LIS1241 Sony Clie PEG-NR70V/U Battery Installation
Contents
1. LIS1241 Sony Clie PEG NR70V U Batter Installation Instructions PLEASE NOTE Patience and care along with moderate technical and hand tool ability are required for the successful replacement of a Clie battery Excessive force may result in damage to your PDA The instructions below come with no warranty guarantee proper or improper assembly or use The instructions below come with no warranty or guarantee By utilizing these instructions you agree to hold Batteryship com blameless and unaccountable for any and all damages problems or personal injuries that may or may not arise by your use of these instructions Replacing your Clie battery may void any warranty you have on your Clie Please read all instructions and back up your data BEFORE replacing the battery If your Clie is a different model number use these instructions as a reference and consult your owner s manual or a technician if necessary Included Phillips Flathead Screwdriver Combo Remove the one screw on the battery compartment using the included Phillips screwdriver as shown then the cover itself Set them aside for reassembly Do not attempt to remove the battery yet YOUR TOOLS MAY LOOK DIFFERENT FROM THE TOOLS SHOWN ABOVE Step 3 Once the screws have been removed GENTLY pry or lift the back cover off as shown Included Plastic Flathead Screwdriver _ a Step 2 Remove the five screws around the back of the Clie as shown using the i2. from step 2 Replace the battery compartment cover and screw from step 1 FULLY CHARGE your new battery before use Allow at least three hours For quality control we pre charge many of our batteries so yours may require less time PLEASE NOTE Our tools fit the majority of Clie s but some devices may have different screws installed for various reasons If our tools do not fit your device you may have the appropriate tool in a tool kit you already own You can also check your local hardware or electronics store if you do not have the right tool at home
3. ncluded Phillips screwdriver Your model may have four screws and require a small flathead screwdriver which we have also included Set the screws aside for reassembly Remove your old battery from its seat using the plastic flathead screwdriver if needed Leave the connector plugged in for this step The battery may be glued or taped in so remove the tape or pry under the battery GENTLY until it comes loose Take care not to break the old battery Steps 5 7 continued on back Disconnect the old battery at the connector by CAREFULLY pulling outward on the connector with your thumb and forefinger Be very sure that you are pulling outward on only the part of the connector that comes out as shown Step 6 Making sure that your battery is facing the right direction connector towards the top of the Clie connect the new battery by pressing the connector at the end of the ribbon cable into the socket as shown Note the location of the prongs in the socket of the Clie and the location of the plugs for the prongs on the battery connector and connect them accordingly Note that the metal connectors shown above generally go in facing up towards the back of the Clie Do not press too hard or try to force the pieces together They will fit easily when correctly aligned Position the new battery in its seat Place the tape back over the battery if applicable Replace the back of the Clie and screw the five screws back in
Download Pdf Manuals
Related Search