Kenmore 580.5245 Dehumidifier User Manual
Contents
1. C At temperatures below this the coils can become covered with frost which may reduce dehumidifying performance DEFROST CONTROL When the defrost control senses frost build up on the evaporator coil it will automatically shut off the compressor The fan will continue to run to draw air across the coil and melt the frost When the coil is defrosted the compressor will automatically restart and dehumidifying resume Use the dehumidifier in a basement to help prevent moisture damage Use the dehumidifier in cooking laundry bathing and dishwashing areas that have excessive moisture Use the dehumidifier to prevent moisture damage anywhere books or valuables are stored HSIMDNA AUTOMATIC SHUT OFF When the bucket is full or when the bucket is not in the proper position the Bucket Full light turns on and the unit automatically shuts off Also when bucket is out of position the unit will beep 3 times The bucket must be replaced in the proper position for the dehumidifier to work The light will be on and the dehumidifier will not run if the bucket is not in the proper position REMOVING AND EMPTYING THE WATER BUCKET The water bucket can be emptied in one of three ways Empty the bucket manually Place the dehumidifier Attach a garden hose to the When the bucket is full directly over drain threaded bucket drain hose remove and empty it into a The bucket has a threaded connection to carry water2. a Power Control Humidity Control Fan Speed Control and Timer Control Bucket Full indicator This light glows when the water bucket is full and needs to be emptied Power Operation starts when this button is pressed and stops when the button is pressed again Humidity Control This button controls the humidity in the room gt To raise the humidity setting ao To lower the humidity setting The humidity can be set within a range of 40 RH Relative Humidity 70 RH Relative Humidity by 5 increments Fan Speed This controls the speed of the airflow High Fan speed is set to high Low Fan speed is set to low When Fan Speed button is pressed the fan speed mode is changed Energy Timer Pressing this button will make the unit go into automatic On Off mode In this mode the unit will be On for 3 or 6hrs and then it will automatically turn off for 3 or 6hrs After that it will turn on again and this cycle will be repeated continuously Constant button will make the unit run continuously under normal humidity conditions The Timer can be set for Constant 6 Hr On Off or 3 Hr On Off When Timer button is pressed the Timer indicator lights shift as follows Constant gt 3 Hr On Off gt 6 Hr On Off gt Constant Auto Restart In case the power comes on again after a power failure Auto Restart Operation is the function to operate procedures automatically to the previous operating conditions So there is n
3. prong grounding plug To minimize possible shock hazard the cord must be plugged into a mating grounding type wall receptacle and grounded in accordance with the National Electrical Code ANSI NFPA 70 latest edition and all local codes and ordinances If a mating wall receptacle is not available it is the personal responsibility and obligation of the customer to have a properly grounded 3 prong wall receptacle installed by a qualified electrician Electrical Shock Hazard Plug into a grounded 3 prong outlet Do not remove ground prong Do not use an adapter Do not use an extension cord Failure to follow these instructions can result in death fire or electrical shock prong 3 prong grounding grounding de plug pias Power supply cord FEATURES OPERATION To reduce the risk of fire electric shock or injury to persons read the important SAFETY instructions section before operating this appliance 1 Control panel 2 Front grille 3 Power cord 4 Cabinet 5 Air filter 6 Water bucket IMPORTANT When unit is first plugged in or after a power outage there will be a 2 minute delay before operation begins HSIMDNA n EP sigh Constant BUCKET Uy ATRAS 9 HE ONON FULL A Creen e 3He OnO i 7 5 e E x FIMER Y rt Auto Restart s CONTROL PANEL Your dehumidifier control panel contains a Bucket Full indicator a Humidity indicator
4. 10209A 5211A10231A 5211A10085H DESCRIPTION NUT TERMINAL COVER TERMINAL COVER O L P GASKET COMPRESSOR NUT HEXAGON BRACKET WASHER BUSHING TUBE ASSEMBLY SUCTION TUBE ASSEMBLY DISCHARGE TUBE ASSEMBLY CAPILLARY 13
5. INET 14 A 3831A20016B ESCUTCHEON 5 A 6877A30013D SENSOR ASSEMBLY 15 A 3551A30030C COVER ASSEMBLY DISPLAY 6 A 4995A10051A CONTROL BOX ASSEMBLY 16 A 6411A20001V POWER CORD ASSEMBLY 7 A 6871A20162A PWB ASSEMBLY MAIN 8 A OCZZA20001Q CAPACITOR DRAWING 9 A 4H00442J CLAMP CAPACITOR 141 580 52450 NOTE When ordering parts use the Kenmore part number not the illustration number CYCLE PARTS ILL NO PART NUMBER DESCRIPTION 1 B 5900A20007A FAN 2 B 4999A10001C SHROUD ASSEMBLY 3 B 4681A20040C MOTOR ASSEMBLY SINGLE 4 B 4960A20009A MOUNT MOTOR 5 B 5403A10008D CONDENSER ASSEMBLY 6 B 5421A10009F EVAPORATOR ASSEMBLY sTo 580 52450 NOTE When ordering parts use the Kenmore part number not the illustration number COMPRESSOR PARTS HSIMTDNA ILL NO 1 C 2 C 3 C 4 C 5 C 6 C 7 C 8 C 9 C 10 C 11 C PART NUMBER 4H00947A 3550U LO04A 6750U LO39A 4986U L001G 2520UABC2FA 1NHA0801206 4810AR4155A 4830A30005A 5211A
