Lenco CR-3304
Contents
1. CD 5 Press the Play Pause gt button Track number 01 amp the symbole amp CD will 3 Insert a disc with the label e side facing up e 4 Close the CD door The disc will rotate and NI the total tracks of the disc ul will show on the display TO INTERRUPT PLAYBACK TO STOP PLAYBACK Press the Play Pause gt I button and the symbol We will Press the STOP button and the display shows the total be flashed Press the button again to resume playback tracks of the disc oo n N oo oo Wf ow TO SKIP TO THE BEGINNING OF A TRACK Press either one of the skip buttons according to the desired skip direction Play back resumes from the selected track When the button is pressed once during play the previous track starts again When the gt gt button is pressed once during play the next track plays SEARCHING FOR A PASSAGE WITHIN A TRACK Keep the lt lt or PP button pressed during playback and release the button as soon as you recognise the desired passage Then normal CD playback will resume from this point GB 4 e CR3304 LENCO ENGLISH FM IM TCDO56 6 30 5 2009 12 45 16 REPEAT REPEAT ALL AND MIX PLAYBACK Press PLAY MODE button during stop mode CD plays with a single track repeat all tracks repeat or randomly FOR NORMAL COMPACT DISC PLAYBACK Mode sequence REPEAT gt gt REPEAT ALL gt gt gt gt CLEAR During Repeat2. normally Let it stand for 1 to 2 hours before turning the power on or gradually heat the room up and dry the unit before use Ensure a minimum distance of 5 cm around the apparatus for sufficient ventilation Ensure that the ventilation is not impeded by covering the ventilation openings with items such as newspapers table cloths curtains etc Do not place naked flame sources such as lighted candles on the apparatus Take attention to the environmental aspects of battery disposal Use the apparatus only in moderate climates not in tropical climates Do not expose the apparatus to dripping or splashing Do not place objects filled with liquids such as vases on the apparatus Should any trouble occur disconnect the AC power cord and refer servicing to qualified personnel The lightening flash with arrowhead symbol within the triangle is a warning sign alerting the user of dangerous voltage inside the unit CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION To reduce the risk of electric shock do not remove the cover There are no user serviceable parts inside the unit Refer all servicing to qualified personnel The exclamation point within the triangle is a warning sign alerting the user of important instructions accompanying the product In case of malfunction due to electrostatic discharge the apparatus has to be reset by disconnecting it from mains supply THE MARKING INFORMATION IS LOCATED AT THE BO
3. x 006P 3V 2 x AAA LRO3 1 5V 245 L x 207 D x 104 H mm 80 L x 76 D x 22 H mm 1 37KGS e Due to continuing improvement the features and the design are subject to change without notice Where to place the item Today s furniture is coated with a wide variety of lacquers and synthetic coatings that are treated with an extensive range of cleaning products Therefore the possibility that some of these substances contain components that react adversely to the rubber feet of the item and soften them cannot be completely excluded The rubber feet of the appliance can cause discoloring to furniture surfaces If necessary place the appliance on a non slide surface If at any time in the future you should need to dispose of this product please note that Waste electrical products should not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or retailer for recycling advice Waste Electrical and Electronic Equipment Directive i For information and support www lenco eu GB6 e CR3304 LENCO ENGLISH FM IM TCD058 8 30 5 2009 12 45 17
