Tripp Lite ISOBAR4/220
Contents
1. 220 CCIEURO TT Input Voltage gt 220 240 VAC 220 240 VAC 220 240 VAC Input Frequency 50 60 Hz 50 60 Hz 50 60 Hz Circuit Breaker Amperage Rating 10 amp S 10 amp 10 amp AC Receptacles 4 IEC 320 4 NEMA 5 15R 5 IEC 320 AC Power Cord l 2 m detachable 2 m fixed 2 m detachable Plug Type IEC 320 NEMA 5 15P IEC 320 Surge Suppression Rating 620 joules 1020 joules 340 joules Transient Response Time Instantaneous Instantaneous Instantaneous Line Noise Suppression Rating gt 60 dB 1 MHz gt 75 dB 1 MHz gt 60 dB 1 MHz Approvals CE TUV CE Three conductor grounded Transient amplitude reduction occurs faster than the clamp response of the varistors because of the high rejection rate of the Isobar filter network LIFETIME LIMITED WARRANTY TRIPP LITE warrants its products to be free from defects in materials and workmanship for the life of the product TRIPP LITE s obligation under this warranty is limited to repairing or replacing at its sole option any such defective products To obtain service under this warranty you must obtain a Returned Material Authorization RMA number from TRIPP LITE or an authorized TRIPP LITE service center Products must be returned to TRIPP LITE or an authorized TRIPP LITE service center with transportation charges prepaid and must be accompanied by a brief description of the problem encountered and proof of date and place of purchase This warranty does not apply to equipment2. STEP 2 Connect your equipment either 2 or 3 wire tothe Surge suppressor s output receptacles Note If your equipment s plugs do not match the surge suppressor s receptacles use an IEC 320 jumper cord supplied with some models or use a Universal Plug Adapter available separaiely in a variety of plug configurations from 1 Tripp Lite CAUTION Do not connect equipment with a total amperage rating higher than the amperage rating of the surge suppressor s circuit breaker see Specifications on back If the amperage rating is exceeded the circuit breaker will trip Remove overload wait 1 minute and press circuit breaker to reset STEP 3 Turn on the surge suppressor s power switch Note Select models feature switches that illuminate in the ON position Turn on the individual front panel switches on the CCIEURO to control corresponding outlets on the rear of the unit If the CCIEURO s green Protection Present light fails to illuminate the first level of surge protection is inoperative although protection still exists at an adequate level If this occurs return the CCIEURO for service WARNING Do not drill into or open any part of the surge suppressor There are dangerous voltages present inside the unit There are no user serviceable parts inside the unit l _ E Copyright 2000 by TRIPPLITE All rights reserved Isobar is a registered trademark of Tripp Lite C TT 900Z SPECIFICATIONS e EURO 4 ISOBAR 4
3. 2006 11 2 EURO 4 TRIPP LITE 1111 W 35th Street www 1tripplite com F Isobar Surge Suppressors 220 240V Isobar Surge Suppressors protect attached equipment against potential damage from spikes surges and noise interference on the AC line All models feature durable metal cabinets EURO 4 and ISOBAR 4 220 models feature isolated filter banks which eliminate interference between connected equipment CCIEURO models are designed to be located between a computer and monitor for easy access to front panel switches INSTALLATION STEP 1 Using the supplied power cord connect the surge suppressortoa grounded three conductor 220 240 Volt 50 or 60 Hz AC wall outlet Note the Isobar 4 220 is designed for 230V operation but may also be used for 120V operation atreduced suppression levels However it is the user s responsibility to avoid equipment damage to be sure the voltage rating of connected equipment matches the voltage delivered at their AC wall outlet Select surge suppressor models feature a detachable power cord exchange the power cord from these models with a detachable power cord from your equipment from a computer for example with a plug type that matches your wall outlet CAUTION Do not connect the surge suppressor to a UPS system s output receptacles All cords adapters or wall outlets must have a ground pin or connection Lack of a proper ground connection will eliminate common mode protection
4. which has been damaged by accident negligence or misapplication or has been altered or modified in any way This warranty applies only to the original purchaser who must have properly registered the product within 10 days of purchase The warranties of all TRIPP LITE surge suppressors are null and void if they have been connected to the output of any UPS system The warranties of all TRIPP LITE UPS Systems are null and void if a surge suppressor has been connected to its output receptacles EXCEPT AS PROVIDED HEREIN TRIPP LITE MAKES NO WARRANTIES EXPRESS OR IMPLIED INCLUDING WARRANTIES OF MERCHANTABIL ITY AND FITNESS FOR A PARTICULAR PURPOSE Some states do not vom limitation or exclusion of implied warranties therefore the aforesaid limitation s or exclusion s may not apply to the purchaser EXCEPT AS PROVIDED ABOVE IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT INDIRECT SPECIAL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE Specifically TRIPP LITE is not liable for any costs such as lost profits or revenue loss of equipment loss of use of equipment loss of software loss of data costs of substitutes claims by third parties or otherwise The policy of TRIPP LITE is one of continuous improvement Specifications are subject to change without notice 93 1407 8912161 3 00 am
Download Pdf Manuals
Related Search