FlashlightDVR™ - MCM Electronics
Contents
1. OQ Swann FlashlightDVR USER MANUAL SW244 TDV Before You Begin READ THESE INSTRUCTIONS BEFORE USE AND RETAIN FOR FUTURE REFERENCE WARNING Important notice about correct usage of the power adapter The correct orientation for the enclosed power adapter is in a vertical or floor mount position FCC WARNING STATEMENT This device complies with Part 15 of FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation Important Notice All jurisdictions have specific laws and regulations regarding the use of cameras Before using any camera for any purpose it is the buyer s responsibility to be aware of all applicable laws and regulations that prohibit or limit the use of cameras and to comply with the applicable laws and regulations The legality of watching people other than yourself changes from country to country and even state to state Contact your local government s privacy information body or your local Police for more information on what if any restrictions you may face Technical Support owann Technical Support is available for any inquiries you may have Website www swannsecurity com USA Canada 1 800 627 2799 1 877 274 3695 Australia 1300 13 8324 Email tech swann com au Introduction Thank you for purchasing the Swann Flashlight2. 7 mm nm n LII i lf you want to quit snapshot mode Press and hold the button for 2 seconds to return to Time display Ciel f Ua 1 M S NOTE When taking photos at night ensure the flashlight level is set to off in order for infrared LEDs to turn on Taking photos with the light on will overexpose the image and appear as a white image 6 Video Audio Recording To enter the video audio recording mode press and hold button for 2 seconds The LCD will display the SD Card data indicator and will flash for approximately 10 seconds After the data indicator disappears the unit enters the video audio recording mode with LCD displaying as below REC riri riri LILI LILI Point the FlashlightDVR at an object and then press the button to start the video audio recording The data indicator will flash under the SD logo m TL ni LILI LILI Once the data indicator disappears the video will begin to record and the timer will start counting 10 Press the button to stop a video audio recording The data indicator will flash while the data is writing to the SD Card The time display indicates the duration of the video audio recorded For example the below figure indicates 10 minutes 3 seconds of video audio has been recorded You can press button again to start another video audio recording or press and hold button for 2 seconds to exit video mode and return to time display mode IX Connecting
3. DVR This manual details the operation of the product Please read it carefully and keep it for future reference The Swann FlashlightDVR is an innovative ALL IN ONE PORTABLE solution for Flashlight Camera and Digital Video Recorder It is ideal for instant MPEG4 Video Recording for Security Applications Il Features High powered White LED flashlight Highly Durable with precision tooled aluminum housing Compact size and portable DVR System Support up to 2GB external Mini SD Card flash storage MPEG4 Video Recording Support 1 5 Hours VGA recording with 1 GB Mini SD card Built in CMOS Color VGA Sensor 640x480 Night Vision support Backup using USB1 1 compatible interface Easy operation with one touch control LCD Status Display with backlight Clock Display Built in Ni MH Charger 12V input Ill Package Contents 1 x FlashlightDVR 1 x USB Cable 1 x User Manual 1 x 12V AC DC Adaptor for Charging 1 x Charger for Cigarette Adapter IV FlashlightDVR Layout CONTROL PANEL LCD DISPLAY Y CAMERA N MICROPHONE Bev p eee TAY Boy BATTERY COMPARTMENT IRLED SD CARD SLOT USB Pa OUTLET AND DC 12V INPUT REFLECTOR LIGHT EMITTING COMPONENT FLASHLIGHT ASSEMBLY DEVICE V Before Use Remove the end cap of the FlashlightDVR and install 3 C size Ni MH rechargeable batteries or 3 C size alkaline batteries not included Tighten the
4. aults to OFF mode Press Flashlight button repeatedly to cycle through the various brightness levels Low Medium High C op Using a Mini SD Card The FlashlightDVR supports 128MB to 2GB Mini SD Cards When the Mini SD Card is installed the unit will automatically select the Mini SD Card as the storage media If Mini SD Card is not installed the unit will use the internal 100MB out of 128MB memory for Video and Snapshot storage Insert the Mini SD card into the Min SD card slot as shown below Please make sure the orientation of Mini SD card is correct rN MINI SD CARD SLOT 4 E MINI SD Z CARD USB SOCKET 12 VOLT DC INPUT FOR BATTERY CHARGING 5 Snapshot Mode To enter the snapshot mode press and hold the button for 2 seconds The LCD will display the SD Card data indicator and flash for approximately 10 seconds After the data indicator disappears the unit enters snapshot mode with the LCD displaying 0 as below REC riri riri NN NN Point the camera to the object and then press button to take a photo The data indicator will flash under the SD logo M dmi REC 1171 ri MIN LUI Once the DVR has finished processing the image a number 1 will appear under HEC indicating 1 picture has been saved REC Fi FW nm LII LIL LIN Press button again to take a second picture The data indicator will flash and HEC will indicate 2 pictures have been stored Ad l
5. e batteries or dispose batteries in fire for risk of physical injury Do not use batteries with varying voltages or charge as it may damage the unit DO NOT disassemble the unit DO NOT charge the unit in high temperatures If there is a problem with the unit contact Swann Technical Support for assistance 13 APPENDIX Product Specification FlashlightDVR Built in Cool White 3Watt LED 3 Levels of Brightness Shut Down at 80 Degree C Color CMOS Sensor 300K pixels ensor Resolution VGA 640 x 480 Automatic White Balance Automatic 17pcs 850nM At OLux IR Effective Distance Maximum 4 Meter MPEG 4 MP4 128MB Mini SD Card Supports Up to 2GB TN LCD display Maximum 18 minute 128MB VGA Maximum 1 5 Hours for 1G SD Card Compliant with USB1 1 Interface IR LED Camera Torch J im z 21210 21 5 Um Olo mi e 3 2 5 19 01515152 28 lt 55 lt 0 2 0 0 13 15 S Va 5 lt 5 20 2 gt 5 2 He dae 3 gt 2 5 5 ex T1219 o 5 lt 3 5 lt 3 o lt DVR Maximum Image Transfer Rate 30 fps Audio Input Built In Microphone Audio Engine Single Channel 16 bit ADC Gain 35 25dB Adaptor 12VDC Ni MH 3 x size rechargeable battery harging Input Voltage ull Charge Protection 6 Hour T
