Draper 137009 projection screen
Contents
1. Spiceland IN 47385 USA I 765 987 7999 www draperinc com I fax 765 987 7142 Copyright 2008 Draper Inc Form SalaraM_Inst08 Printed in U S A Clean with a very soft brush or cloth and carefully dust the surface DO NOT USE SOAP WATER SOLVENTS OR ABRASIVES These substances will damage a glass beaded viewing surface If you encounter any difficulty installing or servicing your Salara call your dealer or Draper Inc Spiceland Indiana 765 987 7999 or fax 765 987 71422. Installation Instructions Salara Series M by Draper A Caution Read and understand these instructions keep them for future reference Follow instructions carefully Care in both mounting and correct operation will mean long and satis factory service from your Draper screen Locate the screen where the audience can best see it and where other room furnishings permit Mount the screen so that the bottom of the picture when screen is fully extended will be above the heads of viewers When raising screen pull down and while holding allow for slow retraction into the case to reduce risk of injury from falling screen Screen should be installed level using a carpenter s level Nothing should be fastened to screen dowel or viewing surface NOTE Screen has been thoroughly inspected and tested at factory and found to be operating prior to shipment Wall Ceiling Flush Mounting Attach Mounting Brackets to wall or ceiling see Fig 1 The installer should furnish screws toggle bolts molly bolts nylon or lead anchors as required by the mounting surface Installer also needs to ensure the mounting surface is reinforced sufficiently to support the screen Brackets must be level with each other Mounting Bracket Ceiling Mounting Bracket Figure 1 Attach the screen by snapping the extrusions on the back of the case onto the brackets With the lower edge of the screen case tilted awa
3. y from the wall engage the rib on top of the case with the slot on each bracket Slide the screen case along the brackets to adjust the screen location from left to right if necessary see Fig 2 Once the case is in position pivot the case back toward the brackets until the lower edge of the case snaps into place with the spring loaded latch see Fig 3 Extrusions along back of case Figure 2 Figure 3 Operating Instructions Standard To lower picture surface pull screen down Hesitate then allow screen to retract very slowly until it locks in place ZNTo raise picture surface pull screen down and while holding allow for slow retraction into the case to reduce risk of injury from falling screen Operating Instructions AutoReturn To lower picture surface pull screen down Hesifate then allow screen to retract very slowly until it locks in place To raise picture surface pull screen down gently until it stops then release Dimensions Floating Mounting Brackets 5 16 i in Case Length gt i 3 8 A Hw ES a Ea lt te O si t 16 E NS ee Viewing Surface a E36 l lt 5 57 16 16 Viewing Surface Care amp Maintenance Matt White amp High Contrast Grey Glass Beaded Clean surface with a solution of mild dishwashing liquid diluted with warm water Sponge the surface rinse with clear water and blot dry Do not use cleaning solvents or abrasives ise 411 S Pearl St
Download Pdf Manuals
Related Search