Home

Installation

1. Replace both adjustable feet INSTALLATION 9 Place the door back on Ensure the door is aligned horizontally and vertically so that the seals are closed on all sides before finally tightening the top hinge 10 Insert the hinge bracket and screw it to the top of the unit 11 Use a spanner to tighten it if necessary 12 Put the hinge cover and the screw cover back 13 With the door closed check that the door is aligned horizontally and vertically and that the seals are closed on all sides before finally tightening the bottom hinge Re adjust the levelling feet as needed INSTALLATION Levelling the Unit To do this adjust the two levelling feet at the front of the unit va If the unit is not level the door and magnetic seal alignments will not be covered properly Cleaning Before Use Wipe the inside of the unit with a weak solution of bicarbonate soda Then rinse with warm water using a wrung out sponge or cloth Wash the shelf in warm soapy water and dry completely before replacing in the unit Clean the exterior of the unit with a damp cloth If you require more information refer to the Cleaning section Ls Before Plugging in YOU MUST Check that you have a socket which is compatible with the plug supplied with the unit Before Turning On Do not turn on until two hours after moving the unit The coolant fluid needs time to settle Before Using Y
2. collect juices and cover it properly Place the container on the lowest shelf Leave space around your food to allow air to circulate inside the unit Ensure all parts of the unit are kept cool To prevent transfer of flavours and drying out pack or cover the food separately Fruit and vegetables do not need to be wrapped Always let pre cooked food cool down before you put in the unit This will help to maintain the internal temperature of the unit To prevent cold air escaping from the unit try to limit the number of times you open the door We recommend that you only open the door when you need to put food in or take food out Cleaning Defrosting Frost might build up in the unit after it has been used for a period of time Scrape away the frost using a plastic scraper not included A Do not use a metal or sharp instrument to scrap away the frost nor should you use any electrical appliances to aid defrosting We recommend that defrosting should be carried out when the frost layer builds up to 10 mm 0 39 Choose a time when the stock of frozen food is low follow these procedures 1 Take out the food turn the unit off at the mains supply and leave the door open Ideally the frozen food should be put into another freezer If this is not possible wrap the food in several sheets of newspaper or large towels and then a thick blanket to keep it cool Place a shallow bowl or pan below the unit Scrape away the
3. frost S using the plastic scraper Defrosting the remaining frost can be si WS speeded up by placing a bowl of hot water inside the unit and closing the door As the solid frost loosens scrape it away with the plastic scraper and remove When defrosting is complete clean your unit s interior and exterior Cleaning the Interior and the Exterior of the Unit Remove the shelf before cleaning Wipe the inside of the unit with a weak solution of bicarbonate soda and then rinse with warm water using a wrung out sponge or cloth Wipe completely dry before replacing the shelf Use a damp cloth to clean the exterior and then wipe with a standard furniture polish Make sure that the door is closed to avoid the polish getting on the magnetic door seal or inside the unit The grille of the condenser at the back of the unit and the adjacent components can be vacuumed using a soft brush attachment Cleaning Tips Condensation may appear on the outside of the unit This may be due to a change in room temperature Wipe off any moisture residue If the problem continues please contact a qualified technician for assistance Maintenance Care When Handling Moving the Unit Hold the unit around its sides or base when moving it Under no circumstances should it be lifted by holding the edges of the top surface Servicing The unit should be serviced by an authorised engineer and only genuine spare parts should be used
4. process Do not lay the unit flat as this may damage the coolant system Ensure the unit is unplugged and empty Reversing the Door Swing Tools required Phillips style screwdriver Flat bladed screwdriver Hexagonal spanner Ls e Ensure the unit is unplugged and empty e Adjust the two levelling feet to their highest position To take the door off it is necessary to tilt the unit backwards You should rest the unit on something solid so that it will not slip during the door reversing process All parts removed must be saved to do the reinstallation of the door Do not lay the unit flat as this may damage the coolant system We recommend that 2 people handle the unit during assembly 1 Tilt the unit slightly towards the rear and prop it securely Two people are required to tilt the unit during the door reversal process INSTALLATION 2 Remove the top right hinge cover 3 Undo the screws Then remove the hinge bracket 4 Remove the top left screw cover 5 Move the core cover from left side to right side And then lift the door and place it on a padded surface to prevent it from scratching INSTALLATION 6 Remove the screws and bottom hinge Then remove the adjustable feet from both side 7 Unscrew and remove the bottom hinge pin turn the bracket over and replace it 8 Refit the bracket fitting the bottom hinge pin
5. Criterion User s Manual 1 5 Cu Ft Compact Refrigerator MODEL CCR15CE1B BEFORE USING YOUR PRODUCT Please read this manual carefully amp follow all safety rules amp operating instructions Keep this manual for future reference INSTALLATION Location When selecting a position for your unit you should make sure the floor is flat and firm and the room is well ventilated with an average room temperature of between 16 C and 32 C Avoid locating your unit near a heat source e g cooker boiler or radiator Also avoid direct sunlight as it may increase the electrical consumption Extreme cold ambient temperatures may also cause the unit not to perform properly This unit is not designed for use in a garage or outdoor installation Do not drape the unit with any covering When installing the unit ensure that 100 mm of free space is left at both sides 100 mm at the rear and 200 mm at the top of the unit The door can be opened to the right or the left depending on what better suits the location Please ensure there is adequate space for the door to fully open Ls e If you want to have the door swing reversed we recommend that you contact a qualified technician You should only try to reverse the door yourself if you believe that you are qualified to do so All parts removed must be saved to do the reinstallation of the door You should rest the unit on something solid so that it will not slip during the door change