6. end cap after installing the batteries 3 x C SIZE ALKALINE BATTERY OR 3 x C SIZE 3000mAH Ni MH RECHARGEABLE BATTERY VI FlashlightDVR Control Panel There are 4 buttons on the control panel as below LL REC SNAPSHOT FLASHLIGHT FUNCTION 1 Flashlight button 2 Function button 3 Record button A 4 Snapshot button 7 VII LCD Display STORAGE CAPACITY INDICATOR DATA INDICATOR RECORDING SD INDICATOR BATTERY CARD INDICATOR oy Wut 17 I II Y H M USB D S DATE TIME DISPLAY HOUR USB STATUS YEAR MONTH MINUTE DATE SECOND Modes of Operation 1 Time Date Setup When batteries are installed in the unit the Time Display Mode appears as shown below imi Ua 5j 1 1 H M S A Date Display Press Function button to enter Date Display mode By default 2007 January 01 will display as below V lt Vtig Vit mit Lit LIU M D Press the Function button again to go back to Time Display mode B Time Adjustment In Time Display mode hold the Function button for 2 seconds to enter the Time edit mode The number indicating Hour will flash and can be edited using 4 and v buttons Press 4 button will increase the number by 1 while press v button will decrease by 1 Press the Function button to move to change the Minutes Use the and v buttons to change the minutes Press the Function button to edit the Seconds Once all adju
7. imer 3 x C size battery Alkaline or Ni MH rechargeable Below 7Watt 10 to 35 Degree C 20 95 Non Condensation Weight 520 grams Without Battery Dimensions 79 W x97 H x 323 L mm Weather Proof le o Weg
8. nect the USB cable from the FlashlightD VR ij Safe To Remove Hardware x The USE Mass Storage Device device can now be safely Recycle Bin removed from the system Battery Charging The 12V AC DC Adapter is used for charging Ni MH rechargeable batteries only When charging the FlashlightDVR will display only the time date NOTE When there are no batteries inside the housing DO NOT connect the 12 Volt AC DC adaptor to FlashlightDVR Unscrew the end cap and insert 3 C Size Ni MH Rechargeable batteries Tighten the end cap to the housing Connect the 12 Volt AC DC adapter as shown right The LCD display will appear as Charge 12 When Charge disappears the battery indicator will appear showing the amount of charge jet nl d 6 Cpe tt te tt imi mild d UU 5j 1 UU teh 1 UU 241 nj 1 1 H M S H M S H M S 1 md nV t U LI te Ll H M S The FlashlightDVR will automatically stop charging after 6 hours or internal temperature reaches 80 degrees Celsius When the battery is full the battery indicator will stop rolling and will appear as full charge IMPORTANT f the battery indicator shows no or low charge please recharge or replace batteries immediately Cautions for Use Only use the included 12Volt AD DC adaptor when using Ni MH rechargeable batteries DO NOT charge the unit when using alkaline batteries DO NOT bend unit DO NOT short circuit bend deform th
9. stments are complete press the Function button to save all changes and return to Time Display Mode C Date Adjustment When viewing the date press and hold the Function button for 2 seconds to enter the Date edit mode The number indicating the Year will flash and can be changed using a and buttons Press a button will increase the number by 1 while press v button will decrease by 1 Press the Function button to change to Month edit Use the arrows as above Press the Function button again to change to Day edit and use the arrows to adjust When you have finished making changes press the Function button again to save and exit Date Adjustment mode 2 Battery Indicator The battery indicator appears in the upper left area of 8 the display When the indicator is empty the 1 mi FlashlightDVR will no longer function properly and UL 541 541 requires charging or battery replacement if using H M S alkaline batteries One bar indicates the batteries are low and require 5 charging or replacement as soon as possible Iai Vd 11 it H M S The battery level is normal and will have 2 slots lit up 1 1 mi li onthe Battery Indicator 11 It H M S fnm A full Battery Indicator indicates the battery is fully n i 5 i charged and ready for use us o 3 Flashlight 4 The unit has 3 levels of brightness Low Medium and High When batteries are installed in the unit the flashlight def
10. the FlashlightDVR to PC Connection to PC Connect the USB cable to your PC USB port Connect the mini plug end of the cable to the FlashlightDVR mini USB port as shown at right A popup window will display the Found new hardware message and the system will automatically install the corresponding driver Once the installation is complete Removable Disk will appear in the My Computer folder E My Computer File Edit View Go Favortes Help di Lut Copy Paste 3 Floppy amp Setup a c S Removable Printers Control Panel Dial Up Disk F Networking User D Select an item to view Its z description 9 Scheduled Web Folders Tasks a Computer When connected the FlashlightDVR will show USB on the LCD panel USB Upload Download Files Data can be copied from the Mini SD card to a hard drive Data can also be copied moved and deleted Note FlashlightDVR features are disabled while connected to PC Disconnect from PC Do not disconnect the USB cable before performing the following Left click on the Remove Hardware icon located in the System Tray A window containing a list of the USB devices will appear Left click on Safely Remove Mass Storage Device associated with your FlashlightDVR V Uu 9 23AM When the Safe To Remove Hardware message box appears unplug the USB cable from your computer Then discon
Download Pdf Manuals
Related Search