Sony ICF-M410V AM/FM/Weather/TV Radio - C:\Other Documents\MANUALS 1\Manuals 02-10\Sony\Sony ICF-M410S\Sony ICF
Contents
1. memory of the station has been initialized or another station is preset Preset the station again Sound is not heard and amp appears in the display e Batteries are exhausted The preset stations may be initialized if a maintenance service is performed Please note down your settings in case you want to preset them again Specifications Time display 12 hour system Frequency range Band Range Channel step TV 2ch 13ch 1 channel WEATHER lch 7ch 1 channel FM 87 5 108 MHz 0 1 MHz AM 530 1 710 kHz 10 kHz Speaker 7 7 cm 3 inches 8 Q Power output 200 mW at 10 harmonic distortion Output earphone jack 3 5 mm minijack Power requirements 4 5 V DC three size AA R6 batteries External power source DC IN 4 5 V Dimensions Approx 205 x 104 x 40 5 mm w h d Approx 8 x 41 x1 inches not incl projecting parts and controls Approx 212 x 104 x 42 5 mm w h d Approx 8 x 41 x11 inches incl projecting parts and controls Mass Approx 504 g 17 8 oz incl batteries Optional accessory AC power adaptor AC E45HG Specifications for AC E45HG vary for each area Check your local voltage and the polarity of the plug before purchasing Design and specifications are subject to change without notice Your Sony dealer may not handle all of the above listed optional accessory Please ask your dealer for detailed information on the optional accessory available in your coun2. radio Otherwise 4X1 may be displayed When this occurs turn on the radio so that disappears When operating the unit with the internal batteries remove the AC power adaptor from the wall outlet and the DC IN 4 5 V jack Make sure that the plug of the external power source is disconnected before operating the unit Use the recommended Sony AC power adaptor only The polarity of the plugs of other manufacturers may be different Failure to use the recommended AC power adaptor may cause the unit to malfunction DA Preventing Accidental Change HOLD function Slide HOLD o is displayed indicating that all the functions of the buttons are locked To release the key protection slide HOLD again so that o disappears For details on the optional AC power adaptor see Specifications Setting the Clock The display will flash AM 12 00 when the batteries are installed or the AC power adaptor is plugged in for the first time 1 To stop the display from flashing press CLOCK when the radio is off 2 While holding down CLOCK turn TUNE TIME SET to set the clock to the current time When you turn TUNE TIME SET a little to or the clock digits move forward or backward one by one and when you turn TUNE TIME SET further to A or the clock digits move rapidly When you release CLOCK the clock starts operating and starts flashing Changing AM Channel Step The AM channel ste
3. 3 229 096 31 1 SONY TV WEATHER FM AM PLL Synthesized Radio Operating Instructions OWNER S RECORD The model number is located on the rear and serial number on the rear exterior Record the serial number in the space provide below Refer to these numbers whenever you call upon your Sony dealer regarding this product Model No ICF M410V Serial No For customers in the USA Please register this product on line at http www sony com productregistration Proper registration will enable us to send you periodic mailings about new products services and other important announcements Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification Thank you ICF M410V Sony Corporation 2002 Printed in Malaysia http www sony net To prevent fire or shock hazard do not expose the unit to rain or moisture To avoid electrical shock do not open the cabinet Refer servicing to qualified personnel only You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This eq
4. d operation Before You Begin Thank you for choosing the Sony radio It will give you many hours of reliable service and listening pleasure Before operating the radio please read these instructions thoroughly and retain them for future reference Features e PLL synthesized tuning 4 band radio e A total of 20 channels can be preset 5 TV channels 5 WEATHER channels 5 FM channels and 5 AM channels e Easy to tune in preset stations with 5 direct access buttons e Sleep timer function switches the radio off automatically can be set to turn off after 15 30 45 or 60 minutes Standby timer function switches the radio on automatically at the time you want Notes on AM Channel Step The AM channel step differs depending on areas See Changing AM Channel Step Precautions e Operate the unit only on 4 5 V DC For battery operation use three size AA R6 batteries For AC operation use only the recommended AC power adaptor The unit is not disconnected from the AC power source mains as long as it is connected to a wall outlet even if the unit itself has been turned off The nameplate indicating operating voltage etc is located on the bottom exterior e Avoid exposure to temperature extremes direct sunlight moisture sand dust or mechanical shock Never leave in a car parked under the sun Should any solid object or liquid fall into the unit disconnect the AC power adaptor and remove the batterie
