Indesit TLA 1 S
Contents
1. cause skin abrasions or frost freezer burns e When unplugging the appliance always pull the plug from the mains socket do not pull on the cable e Before cleaning and maintenance always switch off the appliance and disconnect it from the electrical supply It is not sufficient to set the temperature adjustment knobs on 0 appliance off to eliminate all electrical contact e n the case of a malfunction under no circumstances should you attempt to repair the appliance yourself Repairs carried out by inexperienced persons may Cause injury or further malfunctioning of the appliance e Do not use devices or tools other than the special scraper provided inside the compartments e Do not put ice cubes taken directly from the freezer into your mouth e Do not allow children to tamper with the controls or play with the appliance Under no circumstance should they be allowed to sit on the bins or to hang from the door e Keep packaging material out of the reach of children It can become a choking or suffocation hazard Disposal e Observe local environmental standards when disposing packaging material for recycling purposes e The European Directive 2002 96 EC on Waste Electrical and Electronic Equipment WEEE requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream Old appliances must be collected separately in order to optimise the recovery and recycling of the2. materials they contain and reduce the impact on human health and the environment The crossed out wheeled bin symbol on the product reminds you of your obligation that when you dispose of the appliance it must be separately collected Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance Respecting and conserving the environment e Install the appliance in a fresh and well ventilated room Ensure that it is protected from direct sunlight and do not place it near heat sources e Try to avoid keeping the door open for long periods or opening the door too frequently in order to conserve energy e Do not fill the appliance with too much food cold air must circulate freely for food to be preserved properly If circulation is impeded the compressor will work continuously e Do not place hot food directly into the refrigerator The internal temperature will increase and force the compressor to work harder and will consume more energy e Defrost the appliance if ice forms see Maintenance A thick layer of ice makes cold transference to food products more difficult and results in increased energy consumption e Regularly check the door seals and wipe clean to ensure they are free of debris and to prevent cold air from escaping see Maintenance Troubleshooting If the appliance does not work before calling for Assistance see Assistance ch
3. LVESe Drain for DEFROST WATER Compartment for a 2 LITRE BOTTLE FRUIT and VEGETABLE bin Levelling elo BOTTLE shelf e Varies by number and or position Start up and use Starting the appliance SHELVES with or without grill Due to the special guides the shelves are removable and the height is adjustable see diagram allowing easy storage of large containers and food Height can be adjusted without complete removal of the shelf yp Before starting the appliance follow the installation Pa ter instructi Installation Wa instructions see Installation LUG j Before connecting the appliance clean the Lf tments and ies well with luk PF compartiments anaq accessories WEI WI ukewarm LUT water and bicarbonate 1 Insert the plug into the socket and ensure that the internal light illuminates average value After a few hours you will be able to put food in the refrigerator e Use the TEMPERATURE ADJUSTMENT knob to adjust the temperature see Description Setting the temperature e Place only cold or lukewarm foods in the compartment not hot foods see Precautions and tips The temperature inside the refrigerator compartment automatically adjusts itself according to the position of e Remember that cooked foods do not last longer than the thermostat knob raw foods We recommend however a medium position e Do not store liquids in open contai
4. Operating Instructions FRIDGE English 1 TLA 1 TLA 18S 1 inDesit Contents Installation 2 4 Positioning and connection Reversible doors Description of the appliance 5 Overall view Start up and use 6 Starting the appliance Using the refrigerator to its full potential Maintenance and care 7 Switching the appliance off Cleaning the appliance Avoiding mould and unpleasant odours Defrosting the appliance Replacing the light bulb Precautions and tips 8 General safety Disposal Respecting and conserving the environment Troubleshooting 9 Assistance 10 Installation Before placing your new appliance into operation please read these operating instructions carefully They contain important information for safe use for installation and for care of the appliance Please keep these operating instructions for future reference Pass them on to possible new owners of the appliance Positioning and connection Positioning 1 Place the appliance in a well ventilated humidity free room 2 Do not obstruct the rear fan grills The compressor and condenser give off heat and require good ventilation to operate correctly and save energy 3 Leave a space of at least 10 cm between the top part of the appliance and any furniture above it and at least 5 cm between the sides and any furniture side walls 4 Ensure the appliance is away from any sources of heat direct sunlight electric
