Philips Clock Radio AJ3121
Contents
1. Extend and position the pigtail fully to obtain optimal reception MW uses a built in antenna inside the set Direct the antenna by adjusting the position of your set SETTING THE CLOCK ALARM TIME The time is displayed using the 24 hour clock 1 2 3 Hold down SET TIME ALARM SET Press HR or MIN repeatedly or hold down HR or MIN to adjust minute and or hour Release SET TIME ALARM SET and HR or MIN when you reach the correct setting The set clock time will show on the display and start to run SELECTING THE ALARM MODE To use the alarm you must set the alarm time first You can choose from two different alarm modes to wake you up by radio or buzzer 1 Select your choice of alarm mode by adjusting RADIO ALARM to RADIO or BUZZER The alarm indicator AL will light up Helpful Hint e f you have selected the radio mode make sure you have adjusted the vol ume loud enough to wake you e The buzzer is set at a fixed volume and cannot be adjusted SWITCHING OFF THE ALARM There are three ways of switching off the alarm Unless you cancel the alarm completely the 24 hour alarm reset option will be automatically selected after 59 minutes from the time your alarm time first goes off 24 HOUR ALARM RESET If you want the alarm mode to be stopped immediately but also wish to retain the same alarm setting for the following day e Press ALARM RESET during the alarm call The alarm indicator AL2. Clock Radio AJ3121 User manual Manuel d utilisation Manual del usuario Benutzerhandbuch PHILIPS English CONTROLS see fig 1 SET TIME ALARM SET sets the clock time sets the alarm time HR MIN adjusts the hours minutes for clock alarm sleep time REPEAT ALARM SLEEP OFF switches off the active alarm for a 9 minutes period switches off the radio sleep function ALARM RESET stops the active alarm for 24 hours SLEEP activates the radio for sleep function adjusts the sleep period TUNING tunes to radio stations ALARM indicator lights up when alarm is activated FM MW selects FM MW waveband VOLUME adjusts the sound level RADIO ALARM OFF switches off the radio alarm RADIO ON switches on the radio ALARM RADIO activates the radio for alarm ALARM BUZZER activates the buzzer for alarm o Power cord connects to wall outlet 2 Pigtail improve FM reception me Battery door opens to store a 9 volts 6F22 battery not included for clock memory backup INSTALLATION POWER SUPPLY 1 Check if the power supply as shown on the type plate located on the bot tom of the set corresponds to your local power supply If
3. RNING Under no circumstances should you try to repair the set yourself as this will invalidate the warranty Do not open the set as there is a risk of electric shock Problem Possible Cause e Remedy No sound power Volume not adjusted e Adjust the volume Occasional crackling sound during FM broadcast Weak signal e Adjust the position of the Pigtail Continuous crackling hiss disturbance during MW broadcast Electrical interference from TV computer fluorescent lamp etc e Move set away from other electrical equipment The alarm does not function Alarm time not set and or alarm mode not selected e Set the alarm time and select alarm mode Volume too low for RADIO e Adjust the volume Radio alarm not adjusted to radio station e Tune to a radio station ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials paper and cardboard Your set consists of materials which can be recycled if disassembled by a special ized company Please observe local regulations on the disposal of packing materi als and old equipment Disposal of your old product Your product is designed and manufactured with high quality materials and com ponents which can be recycled and reused When this crossed out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002 96 EC Please inform yourself ab
4. draw the power plug rom the wall outlet In addition to this it is advisable to remove the battery rom the clock radio This will prevent any danger of leakage and the clock radio will not be damaged Do not expose the set batteries to humidity rain sand or excessive heat caused by heating equipment or direct sunlight e The apparatus shall not be exposed to dripping or splashing e Adequate ventilation with a minimum gap of 15cm between the ventilation holes and surrounding surfaces is necessary to prevent heat build up e The ventilation should not be impeded by covering the ventilation openings with items such as newspapers table cloths curtains etc e No objects filled with liquids such as vases shall be placed on the appartus e No naked flame sources such as lighted candles should be placed on the apparatus e To clean the set use a soft slightly dampened chamois leather Do not use any cleaning agents containing alcohol ammonia benzene or abrasives as hese may harm the housing CAUTION Use of controls or adjustments or performance of procedures other than herein may result in unsafe operation This set complies with the radio interference requirements of the European Community TROUBLESHOOTING If a fault occurs first check the points listed below before taking the set for repair If you are unable to remedy a problem by following these hints consult your dealer or service center WA
5. it does not consult your dealer or service center Connect the power cord to the wall outlet 3 To disconnect the set from the power supply completely remove the plug from the wall outlet N For users in the U K please follow the instructions on the lower left handed corner of the sheet CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to a day when there is a power interruption e g power failure The com plete clock radio and display illumination will be switched off As soon as the power supply returns the display will indicate the correct time 1 Remove the battery door to insert a 9 volts 6F22 type battery not included for backup 2 Replace the battery door NOTE If no backup battery is installed or the power interruption is prolonged you will need to set the clock and alarm times again Batteries contain chemical substances so they should be disposed of properly Standby power COMSUMPTION vsin a A 1 8W RADIO You can use this set solely as a radio D R O N ra Adjust RADIO ALARM to RADIO ON to switch on the radio Select your waveband by adjusting the FM MW switch Adjust TUNING to tune to your desired station Turn the VOLUME control to adjust the volume level Adjust RADIO ALARM to OFF to switch off the radio When sleep function is activated to switch off the radio you also need to press SLEEP OFF button To improve reception FM
6. out the local separate collection system for electrical and electronic products Please act according to your local rules and do not dispose of your old products with your normal household waste The correct disposal of your old product will help prevent potential negative consequences for the environment and human health Bt Tex T ene PHILIPS Meet Philips at the Internet http www philips com we AJ3121 Printed in China PDCC JH ZC 0716
7. will remain on CANCELING THE ALARM COMPLETELY To cancel the set alarm time before it goes off or during the alarm call e Adjust RADIO ALARM to OFF position gt The alarm indicator AL will light off REPEAT ALARM This repeats your alarm call at 9 minute intervals 1 During the alarm call press REPEAT ALARM 2 Repeat if desired for up to 59 minutes The alarm indicator SLEEP This set has a built in AL will remain on imer which enables the set to be automatically switched off during radio playback after a set period of time This allows you to lie back listen and fall asleep Setting SLEEP Set RADIO ALARM to OFF position 1 2 he maximum sleep time is 1 hour and 59 minutes Set the sleep time ways Simply press SLEEP to set your sleep time to 59 minutes o activate sleep function by selecting on the following Hold down SLEEP and press MIN repeatedly to adjust sleep time from 59 minutes downward Hold down SLEEP and press HR to get one more hour sleep time 1 59 To cancel sleep press SLEEP OFF SAFETY INFORMATION e Install the unit near the AC outlet and where the AC power cord plug can be easily reached e Where the MAINS plug or an appliance coupler is used as the disconnect device the disconnet device shall remain readily operable e Place the set on a hard and flat surface so that the system does not tilt e f you do not intend to use the set for a long time with
Download Pdf Manuals
Related Search