Sun Storage J4200/J4400 Array Disk Drive Replacement Guide
Contents
1. 4 Align the new disk drive with the open slot and slide the drive into the disk tray 5 Push the disk drive into the tray slot until the disk ejection lever engages the tray connectors and begins to swing closed 4 Sun Storage J4200 J4400 Array Disk Drive Replacement Guide April 2008 6 Press the disk ejection lever closed until it locks in place to seat the drive and lock it into the tray FIGURE 3 Inserting a Disk Drive in a J4400 Array Disk Tray 7 After the disk drive is locked in place the Activity LED will be steady green to indicate a ready state V Verify and Complete the Disk Drive Replacement Verify the Activity LED is steady green Removing and Replacing a Disk Drive 5 6 Related Documentation For additional information about the Sun Storage J4200 J4400 Array see the following product documentation Application Title Part Number Regulatory and safety information Multilanguage safety information Site planning information Installation at a glance Installation at a glance Complete details of the hardware components rail and tray installation and cabling Late breaking information not included in the information set Installation and use of the management software using a GUI Installation and use of the management software using a CLI General operation and troubleshooting Disk drive replacement procedures SIM board replacement2. procedures SIM board replacement procedures Power supply replacement procedures Sun StorageTek Regulatory and Safety Compliance Manual Important Safety Information for Sun Hardware Systems Sun Storage J4200 J4400 Array Site Preparation Guide Sun Storage J4200 Array Setup Poster Sun Storage J4400 Array Setup Poster Sun Storage J4200 J4400 Array Hardware Installation Guide Sun Storage J4200 J4400 Array Release Notes Sun StorageTek Common Array Manager User Guide for the J4000 Array Family Sun StorageTek Common Array Manager CLI Guide for the J4000 Array Family Sun Storage J4200 J4400 Array Overview Sun Storage J4200 J4400 Array Disk Drive Replacement Guide Sun Storage J4200 Array SIM Board Replacement Guide Sun Storage J4400 Array SIM Board Replacement Guide Sun Storage J4200 Array Power Supply Replacement Guide 96272 Revision A 816 7190 nn 820 3219 nn 820 3221 nn 820 4691 nn 820 3218 nn 820 3222 nn 820 3765 nn 820 4419 nn 820 3223 nn 820 3225 nn 820 3226 nn 820 4600 nn 820 3227 nn Sun Storage J4200 J4400 Array Disk Drive Replacement Guide April 2008 Application Title Part Number Fan replacement procedures Sun Storage J4200 Array Fan Replacement 820 3229 nn Guide Power supply and fan Sun Storage J4400 Array Power 820 3228 nn replacement procedures Supply Fan Replacement Guide Chassis replacement Sun Storage J4200 Chassis Replacement 820 4413 nn procedur
3. 0 J4400 Array Disk Drive Replacement Guide April 2008 Removing and Replacing a Disk Drive This document describes replacement procedures for the disk drive customer replaceable unit CRU installed in the Sun Storage J4200 and J4400 Arrays This document assumes you have m Identified the disk tray containing the failed disk drive m Received the replacement disk drive This product is intended for restricted access whereby access is controlled through the use of a means of security for example key lock tool or badge access and personnel authorized for access have been instructed on the reasons for the restrictions and any precautions that need to be taken ESD Precautions When performing this service action observe the following electrostatic discharge ESD precautions m Remove all plastic vinyl and foam material from the work area m Wear an antistatic wrist strap at all times when handling any CRU m Before handling any CRU discharge any static electricity by touching a grounded surface m Do not remove a CRU from its antistatic protective bag until you are ready to install it m After removing a CRU from the cabinet immediately place it in an antistatic bag or antistatic packaging m Handle any card that is part of a CRU by its edges only and avoid touching the components or circuitry Removing and Replacing a Disk Drive 1 m Do not slide a CRU over any surface m Limit body movement which buil