5. end the time Reset the sleep timer to a longer one
6. g the Reception See fig PD TV WEATHER FM Extend the telescopic antenna and adjust the length and the angle for best reception AM Rotate the unit horizontally for optimum reception A ferrite bar antenna is built in the unit Note Adjust the direction of the antenna holding the bottom of it The antenna can be damaged when you move the antenna with excessive force Presetting Your Favorite Station Preset Tuning You can preset up to 5 stations in each TV WEATHER FM and AM Presetting a Station 1 Follow steps 1 to 4 in Playing the Radio and manually tune in to the station you wish to preset 2 Press the PRESET TUNING button you wish to preset for Example Display window more than a few seconds when you preset FM You will hear two confirmation beeps and preset number 90 0 MHz in preset number 2 appears in the display To preset another station repeat these steps To change the preset station preset a new station The previous station will be cancelled Tuning in a Preset Station 1 Press POWER to turn on the radio 2 Select the band with BAND or WEATHER 3 Press the desired PRESET TUNING button 4 Adjust the volume using VOL Note Holding down the desired PRESET TUNING button for more than a few seconds will replace the previous station on the PRESET TUNING button with the station you tuned in to Setting the Standby Timer You can set the radio to turn on at a preset time You can set the s
7. he batteries are replaced press POWER to turn the indication off Note on replacing the batteries Do not take more than 40 seconds to replace the batteries otherwise the clock standby settings and preset stations will be initialized Should that happen reset the functions Notes on batteries Do not charge the dry batteries Do not carry the dry batteries together with coins or other metallic objects It can generate heat if the positive and negative terminals of the batteries accidentally come into contact with metallic objects When you are not going to use the unit for a long time remove the batteries to avoid damage from battery leakage and corrosion e Do not use different types of batteries at the same time e When you replace the batteries replace all with new ones To attach the battery compartment lid if it is accidentally detached See Fig 1 Insert one side of the lid as illustrated 2 Push the other side to attach Using House Current See fig Connect the Sony AC power adaptor not supplied to the DC IN 4 5 V jack firmly and plug it into a wall outlet Notes on the AC power adaptor e When operating the unit with an external power source do not remove the batteries These batteries serve to backup settings stored to memory Since batteries discharge in this case as well we recommend changing them about once a year Before connecting and disconnecting the external power source plug be sure to turn off the
8. p differs depending on areas The channel step of this unit is factory set to 10 kHz Change the settings as shown below to be able to listen to the radio Area Channel step North and South American countries 10 kHz Other countries 9 kHz Note When the AM channel step is changed the preset stations for AM will be initialized 1 Press POWER to turn off the power 2 While holding down CLOCK keep pressing POWER for more than 5 seconds Two short beeps sound and the AM channel step will be changed 9 kHz or 10 kHz is displayed for about 3 seconds If you proceed to step 2 again the channel step changes again Playing the Radio Manual Tuning 1 Press POWER to turn on the radio 2 Press BAND repeatedly to select the band Each press changes the band as follows gt AM gt FM gt TV Each band memorizes the frequency you had tuned previously To change the band to WEATHER press WEATHER You can return to the previous frequency by pressing BAND 3 Turn TUNE TIME SET When you turn TUNE TIME SET a little to or the frequency digits move forward or backward one step at a time and when you turn TUNE TIME SET further to A or the frequency digits move rapidly 4 Adjust the volume using VOL To turn off the radio Press POWER again To listen with an earphone not supplied Connect an earphone not supplied to the jack The sound through the speaker will not be heard Improvin