6. Owner s Manual Manual del Propietario Kenmores DEHUMIDIFIER DESHUMIDIFICADOR Model Modelo 580 52450 m Z 0 E YD T Ss TON vasa Sears Roebuck and Co Hoffman Estates IL 60179 U S A www sears com TABLE OF CONTENTS TABLE OF CONTENTS coorrrrreconnnnmnnnnnnnnnnononos 2 AUTOMATIC SHUT OFF aaoi 8 WARRANTY AAA A tease 2 REMOVING AND EMPTYING Ear a HE WATER BUGRE Topes daa 8 Important Safety Instructions ad ea 3 MAINTENANCE Nas dias cade 9 ELECTRICAL REQUIREMENTS e 4 Grille ANd CASE ccocccncnnnnininonanenenonanannononoss 9 OPERATION A AE 5 Air filter A A E 9 Peas in pta 5 Cleaning inside the unitevevesvenneu 9 Control A mentee 6 General Cleaning smc 9 INSTALLING YOUR DEHUMIDIFIER 7 Water bucket cleaning 9 Bj A eitntetcatoahts uta 7 TROUBLESHOOTING correctores 10 CHOOSING THE PROPER LOCATION wad 7 REPAIS PARTS AATE ATERT ETETETT TETTE 11 ESPANOL A E TET E ON T E TTA 14 SERVICE NUMBERS eerren Back Cover WARRANTY FULL ONE YEAR WARRANTY ON DEHUMIDIFIER For one year from the date of purchase if the Dehumidifier is operated and maintained according to the owner s instructions furnished with the product Sears will repair the Dehumidifier free of charge if defective in materials or workmanship FULL FIVE YEAR WARRANTY ON SEALED REFRIGERATION SYSTEM For five years from the date of purchase when this Dehumidifier is operated and maintained according to owner s instructions furni
7. brush or use the dusting attachment of your vacuum If cabinet paint chips you can touch up the paint with a good grade enamel to prevent rust WATER BUCKET CLEANING Every few weeks rinse the inside of the water bucket with a mild detergent to prevent growth of mold mildew and bacteria TROUBLESHOOTING Dehumidifier does not start Dehumidifier does not dry the air as it should Dehumidifier runs too much Frost appears on the coils Fan noise Water on floor The dehumidifier power cord is unplugged Make sure the dehumidifier plug is pushed completely into the outlet The fuse is blown or circuit breaker is tripped Water bucket is full Check the house fuse or circuit breaker box and replace the fuse or reset the breaker The dehumidifier automatically turns off when this occurs Empty the bucket Bucket is not installed Did not allow enough time to remove the moisture Make sure the bucket is in the right place When first installed allow at least 3 or 4 days to maintain the desired dryness The Humidity Control may not be set low Humidity Doors and windows may not be closed tightly Clothes dryer may be blowing moisture laden air into the room Room temperature is too low Area to be dehumidified is too large Doors and windows are open Dehumidifier has been recently turned on or room temp
8. der any circumstances cut remove or bypass the grounding prong from this plug Power supply cord with 3 prong grounding plug rN ie ELECTRICAL INFORMATION The complete electrical rating of your new dehumidifier is stated on the serial plate Refer to the rating when checking the electrical requirements Be sure the dehumidifier is properly grounded To minimize shock and fire hazards proper grounding is important The power cord is equipped with a three prong grounding plug for protection against shock hazards Your dehumidifier must be used in a properly grounded wall receptacle If the wall receptacle you intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker have a qualified electrician install the proper receptacle Do not use an extension cord or an adapter plug HSMODNA ELECTRICAL REQUIREMENTS OBSERVE ALL LOCAL CODES AND ORDINANCES DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE POWER SUPPLY CORD GROUND PRONG ELECTRICAL GROUND IS REQUIRED ON THIS APPLIANCE A 115 volt 60 Hz AC only 15A fused and properly grounded electrical supply is required A time delay fuse or time delay circuit breaker is recommended Use a dedicated circuit serving only this appliance DO NOT USE AN EXTENSION CORD RECOMMENDED GROUNDING METHOD For your personal safety this appliance must be grounded This appliance has a power supply cord with a 3