4. 1 mode display shows g l 9 During Repeat 2 mode During Mix mode display shows I display shows f Note CD R RW discs Because of non standardized format definition production of CD R RW playback quality and performance are not guaranteed Manufacturer is not responsible for the playability of CD R RW due to recording conditions such as performance writing software media ability etc Do not attach a seal or label to either side of the CD R RW disc It may cause a malfunction It is recommended to record only audio files on CD R RW discs for easy reading PROGRAMMED PLAYBACK PROGRAMMED PLAYBACK FOR NORMAL COMPACT DISC PLAYBACK Programmed playback enables tracks on a disc to be played in a desired order Up to 20 tracks can be programmed e 1 Press the PROGRAM button e 2 Press the NEXT and BACK buttons to select the desired track number 3 Press PROGRAM button again to memorize the track 4 Repeat steps 2 and 3 until all desired tracks are programmed ES 5 Press the PLAY PAUSE button to start p gt amp PROGRAM are shown on the display 6 Press STOP button to stop programmed playback 7T Press PROGRAM and PLAY PAUSE buttons to resume programmed playback 8 Open the CD door or turn off the CD player to clear the programmed memory Y MAINTENANCE CLEANING A CD CLEANING THE UNIT If the CD skips or will not play
5. E CLOCK TIME AND ALARM SETTINGS CAN BE PROTECTED AGAINST POWER FAILURE BY A 9V BATTERY NOT SUPPLIED IN THE EVENT OF A POWER FAILURE THE DISPLAY IS BLANK BUT THE CLOCK TIME AND ALARM SETTINGS ARE HELD IN MEMORY WHEN THE POWER INTER RUPTION ENDS THE DISPLAY APPEARS AGAIN DURING A POWER INTERRUPTION THE CLOCK TIME MAY GAIN OR LOSS A FEW MINUTES PER HOUR AND MAY REQUIRE RESETTING BATTERY INSERTION 1 REMOVE THE COVER OF THE BATTERY COMPARTMENT ON THE BOTTOM OF THE UNIT e 2 CONNECT A 9V BATTERY AN ALKALINE TYPE BATTERY IS RECOMMENDED TO THE e BATTERY TERMINAL INSIDE THE COMPARTMENT 3 PLACE THE CONNECTED BATTERY IN THE COMPARTMENT AND REPLACE THE COVER FOR OPTIMUM PERFORMANCE THE BATTERY SHOULD BE REPLACED EVERY 6 MONTHS REMOTE TEMPERTURE SENSOR 1 REMOVE THE FOUR SCREWS FROM THE BATTERY COMARTMENT WITH A SCREWDRIVER 2 INSTALL TWO 1 5V SIZE BATTERIES MATCHING POLARITIES SHOWN IN THE BATTERY COMPARTMENT 3 TIGHTEN THE SCREW NOTE FOR OPTIMUM THE BATTERY SHOULD BE REPLACED EVERY 10 MONTHS OR WHEN THE OUTDOOR READINGS CANNOT BE DISPLAYED PROPERLY THE CLOCK TO SET THE TIME 1 PRESS AND HOLD THE TIME SET BUTTON 2 PRESS THE HOUR BUTTON TO SET HOURS 3 PRESS THE MINUTE BUTTON TO SET MINUTES 4 RELEASE THE TIME SET BUTTON THE CORRECT TIME IS SHOWN ON THE DISPLAY GB 2 e CR3304 LENCO ENGLISH FM IM TCD054 4 30 5 2009 12 45 16 e TO WAKE TO THE MUSIC SLIDE THE ALARM S
