 Spacer Nylon 320 x 500 x 250 Towards front of projector Towards front of projector SLB 6500 SLM 6500 Only used when installing SLB Interface brackets Installation WARNING OVERTIGHTENING OF SCREWS CAN DAMAGE PARTS AND LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT DO NOT over tighten screws when installing Interface bracket NOTE Step 1 is only required when installing an SLB Interface bracket If an SLM bracket is being installed proceed to step 2 1 Screw six thumb screws onto six 10 24 x 5 8 Phillips pan head screws DO NOT fully tighten thumb screws at this time 2
3. hief Manufacturing a products division of Milestone AV Technologies 2009 Milestone AV Technologies AZ 8401 Eagle Creek Parkway Savage MN 55378 I AAA ante Our Mounts Your Vision e P 800 582 6480 952 894 6280 F 877 894 6918 952 894 6918 05 09
Download Pdf Manuals
Related Search