Sima GoDVD CT2 Copy Master Digital Video Duplicator
Contents
1. Darken gt B W Pressing the button four times begins the cycle again The LED indicator light shows which Input format and Enhancement mode are selected For example a steady green light means you have selected a composite input signal and will output in the Normal video mode An orange blinking light indicates an S video input signal with one of three enhancement modes Use the steady indicator light as a fixed point to determine the desired enhancement mode Review the chart below to determine the correct setting If unsure which video enhancement mode is selected look at your video monitor while toggling through the options Input LED Normal Enhanced Darken B W en Green Steady Green blinking Green blinking Green blinking Orange Steady Orange blinking Orange blinking Orange blinking Select A V input on your recording VCR or DVD and press RECORD Then press PLAY on your playback device Specifications Note VHS and DVD media are produced in more than one video format In the United States the NTSC format is used In Europe the PAL format is used GoDVD automatically detects the input format however you must select the output format NTSC amp PAL GoDVD converts NTSC to PAL and PAL to NTSC video formats To output in NTSC slide the switch located on the OUTPUT panel to the right To output in PAL slide the switch located on the OUTPUT panel to the left INPUT NTSC3 58 NTSC4 43 PAL PAL M PAL N S2. negligence or unauthorized repairs All liability for incidental or consequential damages is specifically excluded some states do not allow for the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you This warranty gives you specific legal rights and you may have other rights which vary from state to state Troubleshooting Possible Solutions Congratulations on your purchase of Sima s GoDVD Model CT 2 This Device does not e Press Input select switch to toggle between composite package includes 1 Go DVD Model CT 2 1 RCA style Video Cable operare and s video inputs 1 7 5V 500 mA AC adapter and This Instruction Manual e Has correct mode AV Line Tuner etc been set on the VCR or DVD Connection GoDVD should be connected between your playback VCR e Correct connecting cable DVD or camcorder and the recording VCR or DVD as shown below _ Note Regardless of which input is used both outputs continuously deliver e Have the RCA cables been mixed up at the input and i S output of the VCR DVD an output signal The unit will automatically detect whether the video input is in NTSC USA or PAL Europe format The output format is determined by Kopien e Is the Power light on If not there is no power the setting of the PAL NTSC output switch See diagram below e ls the connecting cable of the plug in adapter dama ge d Playback camcorder VCR or DVD Pi
3. ECAM auto detection Input Connectors Composite Video RCA jack x 1 S video mini din x 1 Note input selection switch toggles between composite and s video input source OUTPUT NTSC Fsc 3 58 MHz PAL Fsc 4 43 MHz Output Connectors Composite Video RCA jack x 1 S video mini din x 1 Power DC 7 5V 500mA Dimensions 4 5 W x 2 5 L x 75 H
4. Other Products and Accessories available from Sima Products Color Corrector Model SCC 2 for advanced color correction while copying VHS and DVDs Audio and video cables SFX 9 Video mixer A V selectors SVS 4D VS 712EX Universal Touch screen remote controls SUR 20 SUR 25 SUR 35 SUR 47 sima Sima Products Corporation 140 Pennsylvania Ave Bldg 5 Oakmont PA 15139 800 345 7462 www simacorp com e mail us at custserv simacorp com 2004 Sima Products Corporation PN21696 GoDUD Digital Video Enhancer and Duplicator Model CT 2 User Manual SIMa Notice Use of this product for unauthorized duplication of copyrighted material from DVD VHS or other media is strictly prohibited under the federal Copyright laws unless the copy qualifies as a fair use under the Copyright laws FCC Information This equipment generates and uses radio frequency energy and if not installed and used properly that is in strict acceptance with the manufacturer s instructions may cause interference to radio and television reception It has been type tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules which are designed to provide reasonable protection against such interference in a residential installation However there is no guarantee that interference will not occur in a particular installation If this equipment d
5. cture rolling e TV does not support 50 60 Hz scan rates GoDVD will not perform the following functions 1 Allow you to play a PAL DVD or video tape on a NTSC player and visa versa 2 Allow you to play a PAL DVD or video tape on an NTSC TV that supports only 60 Hz scan Sout Vout NTSC PAL Input Panel Output Panel 3 Allow you to copy an NTSC DVD or video tape to an NTSC DVD ae 7 recorder or VCR in the PAL format to send over seas unless the adapter l Input Indicator recorder supports both formats button select light button Only the video cables are to be connected to GoDVD Audio cables should be connected directly between the playback and recording units With Hi 8 or S VHS capability connect your S video cables to GoDVD Operation Connect the GoDVD unit as shown on page 3 Select the PAL NTSC output format by setting the PAL NTSC output switch to the desired setting Note The unit will automatically detect whether the input is PAL or NTSC however you must select the desired output format For use on U S televisions VCRs and DVDs set the output format switch to NTSC Select the appropriate input by pressing the Input select switch Green indicator light signifies Composite signal Orange indicator light signifies S video input signal Select the desired video enhancement mode by pressing the Video Enhancement button The button cycles between four enhancement modes as follows Normal gt Enhanced gt
6. oes cause interference to radio and television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Re orient the receiving antenna Relocate this equipment with respect to the receiver Move this equipment away from the receiver Plug this equipment into a different outlet so that this equipment and receiver are on different branch circuits If necessary the user should consult the dealer or an experienced radio television technician for additional suggestions The user may find How to Identify and resolve Radio Television Interference Problems prepared by the FCC helpful The booklet is available from the U S Government Printing Office Washington DC 20402 Stock No 004 000 00345 4 90 day Limited Warranty Sima Products Corporation warrants this product against defects in materials and workmanship for a period of 90 days from the date of purchase During the warranty period the product will be repaired or replaced at Sima s option Mail the enclosed product registration card within ten days of the original purchase Conditions Ship your unit freight pre paid including a copy of your sales receipt and a description of problem to Sima Products Corporation Attn Customer Service 140 Pennsylvania Ave Bldg 5 Oakmont PA 15139 This warranty is void if any defects are caused by abuse misuse
Download Pdf Manuals
Related Search