6. HE BACK HANG THE REMOTE SENSOR ON THE WALL WITH THE SCREW UNIT STAND THIS UNIT INCORPORATES A STAND WHICH ALLOWS IT TO BE USED ONA TABLE OR OTHER FLAT SURFACE NOTE THE SURROUNDING BUILDING MATERIALS AND HOW THE MAIN UNIT AND REMOTE SENSOR ARE POSITION CAN INFLUENCE THE EFFECTIVE TRANSMISSION RANGE IT SHOULD BE PLACED AWAY FROM DIRECT SUNLIGHT RAIN OR SNOW HIGH POWER ELECTRICAL APPLIANCE AND STRONG MAGNETIC FIELD SUCH AS SPEAKERS OUTDOOR AFTER BATTERIES ARE INSTALLED THE REMOTE SENSOR WILL TRANSMIT THE OUTDOOR TEMPERATURE AT 15 SECONDS INTERVAL THE MAIN UNIT MAY TAKE UP TO 15 SECONDS TO RECEIVE THE INITIAL READINGS UPON GOOD SIGNAL RECEPTION THEN THE MAIN UNIT WILL AUTOMATICALLY UPDATE READINGS AT TWO MINUTES INTERVAL IF NO SIGNAL IS RECEIVED FROM THE REMOTE SENSOR AFTER 10 MINUTES THE OUTDOOR READINGS WILL NOT BE DISPLAYED PROPERLY YOU SHOULD PLACE THE REMOTE SENSOR CLOSER TO THE MAIN UNIT OR REPLACE THE BATTERIES GB3 e CR3304 LENCO ENGLISH FM IM TCD055 5 30 5 2009 12 45 16 THE RADIO RADIO OPERATION 1 PRESS THE POWER BUTTON TO TURN ON THE UNIT TURN THE RADIO OFF PRESS THE POWER BUTTON AGAIN pem 2 SET THE FUNCTION SWITCH TO SELECT THE FM ST OR 3 ADJUST THE TUNING CONTROL TO SELECT THE DESIRED RADIO STATION g 15 FM 4 ADJUST THE VOLUME CONTROL TO SET THE VOLUME TO THE DESIRED LEVEL COMPACT DISC PLAYBACK 1 SettoCD FUNCTION 2 Liftthe CD door up
7. TTOM OF APPARATUS e CR3304 LENCO ENGLISH FM IM TCDO52 2 30 5 2009 12 45 16 LOCATION OF CONTROLS e Main unit e 1 Sleep button 14 Next button P 2 Minute Button 15 Stop button BI 3 Time button 16 LCD alarm clock display 4 Alarm button 17 Speaker 5 Hour button 18 Alarm switch 6 Power button 19 Tuning control 7 CD Door 20 Temperture display 8 Snooze button 21 CD display 9 CD Door open close area 22 Battery compartment 10 Play Pause button Py 23 Volume control 11 Back button 44 24 Function switch 12 Play Mode button 25 Wire Antenna 13 Program button 26 230V power supply cable Remote temperture sensor 27 Hanger slot 28 Screw for mounting battery compartment 29 Battery compartment 30 Stand GB 1 e CR3304 LENCO ENGLISH FM IM TCDO53 3 30 5 2009 12 45 16 POWER SUPPLY OPERATION WITH AC POWER 1 PLEASE CAREFULLY CHECK THAT THE VOLTAGE INDICATED ON YOUR SET CORRESPONDS TO THE VOLTAGE OF YOUR LOCAL AREA 2 INSERT THE AC POWER CORD INTO AN AC OUTLET NOTE WHEN INSERTED A BACK UP BATTERY THE UNIT WILL CONSERVE THE SETTINGS DURING POWER OUTAGE THE DISCONNECT DEVICE SHALL REMAIN READILY OPERABLE POWER ON AND OFF PRESS THE POWER BUTTON TO TURN THE UNIT ON OR OFF ANTENNA FOR FM RECEPTION LAY OUT THE EXTERNAL FM WIRE ANTENNA AND ADJUST DIRECTION FOR OPTIMUM RECEPTION DO NOT CONNECT THIS WIRE TO ANY OUTDOOR ANTENNA FITTING THE BATTERIES BATTERY BACKUP TH
8. WITCH TO THE AUTO POSITION THE SYMBOL IS SHOWN ON THE DISPLAY AND ADJUST THE VOLUME CONTROL TO THE LISTENING LEVEL YOU WANT SELECT THE WAKE UP SOURCE BY SLIDING THE FUNCTION SWITCH TO FM ST FM MONO CD INTHE RADIO MODE THE SELECTED RADIO STATION WILL PLAY INTHE CD MODE THE DISC LOADED IN THE CD COMPARTMENT WILL PLAY IF NO BUTTON IS PRESSED ALARM WILL LAST FOR 2 HOURS WAKE TO ALARM TO AWAKEN BY ALARM SET THE ALARM SWITCH TO THE BUZZER POSITION THE SYMBOL IS SHOWN ON THE DISPLAY SNOOZE REPEAT ALARM WHEN THE ALARM SOUNDS RADIO BUZZER AT THE PRESET TIME YOU CAN TURN OFF THE SOUND TEMPORARILY BY PRESSING THE SNOOZE BUTTON THE SYMBOL 27 15 SHOWN ON THE DISPLAY THE ALARM WILL SOUND AGAIN WITHIN 9 MINUTES THIS CYCLE CAN BE REPEATED FOR UP TO ONE HOUR TO STOP ALARM CD RADIO BUZZER SIMPLY SET THE ALARM SWITCH