4. S PH UN microsystems Sun Storage J4200 J4400 Array Disk Drive Replacement Guide Sun Microsystems Inc www sun com Part No 820 3225 11 April 2008 Revision A Submit comments about this document at http www sun com hwdocs feedback Copyright 2008 Sun Microsystems Inc 4150 Network Circle Santa Clara California 95054 U S A All rights reserved Sun Microsystems Inc has intellectual property rights relating to technology fiat is described in this document In particular and without limitation these intellectual property rights may include one or more of the U S patents listed at http www sun com patents and one or more additional patents or pending patent applications in the U S and in other countries This document and the product to which it pertains are distributed under licenses restricting their use copying distribution and decompilation No part of the product or of this document may be reproduced in any form by any means without prior written authorization of Sun and its licensors if any Third party software including font technology is copyrighted and licensed from Sun suppliers Parts of the one may be derived from Berkeley BSD systems licensed from the University of California UNIX is a registered trademark in the U S and in other countries exclusively licensed through X Open Company Ltd Sun Sun Microsystems the Sun logo AnswerBook2 docs sun com and Solaris are trademarks or registered tradem
5. The Activity LED is off and the ID Status LED is blue indicating that data is not being transferred to or from the disk and that the disk drive is ready to remove Caution Potential loss of data access Data might be lost if an active disk drive is removed If you remove an active disk drive accidentally wait at least 30 seconds before reinserting it 2 Press the release button in and to the right to release the disk ejection lever 3 Pull the disk ejection lever fully open to unlock and partially eject the disk drive from the tray 4 Grasp the middle of the disk drive body and pull it toward you to remove it from the tray Removing and Replacing a Disk Drive 3 FIGURE 2 Removing a Failed Disk Drive From a J4200 Array Disk Tray Caution For products with multiple power cords all power cords must be disconnected to completely remove power from the system V Replacing a Disk Drive Caution Follow all ESD precautions see ESD Precautions on page 1 and use care When handling either the new or failed disk drive 1 Unpack the new disk drive and do one of the following m Place the failed disk drive in the packing materials so that you can return it to Sun for proper disposal m Properly dispose of the failed disk drive 2 Ensure the new disk drive is the same type and same capacity as the failed disk drive 3 Ensure the disk ejection lever is in the fully extended position see FIGURE 3
6. arks of Sun Microsystems Inc in the U S and in other countries All SPARC trademarks are used under license and are trademarks or registered trademarks of SPARC International Inc in the U S and in other countries Products bearing SPARC trademarks are based upon an architecture developed by Sun Microsystems Inc The OPEN LOOK and Sun Graphical User Interface was developed by Sun Microsystems Inc for its users and licensees Sun acknowledges the pioneering efforts of Xerox in researching and developing the concept of visual or graphical user interfaces for the Sop anes industry Sun holds a non exclusive license from Xerox to the Xerox Graphical User Interface which license also covers Sun s licensees who implement OPEN LOOK GUIs and otherwise comply with Sun s written license agreements U S Government Rights Commercial use Government users are subject to the Sun Microsystems Inc standard license agreement and applicable provisions of the FAR and its supplements DOCUMENTATION IS PROVIDED AS IS AND ALL EXPRESS OR IMPLIED CONDITIONS REPRESENTATIONS AND WARRANTIES INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY FITNESS FOR A PARTICULAR PURPOSE OR NON INFRINGEMENT ARE DISCLAIMED EXCEPT TO THE EXTENT THAT SUCH DISCLAIMERS ARE HELD TO BE LEGALLY INVALID Copyright 2008 Sun Microsystems Inc 4150 Network Circle Santa Clara Californie 95054 Etats Unis Tous droits r serv s Sun Microsystems Inc a les droits de p
