Broan-NuTone N-9013NL Combination Heater Heater
Contents
1. be defective under normal use and service THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES FILTERS DUCT ROOF CAPS WALL CAPS AND OTHER ACCESSORIES FOR DUCTING This warranty does not cover a normal maintenance and service or b any products or parts which have been subject to misuse negligence accident improper maintenance or repair other than by NuTone faulty installation or installation contrary to recommended installation instructions The duration of any implied warranty is limited to the one year period as specified for the express warranty Some states do not allow limitation on how long an implied warranty lasts so the above limitation may not apply to you NUTONE S OBLIGATION TO REPAIR OR REPLACE AT NUTONE S OPTION SHALL BE THE PURCHASER S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from state to state This warranty supersedes all prior warranties WARRANTY SERVICE To qualify for warranty service you must a notify NuTone at the address stated below or telephone 1 800 543 8687 b give the model number and part identification2. TIMER IS USED CONNECT AT FIGURE 2 MOUNTING THE B UNIT MOUNTING THE GRILLE Refer to Figure 3 Refer to Figure 4 The B unit heater and light assembly is completely assembled Align keyhole slots in the grille with the screws in the brackets on at the factory and ready for installation with the exception of the A unit and fasten into place the grille 1 Insert the hooked hinge of the B unit into the slotted hanger bracket of the A housing 2 Insert plug on B unit into receptacle in junction box cover 3 Swing the assembly into place and secure to the A unit with the screws provided in the bracket of the A unit 4 Refer to Figure 4 Install the bulbs NOTE 100 watt maximum and 7 watt maximum for night light SLOTTED HANGER BRACKET NIGHT LIGHT LIGHT RECEPTACLE RECEPTACLE KEY HOLE KEY HOLE SLOT SLOT FIGURE 3 FIGURE 4 One Year Limited Warranty WARRANTY OWNER NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one 1 year from the date of original purchase THERE ARE NO OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE During this one year period NuTone will at its option repair or replace without charge any product or part which is found to
3. U Heat A Lite MODEL 9013NL IMPORTANT Do not mount over tub or in shower stall enclosure The NuTone Heat A Lite and Night Light consists of the rough in housing including the junction box and adjustable hanger bar a one piece heater and light assembly grille and a NuTone wall switch assembly MOUNTING THE HOUSING A UNIT Refer to Figure 1 1 Nail mounting brackets to the ceiling joists 16 center to center 2 Insert the adjustable hanger bar in third mounting bracket and nail to joists WARNING Do not wedge the housing in any way to throw it out of round NOTE For 24 center to center joists use two 2 adjustable hanger bars included ADJUSTING THE HOUSING Refer to Figure 1 The screws inside the housing may be loosened slightly to allow for adjustment to the finished plaster or ceiling line WIRING WARNING Be sure heater and switch are properly grounded and all wiring complies with local electrical code 1 Install double gang switch box in chosen location 2 Refer to Figure 2 Run wiring and make connections as illustrated 3 Use the supplied screws to secure switch bracket assembly to switch box 4 Use the supplied screws to secure wall plate to switch bracket INSTALLATION INSTRUCTIONS READ amp SAVE THESE INSTRUCTIONS NAILING BRACKET ADJUSTABLE HANGER BAR HEATER OUTLET BOX NAILING BRACKET FIGURE 1 HEATER JUNCTION BOX YELLOW NOTE WHEN THERMOSTAT OR
4. and c describe the nature of any defect in the product or part At the time of requesting warranty service you must present evidence of the original purchase date Date of Installation Builder or Installer Model No and Product Description IF YOU NEED ASSISTANCE OR SERVICE For the location of your nearest NuTone Independent Authorized Service Center Residents of the contiguous United States Dial Free 1 800 543 8687 Please be prepared to provide Product model number Date and Proof of purchase The nature of the difficulty Residents of Alaska or Hawaii should write to NuTone Inc Attn Department of National Field Service 4820 Red Bank Road Cincinnati Ohio 45227 1599 Residents of Canada should write to Broan NuTone Canada 1140 Tristar Drive Mississauga Ontario Canada _ L5T 1H9 Rev 03 2001 Product specifications subject to change without notice Printed in U S A Rev 06 01 Part No 85930
Download Pdf Manuals
Related Search