Atdec V-FS-Q flat panel desk mount
Contents
1. Screw A s 5mm Allen Key Repeat steps B 1 B 2 and B 3 TIGHTEN for the 2nd set of Horizontal FIRMLY _ Support and Donut Clamp Adjust Donut Clamps Follow steps below to adjust the position of Donut Clamps Ensure the Cable Slots IMPORTANT in all the Poles are facing to the rear When tightening the Donut C 1 C 2 C 3 Clamp each of the Donut Loosen Donut Bolts evenly Slide the Donut Clamp to Tighten Donut Bolts firmly bolts must be tightened using the supplied 5mm desired position using the supplied 5mm Allen Key Allen Key evenly as failure to do so will damage the Donut Clamp Do not over tighten as this may also result in damage J LOOSEN PD Mount Displays Choose the correct Mounting Screws supplied in the bits Insert display cables into the slots in each pole using box and attach the display as shown Cable Balls to hold them in place Note When the slot in each pole cannot be used use Note Extension the supplied Cable Clip s to secure the display cables Clips are included to suit VESA 100mm x 100mm 4 x 4 Mounting Hole ON SiN a Patterns Adjust the Ball Joint Mechanism to suit the 2 5mm EN weight of your display LOOSEN Allen Key TIGHTEN Tighten or loose2. Important Notes Each Donut Clamp Assembly supports a maximum weight of 11 5kg 25lbs This product suits VESA compliant displays with 75mm x 75mm 3 x 3 and 100mm x 100mm 4 x 4 mounting hole patterns The manufacturer does not accept responsibility for incorrect installation Bits Box _ Oo D M8x50mm Cable Extension eT Ball x8 Clip x4 Clip x16 x 2 5mm Allen Mounting Screws REIN Gm M4x10mm x16 M4xl2mm x16 ww M4xl mm x16 d TOOLS REQUIRED oe NE Allen Support Donut x1 Phillips Head Screw Driver Key x1 A Attach Upright Pole to Base Install Horizontal Support and Donut Clamp Attach the Upright Pole to the Base Follow steps below to attach the Horizontal Support and Donut Clamp as shown below Ensure the Cable assembly onto the Upright Pole Ensure the Cable Slots in all the Poles are Slot faces towards the rear facing to the rear B 1 Loosen the Hex screws in the Horizontal Support Donut using the supplied 5mm Allen Key B 2 Slide the Horizontal Support to desired position B 3 Tighten supports firmly Upright Pole using the supplied 5mm IMPORTANT Allen Key When tightening the Donut Clamp each of the Donut bolts must be Cable Slot tightened evenly as failure to do so b TIGHTEN will damage the Donut Clamp Do STAN not over tighten as this may also result TIGHTEN in damage M8x50mm
3. n screws evenly with the 3 supplied 2 5mm Allen Key 1 4 turn at a time Lf Note Ensure enough slack is left in cables to allow for movement As LCD Manufacturers are constantly releasing new monitor models Atdec does not accept responsibility it the mounting hole pattern does not comply with the international VESA standards Due to continuing product development the manufacturer reserves the right to alter specifications without notice Published 29 08 07
Download Pdf Manuals
Related Search