5. anufacturer declines any liability should these safety measures not be observed Your appliance is supplied with a 13amp fused plug that can be plugged into a 13amp socket for immediate use Before using the appliance please read the instructions below WARNING THIS APPLIANCE MUST BE EARTHED Replacing fuse covers When replacing a faulty fuse a 13amp ASTA approved fuse to BS 1362 should always be used and the fuse cover re fitted If the fuse cover is lost the plug must not be used until a replacement is obtained Replacement fuse covers If a replacement fuse cover is fitted it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug Changing the plug Removing the plug If your appliance has a non rewireable moulded plug and you should wish to remove it to add a longer cable or to re route the mains cable through partitions units etc please ensure that either The plug is replaced by a fused 13amp re wireable plug bearing the BSI mark of approval or The mains cable is wired directly into a 13amp cable outlet controlled by a switch in compliance with BS 5733 which is accessible without moving the appliance Disposing of the plug Cut off and dispose of the supplied plug if it does not fit your socket The cable should be cut as close as possible to the moulded plug Remove the fuse WARNING To avoid a shock hazard do not inser
6. e onto its back onto suitable protective materials i e original packaging Remove the door 1 Lay down the appliance on its back 2 Unscrew remove and retain the bottom hinge pin 3 Slightly open the door and slide downward remove and carefully place to one side 4 Unscrew the hinge pin from the top right hand side and refit the pin into the hole in left hand side 5 Use a thin blunt instrument to remove the top and bottom hinge bushes and blanking plugs from the door take care not to mark the door handle Reposition the blanking plugs and bushes on the opposite side Replacing the door 1 Carefully slide the door upward into the hinge pin 2 Fit the bottom hinge pin making sure that the door is aligned to the cabinet 3 Carefully stand the appliance upright in its required location and make sure it is sitting level on the floor Open and close the door checking that the gasket makes a good seal without any gaps when the door is closed Note Replace loose items fittings back into the appliance and leave for at least 15 minutes before switching back on Description of the appliance Overall view The instructions contained in this manual are applicable to different model refrigerators The diagrams may not directly represent the appliance purchased TEMPERATURE control Removable lidded shelf with EGG TRAY Lamp see Maintenance Removable multipurpose SHELVESe SHE
7. eck for a solution from the following list cB Malfunctions Possible causes Solutions The internal light does not e The plug has not been inserted into the electrical socket or not far illuminate enough to make contact or there is no power in the house The refrigerator and the freezer do not cool well The door do not close properly or the seals are damaged The door are opened too frequently The TEMPERATURE ADJUSTMENT knob is not in the correct position The refrigerator have been over filled The atmospheric temperature of the area surrounding the appliance is lower than 14 C The food inside the refrigerator is e The TEMPERATURE ADJUSTMENT knob is not in the correct position beginning to freeze e The food is in contact with the back inside wall of the refrigerator The motor runs continuously e The door is not closed properly or is continuously opened e The outside ambient temperature is very high The appliance makes a lot of noise e The appliance has not been installed on a level surface see nstallation e The appliance has been installed between cabinets that vibrate and make noise e The internal refrigerant makes a slight noise even when the compressor is off This is not a defect it is normal The back wall of the refrigerator unit e This shows the appliance is operating normally is covered in frost or droplets of wate There is water at the bottom of the e The water discharge hole is blocked see Maintena
8. harge hole regularly so that the water can flow out easily Replacing the light bulb To replace the light bulb in the refrigerator compartment pull out the plug from the electrical socket Follow the instructions below Access the light bulb by removing the cover as indicated in the diagram Replace it with a similar light bulb within the power range indicated on the cover 10W Precautions and tips The appliance was designed and manufactured in compliance with international safety standards The following warnings are provided for safety reasons and must be read carefully This appliance complies with the following C Community Directives 73 23 EEC of 19 02 73 Low Voltage and subsequent amendments ps 89 336 EEC of 03 05 89 Electromagnetic mm COMPatibility and subsequent amendments 2002 96 CE General safety e The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use e The appliance must be used to store and freeze food products by adults only and according to the instructions in this manual e The appliance must not be installed outdoors even in covered areas It is extremely dangerous to leave the appliance exposed to rain and storms e Do not touch the appliance with bare feet or with wet or moist hands and feet e Do not touch the internal cooling elements this could