TO OFF OR PRESS THE ALARM BUTTON THE SYMBOL DISAPPEAR ON THE DISPLAY SLEEP FUNCTION 1 TOFALL ASLEEP WHILE LISTENING TO MUSIC PRESS THE SLEEP BUTTON THE SYMBOL 15 SHOWN ON THE DISPLAY 2 TOADJUST THE RADIO S SLEEP FUNCTION TO PLAY FROM 90 60 30 TO 15 MINUTES OF MUSIC BEFORE SHUTTING ITSELF OFF AUTOMATICALLY e REMOTE TEMPERTURE SENSOR e INSTALL THE REMOTE TEMPERTURE AFTER INSTALLING THE BATTERIES POSITION THE REMOTE SENSOR TO DESIRED OUTDOOR LOCATION WITHIN THE EFFECTIVE TRANSMISSION RANGE OF 15 METRE IT CAN BE MOUNTED ON THE WALL BY USING THE HANGER SLOT AT T
9. e Lenco CD RADIO ALARM CLOCK with remote temperature sensor CR 3304 INSTRUCTION MANUAL C For information and support www lenco eu e CR3304 LENCO ENGLISH FM IM TCDO51 1 30 5 2009 12 45 16 CLASS 1 LASER PRODUCT Warning Do not touch the lens CLASS 1 LASER PRODUCT APPAREIL A LASER DE CLASSE 1 CAUTION PRODUCTO LASER DE CLASE 1 DEFEATED AVOID EXPOSURE TO BEAM This product contains a low power laser device DO NOT THROW BATTERIES IN FIRE PRECAUTIONS INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCKS Follow the advice below for safe and appropriate operations ON PLACEMENT Do not use the unit in places which are extremely hot cold dusty or humid Place the unit on a flat and even surface Do not restrict the air flow of the unit by placing it in a place with poor air flow by covering it with a cloth or by placing it on a carpet ON SAFETY When connecting and disconnecting the AC cord grip the plug and not the cord itself Pulling the cord may damage it and create hazard When you are not going to use the unit for a long period of time disconnect the AC power cord ON AC VOLTAGE e Before use check that the rated voltage of your unit matches your local voltage ON CONDENSATION When left in a heated room where it is warm and damp water droplets or condensation may form inside the CD player When there is condensation inside the unit the unit may not function
10. the disc may need cleaning Do not use volatile chemicals on this unit Clean by lightly Before playing wipe the disc from the centre out with a wiping with a soft cloth cleaning cloth After playing store the disc in its case IMPORTANT NOTE If an abnormal display indication or an operating problem occurs disconnect the AC power cord and remove the batteries Wait at least 5 seconds then reconnect the AC power cord or reinstall the batteries CLEANING THE CD LENS WARNING If the CD lens is dusty clean it with a brush blower Blow Should the CD door be opened before the reading of the CD several times on the lens and remove the dust with the is completed a jamming noise may occur This is resolved brush Finger prints may be by closing the CD door removed with a cotton swab moistened with alcohol GB5 e CR3304 LENCO ENGLISH FM IM TCD057 7 30 5 2009 12 45 16 SPECIFICATIONS CD SECTION Channels S N ratio Wow amp Flutter Sampling frequency Quantization Pick up light source Pick up wave length RADIO SECTION Tuning ranges Antennas GENERAL Output power Power consumption Speaker Power source Remote sensor Dimensions Main unit e Remote temperature sensor Weight 2 channels 60 dB undetectable 44 1 kHz 8 x over sampling 1 bit DA converter Semi conductor laser 790 nm FM 87 5 108 MHz FM Wire Antenna 1W 1W RMS 12 5W 2 8 OHM AC 230V 50Hz DC 9V backup 1
Download Pdf Manuals
Related Search