7. ds up static electricity during the removal and replacement of a CRU 2 Disk Drive Components Caution Only trained service personnel should remove the covers on this equipment FIGURE 1 illustrates the location of the disk drive components and LEDs FIGURE 1 Disk Drive Components SAS 300GB 15k RPM Figure Legend 1 Release button 2 Disk Ejection Lever 3 Activity LED 4 Locator Status LED Sun Storage J4200 J4400 Array Disk Drive Replacement Guide April 2008 gt gt op Removing and Replacing a Disk Drive Caution The power supplies in this equipment can produce high energy hazards Only trained personnel with authorized access to this equipment should remove and replace modules in the system This section describes how to remove and replace a disk drive Caution The replacement disk drive must be the same capacity and same type as the disk drive it is replacing Caution Never remove a disk drive unless the ID Status LED is blue see FIGURE 1 If you need to remove multiple disk drives always remove and replace one disk drive at a time Note The disks are hot swappable and you do not need to disconnect power from the system or other components in order to replace one of these parts Removing a Disk Drive 1 From the front of the disk tray locate the failed disk drive see FIGURE 2
8. es Guide Chassis replacement Sun Storage J4400 Chassis Replacement 820 4601 nn procedures Guide Rail kit installation Sun Storage J4200 J4400 Array Rail Kit 820 3764 nn procedures Installation Guide Service Contact Information If you need help installing or using this product in the United States call 1 800 USA 4SUN 872 4786 or go to http www sun com service contacting index xml Removing and Replacing a Disk Drive 8 Sun Storage J4200 J4400 Array Disk Drive Replacement Guide April 2008
9. marques d pos es de SPARC International Inc aux Etats Unis et dans d autres pays Les produits portant les marques SPARC sont bas s sur une architecture d velopp e par Sun Microsystems Inc L interface d utilisation graphique OPEN LOOK et Sun a t d velopp e par Sun Microsystems Inc pour ses utilisateurs et licenci s Sun reconna t les efforts de pionniers de Xerox pour la recherche et le d veloppement du concept des interfaces d utilisation visuelle ou graphique pour l industrie de l informatique Sun d tient une license non exclusive de Xerox sur l interface d utilisation grephigue Xerox cette licence couvrant galement les licenci es de Sun qui mettent en place l interface d utilisation graphique OPEN LOOK et qui en outre se conforment aux licences crites de Sun LA DOCUMENTATION EST FOURNIE EN L TAT ET TOUTES AUTRES CONDITIONS DECLARATIONS ET GARANTIES EXPRESSES OU TACITES SONT FORMELLEMENT EXCLUES DANS LA MESURE AUTORISEE PAR LA LOI APPLICABLE Y COMPRIS NOTAMMENT TOUTE GARANTIE IMPLICITE RELATIVE A LA QUALITE MARCHANDE A VAPTITUDE A UNE UTILISATION PARTICULIERE OU A L ABSENCE DE CONTREFA ON EG 198 ca Adobe PostScript Contents Removing and Replacing a Disk Drive 1 ESD Precautions 1 Disk Drive Components 2 Removing and Replacing a Disk Drive 3 v Removing a Disk Drive 3 v Replacing a Disk Drive 4 v Verify and Complete the Disk Drive Replacement 5 Related Documentation 6 iv Sun Storage J420
10. ropriete intellectuels relatants la technologie qui est d crit dans ce document En particulier et sans la limitation ces droits de propri t intellectuels peuvent inclure un ou plus des brevets am ricains num r s http www sun com patents et un ou les brevets plus suppl mentaires ou les applications de brevet en attente dans les Etats Unis et dans les autres pays Ce produit ou document est prot g par un copyright et distribu avec des licences qui en restreignent l utilisation la copie la distribution et la d compilation Aucune partie de ce produit ou document ne peut tre reproduite sous aucune forme par quelque moyen que ce soit sans l autorisation pr alable et crite de Sun et de ses bailleurs de licence s il y en a Le logiciel d tenu par des tiers et qui comprend la technologie relative aux polices de caract res est prot g par un copyright et licenci par des fournisseurs de Sun Des parties de ce produit pourront tre d riv es des syst mes Berkeley BSD licenci s par l Universit de Californie UNIX est une marque d pos e aux Etats Unis et dans d autres pays et licenci e exclusivement par X Open Company Ltd Sun Sun Microsystems le logo Sun AnswerBook2 docs sun com et Solaris sont des marques de fabrique ou des marques d pos es de Sun Microsystems Inc aux Etats Unis et dans d autres pays Toutes les marques SPARC sont utilis es sous licence et sont des marques de fabrique ou des
Download Pdf Manuals
Related Search