9. ical contact Cleaning the appliance e The external and internal parts as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap Do not use solvents abrasive products bleach or ammonia e The removable accessories may be soaked in warm water and soap or dishwashing liquid Rinse and dry them carefully e The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power The appliance must be switched off and the plug must be pulled out before cleaning the appliance Avoiding mould and unpleasant odours e The appliance is manufactured with hygienic materials which are odour free In order to maintain an odour free refrigerator and to prevent the formation of stains food must always be covered or sealed properly e f you want to switch the appliance off for an extended period of time clean the inside and leave the door open Defrosting the appliance Follow the instructions below Do not speed up the defrosting process by using any devices or tools you may damage the refrigeration Circuit The refrigerator has an as aA diagram where the heat produced by the compressor causes It to automatic defrosting 4 function water is ducted LZ ex to the back of the LE appliance by a special a discharge outlet see O evaporate It is necessary to clean the disc
10. nce refrigerator Assistance 10 Before calling for Assistance e Check if the malfunction can be solved on your own see Troubleshooting e lf after all the checks the appliance still does not operate or the problem persists call the nearest Service Centre model serial number Communicating e type of malfunction e appliance model Mod e serial number S N This information can be found on the data Gross Bruto plate located on the bottom left side of the Brut R 134a Test Pressure i s HIGH 235 refrigerator compartment T Pott Hl M I N Made in Italy 13918 Never call on unauthorized technicians and always refuse spare parts which are not originals 11 195051888 01 07 2005 Xerox Business Services
11. ners They will The cooling section of the refrigerator is located inside increase humidity in the refrigerator and cause the back wall of the refrigerator compartment for condensation to form increased space and improved aesthetics During operation the back wall will be covered in frost or water droplets depending on whether the compressor is operating or paused Do not worry the refrigerator is functioning normally If the TEMPERATURE ADJUSTMENT knob has been set on high values with large quantities of food and with a high ambient temperature the appliance can operate continuously resulting in excessive frost formation and excessive energy consumption compensate for this by shifting the Knob towards lower values defrosting will occur automatically In static appliances the air circulates in a natural way the colder air tends to move downwards as It is heavier The food should be stored as follows Arrangement inside the refrigerator Fresh fish and meat A the fruit and vegetable Eroehchoead Above the fruit and vegetable bins Cooked food On any shelf Salami bread loaf On any shelf chocolate Fruit and vegetables Butter and margarine Bottles drinks milk Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply It is not sufficient to set the temperature adjustment knobs on 0 appliance off to eliminate all electr
12. stove etc 5 In order to maintain the correct distance between the appliance and the wall behind it fit the spacers supplied in the installation kit following the instructions provided Levelling 1 Install the appliance on a level and rigid floor 2 If the floor is not perfectly horizontal adjust the refrigerator by tightening or loosening the front feet Electrical connections After the appliance has been transported carefully place it vertically and wait at least 3 hours before connecting it to the electricity mains Before inserting the plug into the electrical socket ensure the following e The appliance is earthed and the plug is compliant with the law e The socket can withstand the maximum power of the appliance which is indicated on the data plate located on the bottom left side of the fridge e g 150 W e The voltage must be in the range between the values indicated on the data plate located on the bottom left side e g 220 240V e The socket is compatible with the plug of the appliance If the socket is incompatible with the plug ask an authorised technician to replace it see Assistance Do not use extension cords or multiple sockets Once the appliance has been installed the power supply cable and the electrical socket must be easily accessible The cable must not be bent or compressed The cable must be checked regularly and replaced by authorised technicians only see Assistance The m
13. t the discarded plug into a socket anywhere else Fitting a new plug IMPORTANT WIRES IN THE MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE Green and Yellow Earth Blue Neutral Brown Live As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug proceed as follows Connect Green and Yellow wire to terminal marked E or L or coloured Green and Yellow Connect Brown wire to terminal marked L or coloured red or brown Connect Blue wire to terminal marked N or coloured Black or Blue Ifa 13amp plug BS 1363 is used it must be fitted with a 13amp fuse A 15amp plug must be protected by a 15amp fuse either in the plug or adaptor or at the distribution board If you are in any doubt about the electrical supply to your machine consult a qualified electrician before use CE Marking certifies that this appliance conforms to the following EEC directives Low Voltage Equipment 73 23 EEC amp 93 68 EEC Electromagnetic Compatibility 89 336 EEC 92 31 EEC amp 93 68 EEC Reversible doors Warning Before attempting to remove the door switch off the electrical supply and pull out the mains plug It is recommended that you remove any loose items fittings from inside the appliance and place food into insulated containers whilst carrying out this operation You may require assistance to carefully lay the applianc
Download Pdf Manuals
Related Search