9. erature is below 65 F 18 C Air is moving through the dehumidifier Bucket drain hose connection may be loose Water bucket is not all the way in furniture blocking the front or back of the dehumidifier Press the Humidity Control button to lower the humidity Check that all doors windows and other openings are securely closed Install the dehumidifier away from the dryer The dryer should be vented to the outside The unit will not operate satisfactorily if the room temperature is below 65 F 18 C Check with your dealer to see if the capacity is adequate Close all doors and windows to the outside This is normal Frost will usually disappear within 60 minutes This is normal Check the hose if one is attached See Removing and Emptying The Water Bucket 10 REPAIR PARTS Dehumidifier To order Parts call Toll Free Model No 580 52450 1 800 4 MY HOME 1 800 469 4663 NOTE Use the Kenmore part number on all orders not the illustration number OUTER CASE PARTS AND CONTROL PART HSIMDNA ILL NO PARTNUMBER DESCRIPTION ILL NO PART NUMBER DESCRIPTION 1 A 3041AD2007C BASE ASSEMBLY WELD SINGLE 11 A 5230AD3005A FILTER AIR 2 A 4791A10002B BARRIER ASSEMBLY 12 A 3530A10006F GRILLE FRONT 3 A 6600A30003C SWITCH ASSEMBLY MICRO 13 A 4838A20005A TANK BUCKET 4 A 3090A10001R CAB
10. o need of activating this function by pressing any key or button TO OPERATE THE DEHUMIDIFIER 1 Plug the power cord into an electrical outlet Press the power button 2 Set the Humidity Control anywhere between 40 RH Relative Humidity and 70 RH Relative Humidity for normal operation If you need drier air press the gt Humidity Control button If you need less moister air press the a Humidity Control button 3 Press the Power button to stop the unit manually 4 Press the Timer button to set the amount of time you want the unit to run At the end of that time the unit will shut off The Timer can be set for Constant 6 hours or 3 hours 5 If you want to control the speed of airflow press Fan Speed button Each time that the Fan Speed button is pressed the fan speed mode is shifted High gt Low gt High Note Be careful not to lose the water bucket This dehumidifier doesn t run if the water bucket is not installed properly 6 INSTALLING YOUR DEHUMIDIFIER nstall the dehumidifier on a level floor strong enough to support the unit with a full bucket of water For best performance allow at least 12 18 inches of air space on all sides of the unit for good air circulation Keep all outside doors windows and other openings closed when operating the dehumidifier Humid outdoor air will add to the unit s work load Install your dehumidifier in an area where the temperature will not fall below 65 F 18
11. shed with the product Sears will repair the sealed refrigeration system consisting of refrigerant connecting tubing and compressor motor free of charge if defective in material or workmanship WARRANTY SERVICE IS AVAILABLE BY RETURNING UNIT TO THE NEAREST SEARS SERVICE CENTER IN THE UNITED STATES CALL 1 800 4 MY HOME FOR NEAREST SERVICE CENTER TO YOU This warranty applies only while this Dehumidifier is used in the United States This warranty gives you specific legal rights and you may also have other rights which vary from state to state Sears Roebuck and Co D 817WA Hoffman Estates IL 60179 U S A SAFETY IMPORTANT SAFETY INSTRUCTIONS The safety instructions below will tell you how to use your dehumidifier to avoid harm to yourself or damage to your dehumidifier FN Tlie FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance Read product labels for flammability and other warnings TENA PREVENT ACCIDENTS To reduce the risk of fire electrical shock or injury to persons when using your dehumidifier follow basic precautions including the following Be sure the electrical service is adequate for the model you have chosen AAWARNING Avoid fire hazard or electric shock Do not use an extension cord or an adapter plug Do not remove any prong from the power cord Grounding type wall receptacle Do not un
12. to large sink or foe When hose connection which canbe the drain HAND TIGHTEN ONLY finished replace it properly left open Drill a 1 4 6 4mm Be sure the hose doesn t kink NOTE To replace the bucket to 1 2 13mm hole in the or bend It should lie flat from properly make sure the center of the hose connection the dehumidifier to the drain slots on the back of bucket Once opened the hose are positioned correctly connection will continually drain water from the bucket MAINTENANCE GRILLE AND CASE To clean the case Use water and a mild detergent Do not use bleach or an abrasive cleaner To clean the grille Use a vacuum with an attachment or brush AIR FILTER The air filter is on the back of the dehumidifier It should be checked and cleaned at least every 30 days or more often if necessary TO REMOVE Flex the filter at the lower right corner and slide the upper right side to the left Release all of the tabs and remove the filter Wash it in warm soapy water Rinse and let the filter dry before replacing it m Z 0 E YD T CLEANING INSIDE THE UNIT After removing the air filter clean the coil on the inside with a soft brush to remove any soft and wet soil NOTE Do not allow water to enter the electrical machine compartment through the circular opening behind the coil Do not spray the coil with a hose GENERAL CLEANING e Dust the front grille and the side panels with a soft
Download Pdf Manuals
Related Search