9. s and have the unit checked by qualified personnel before operating it any further Make sure that no liquid or foreign material enters the DC IN 4 5 V jack of the unit This may lead to the malfunc tion of the unit In vehicles or buildings radio reception may be difficult or subject to interference Try listening near a window Since a strong magnet is used for the speakers keep away personal credit cards using magnetic coding or spring wound watches from the unit to prevent possible damage from the magnet When the casing becomes soiled clean it with a soft dry cloth moistened with mild detergent solution Never use abrasive cleansers or chemical solvents as they may deform the casing If you have any questions or problems concerning your unit please consult your nearest Sony dealer Troubleshooting Guide Should any problem persist after you have made the following checks consult your nearest Sony dealer The front panel buttons do not operate at all e Om is displayed Slide HOLD so that o disappears Display is dim or no indication is displayed e Weak batteries e The unit is being used in extremely high or low temperatures or in a place with excessive moisture Very weak or interrupted sound or unsatisfactory reception e Weak batteries e When in a vehicle or building move closer to a window A station cannot be received when a preset tuning button is pressed e The station has not been preset The
10. tandby timer whether or not the radio is turned on 1 Hold down STANDBY until srawsy starts flashing 2 While holding down STANDBY turn TUNE TIME SET to set the time for the radio to be turned on 3 When STANDBY is released the standby timer is activated and smwsy stops flashing The radio is turned on and is displayed at the preset time After 60 minutes the radio will automatically turn off Once you set the standby timer the radio will turn on at the same time everyday Deactivating the standby timer Press STANDBY so that sranosy disappears If holding down STANDBY for more than about a second the standby timer is activated Setting the Sleep Timer By setting the sleep timer the radio turns off automatically after a set time 60 45 30 or 15 minutes 1 Press SLEEP The sleep timer setting of 60 is displayed and flashes If you press SLEEP while the radio is off the radio turns on 2 Press SLEEP repeatedly to select the desired sleep timer setting while ema is flashing Each press changes the display as follows 60 gt 45 30 15 E is displayed for about three seconds and the frequency is displayed The sleep timer starts operating The radio will turn off automatically after the set time To cancel the sleep timer Press POWER to turn off the radio before the set time has elapsed and press POWER again to turn on the radio To ext
11. try HOLD a POWER 0 i DOI O n srny PRESET we DB ame OC LOLOL we CLOCK STANDBY SLEEP WEATHER CTT C weoecccce PRESET TUNING eovccccce KDY Wp e O GO a SELECT PRESET BAND Telescopic Antenna earphone jack DC IN 4 5V TUNE TIME SET VOL Rear Size AA R6 x 3 Insert the side of the battery first to DC IN 4 5V AC power adaptor not supplied TV WEATHER FM AM Choosing Power Source Installing Batteries See fig EN 1 Open the lid of the battery compartment at the rear of the unit 2 Install three size AA R6 batteries not supplied with correct polarity and then close the lid AM 12 00 flashes on the display when you first install the batteries To stop the flashing set the clock See Setting the Clock Battery Life Approx hours JEITA TV WEATHER FM AM Sony alkaline size AA LR6 batteries 28 28 29 41 Sony size AA R6 batteries 16 16 17 24 Measured by JEITA Japan Electronics and Information Technology Industries Association standards The actual battery life may vary depending on the circumstance of the unit When to replace the batteries When the batteries become weak the sound may become weak or distorted and will flash in the display After that when the batteries are used up will light and the power of the unit will be turned off If this happens replace the batteries with new ones After t
12. uipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help If you have any questions about the product you may call Sony Direct Response Center 1 800 222 7669 or write to Sony Direct Response Center 12451 Gateway Blvd Fort Myers FL 33913 Declaration of Conformity Trade Name SONY Model ICF M410V Responsible Party Sony Electronics Inc Address 680 Kinderkamack Road Oradell NJ 07649 USA Telephone Number 201 930 6972 This device complies with Part 15 of the FCC Rules Operation is subject to the following two condi tions 1 This device may not cause harmful interference and 2 this device must accept any interfer ence received including interference that may cause undesire
Download Pdf Manuals
Related Search