6. THAN AUTHORISED SERVICE PERSONNEL TO CARRY OUT SERVICING OF REPAIRS WHICH INVOLVE THE REMOVAL OF COVERS A TO AVOID THE RISK OF AN ELECTRICAL SHOCK DO NOT ATTEMPT REPAIRS YOURSELF
7. Under no circumstances should you attempt to repair the unit yourself Repairs carried out by inexperienced persons may cause injury or serious malfunction Contact a qualified technician Switching Off for Long Periods of Time When the unit is not in use for a long period of time disconnect it from the mains supply empty all food and clean the appliance leaving the door ajar to prevent unpleasant smells Disposal Old units still have some residual value An environmentally friendly method of disposal will ensure that valuable raw materials can be recovered and used again The refrigerant used in your unit and insulation materials require special disposal procedures Ensure that none of the pipes on the back of the unit are damaged prior to disposal Up to date information concerning options of disposing of your old unit and packaging from the new one can be obtained from your local council office When disposing of an old unit break off any old locks or latches and remove the door as a safeguard Safety Warnings For your continued safety and to reduce the risk of injury or electric shock please follow all the safety precautions listed below Read all instructions carefully before using the unit and keep them for future reference Retain the manual If you pass the unit onto a third party make sure to include this manual Keep ventilation openings in the unit enclosure clear of obstructions Do not use mechanical devices or
8. between 4 to 5 for hotter environments Please adjust according to the environment Noises Inside the Unit You may notice that your unit makes some unusual noises Most of these are perfectly normal but you should be aware of them These noises are caused by the circulation of the refrigerant liquid in the cooling system It has become more pronounced since the introduction of CFC free gases This is not a fault and will not affect the performance of your unit This is the compressor motor working as it pumps the refrigerant around the system 11 Shopping for Chilled Foods Take a quick look at the chilled food package and make sure it is in perfect condition Try to keep chilled food together whilst shopping and on the journey home as this will help to keep the food cold Don t buy chilled food unless you can chill it straight away Specially insulated bags can be bought from most supermarkets and hardware shops These bags can keep chilled food cold for longer while transporting Food that has been left in a car or at room temperature for a prolonged period of time could raise the food temperature to a dangerous level which allows harmful bacteria to grow Always unpack and place chilled food in the unit before storing dry food Tips for Keeping Food in the Unit Cooked meats fishes should always be stored on a shelf above raw meats fishes to avoid bacterial transfer Keep raw meats fishes in a container which is large enough to
9. other means to accelerate the defrosting process other than those recommended by the manufacturer Do not use electrical appliances inside the food storage compartments of the freezer unless they are of the type recommended by the manufacturer If the mains cable is damaged it must be replaced by the manufacturer its service agent or a qualified technician in order to avoid a hazard Choose a location for your unit away from heat sources such as radiators or fires as refrigerant and vesicant are burnable Young children should be supervised to ensure that they do not play with the unit Do not damage the refrigerant circuit applicable only for appliances with refrigeration circuits which are accessible to the user The unit must be maneuvered by a minimum of 2 persons This unit is not intended for use by persons including children with reduced sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instructions concerning the use of the freezer by a person responsible for their safety If your unit is fitted with a lock to prevent children being trapped inside keep the key out of reach and not in the vicinity of the unit Do not store volatile or flammable substances in the unit Do not store bottles or glass containers in the unit Contents can expand when frozen fizzy drinks which may break the bottle and damage the unit WARNING IT IS HAZARDOUS FOR ANYONE OTHER
10. our Unit Before placing any food in your unit turn it on and wait for 24 hours to make sure it is working properly and to allow it time to fall to the correct temperature Your unit should not be overfilled Product Overview Font View Ice Box Adjustable Shelf Door Racks Thermostat Control Dial at rear side Levelling Feet Rear View Thermostat Control Dial at rear side 10 Operation Switching On Your Unit 1 Connect the mains cable to the mains socket The 4 internal temperature of your unit is controlled by a thermostat There are six settings of which position 3 5 5 is the coldest and position 0 turns the unit off 2 Adjust the thermostat control dial to the desired position bear in mind that the higher the 2 0 number the lower the temperature Position 3 recommended setting when operating at normal 1 room temperature between 16 C and 38 C 3 The unit may not operate at the correct temperature if it is in a particularly hot or a particularly cold room or if you open the door often 4 To ensure that the unit is cool enough to sufficiently chill your food wait 24 hours before filling it with food Adjusting the Temperature The internal temperature of the unit is controlled by a thermostat The recommended position is between 1 to 3 for colder working environments i e during winter and

Installation

Contents

Download Pdf Manuals

Related Search

Related Contents