USB Extender
Contents
1. USB2OQAEN USB2004 BT GB Instruction Manual USB Extender 4 Port USB 2 0 Extender over Cat5 or Cat6 StarTech com Making hard to find easy FCC Compliance Statement This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Use of Trademarks Registered Trademarks and other Protected Names and Symbols This manual may make reference to trademarks registered trademarks and other protected names and or symbols of third party companie2. between the Local and Remote units USB Port Indicates a USB peripheral device is connected and detected on the host computer system StarTech com Installation Hardware Installation 1 The Local Unit can be connected to the host computer system either when it is powered on or off 2 Connect the Local Unit directly to a USB port on the host computer system via the integrated USB cable The Power LED should light up if when the host computer is powered on 3 Connect the UTP CAT5e CAT6 etc network cable to the RJ45 connector on the Local Unit NOTE Ensure that the total length of cable between the Local and Remote units is 100m or less The cabling must also not go through any networking equipment e g router switch hub etc 4 Setup the Remote Unit near the remote USB peripheral s 5 Connect the other end of the UTP cable from the Local Unit to the RJ45 connector on the Remote Unit 6 Connect the power adapter to the Remote Unit The Power LED should light up The Host LED should start flashing if the Local Unit is powered The host computer system should detect a USB hub as being connected and the Host LED on both units should light up steady 7 Plug the remote USB peripheral s into the USB Hub connector s on the Remote Unit The corresponding USB port LED should light up The USB device s should be detected as if connected directly to the host computer system 8 Install the drivers for the co
3. duct Some states do not allow the exclusion or limitation of incidental or consequential damages If such laws apply the limitations or exclusions contained in this statement may not apply to you StarTech com Making hard to find easy StarTech com has been making hard to find easy since 1985 providing high quality solutions to a diverse IT and A V customer base that spans many channels including government education and industrial facilities to name just a few We offer an unmatched selection of computer parts cables A V products KVM and Server Management solutions serving a worldwide market through our locations in the United States Canada the United Kingdom and Taiwan Visit www startech com today for complete information about all our products and to access exclusive interactive tools such as the Cable Finder Parts Finder and the KVM Reference Guide
4. ether using standard UTP Cat5 Cat5e or Cat6 Ethernet cabling Supporting full Hi Speed USB 2 0 data transfer speeds up to 480Mbps the extender is also backward compatible with USB 1 0 1 1 1 1Mbps 12Mbps respectively Packaging Contents 1xUSB 2 0 Extender Local Unit 1xUSB 2 0 Extender Remote Unit 1xPower Adapter 1 x Instruction Manual System Requirements USB enabled computer system with available port USB compliant operating system Available power outlet at remote location StarTech com Local Unit RJ45 connector M RJ45 RJ45 Link LED Activity LED USB connector Host LED Description Power Turns on when power is being supplied via the USB port Host Turns on when the host computer system detects the extender RJ45 Link Indicates connectivity between the Local and Remote unit RJ45 Activity Indicates data transmission between the Local and Remote units StarTech com Remote Unit DC Power connector RJ45 connector t RJ45 Link LED Activity LED USB Hub Connector 1 USB 2 0 Extender ee MESES t J USB port Power Host LED LEDs LED LED Description Power Turns on when power is being supplied via the external powr adapter Host Turns on when the host computer system detects the extender RJ45 Link Indicates connectivity between the Local and Remote unit RJ45 Activity Indicates data transmission
5. nnected USB peripheral s as necessary StarTech com Driver Installation The USB Extender itself does not require a driver installation for any operating system that supports USB The USB Extender is a pass through hub so is only seen as a standard Generic USB hub Drivers will still be required for any USB peripherals connected to the extenders NOTE A additional level of USB hubs can be used on the USB extender one hub per port to provide additional USB ports An externally powered USB hub is recommended StarTech com Wiring Diagram The USB Extender uses all four pairs of wires in the UTP cable so either T568A or T568B termination can be used Both ends of the cable must use the same termination T568A Termination 2 gt me J 5 meme ef omme 2 7 4 8 4 Brown Specifications Bus Interface Connectors Local Unit Connectors Remote Unit LEDs Local Unit LEDs Remote Unit Maximum Data Transfer Rate Maximum Cable Distance USB Power per port Integrated Cable Length Power Adapter Operating Temperature Storage Temperature Humidity Dimensions Local Unit Dimensions Remote Unit Weight StarTech com USB2004EXT USB2004EXTGB USB 2 0 1 x RJ45 1 x USB type A male 1 x RJ45 4 x USB type A 1 x Power 1 x Host 1 x Power 1 x Host 4 x USB Detect USB 2 0 480Mbps 100m 330ft Rem
6. ote Unit 500mA Local Unit 6 5VDC 3A 0 C 50 C 32 F 122 F 5 C 60 C 23 F 140 F 0 80 RH 44 0mm x 87 0mm x 24 0mm 110 0mm x 69 0mm x 28 0mm Local Unit 60g Remote Unit 200g StarTech com Technical Support StarTech com s lifetime technical support is an integral part of our commitment to provide industry leading solutions If you ever need help with your product visit www startech com support and access our comprehensive selection of online tools documentation and downloads Warranty Information This product is backed by a one year warranty In addition StarTech com warrants its products against defects in materials and workmanship for the periods noted following the initial date of purchase During this period the products may be returned for repair or replacement with equivalent products at our discretion The warranty covers parts and labor costs only StarTech com does not warrant its products from defects or damages arising from misuse abuse alteration or normal wear and tear Limitation of Liability In no event shall the liability of StarTech com Ltd and StarTech com USA LLP or their officers directors employees or agents for any damages whether direct or indirect special punitive incidental consequential or otherwise loss of profits loss of business or any pecuniary loss arising out of or related to the use of the product exceed the actual price paid for the pro
7. s not related in any way to StarTech com Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech com or an endorsement of the product s to which this manual applies by the third party company in question Regardless of any direct acknowledgement elsewhere in the body of this document StarTech com hereby acknowledges that all trademarks registered trademarks service marks and other protected names and or symbols contained in this manual and related documents are the property of their respective holders StarTech com Table of Contents Introduction Packaging 1 System Requirements creer eer RES 1 Kore IBS c 2 Remo Unter 3 Installation Hardware Installation Driverlnstalati AA E WA AA 5 Wiring Diagram annnevnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnnvennennnnnnnnnnnn 6 Specifications nude navne 7 Technical Support eene 8 Warranty 8 StarTech com Introduction The StarTech com USB 2 0 extender over Cat5 or Cat6 offers a simple USB extension allowing you to place four USB 2 0 devices up to 100m 330ft away from the computer which is more than 20 times longer than the normal USB cable length restrictions The USB extender is comprised of both the Local and Remote units which can be connected tog
Download Pdf Manuals
Related Search