Haier FCD-JTHC40-E Water Heater User Manual
Contents
1. ice forms tank and pipes will break O Do not installit outdoors causing scalding andleakage Olt shall be hung on firmand solid wall O Do not installit as stand alone EE a Do not installit in places unable to drain If a drain hose is connected it shall be water connected to sewage drain avoiding spilling the room The tubes and pipes fitted onthe product are inseparable parts of the Safe Care technology and shall notbe removed by yourself Otherwise Haier shall not be liable for any damagesor injuries caused due to resulted potential risks Description of the Symbols OQ Never do that Q Be sure to act as per instructions Installation Installation must be made by installers of or designated by our company after service department The water heater shall be wall mounted O Before installation make sure water heater rear wires are fit firmly Determine an installation location Make four holes 12mm 65 mm deem the wall Insert and fix expansion hooks andexpansion bolts in corresponding wall holes Lift the water heater Insert wall rack onto the hooks and bolts Fit flat washers rear wires and nuts in turn onto the bolts Tighten the nuts and checkthem firm Installaccessories such as safety valve drain hoseas shown inFig 2 Usesealing compound toprevent water leakage OTo facilitate installation and removal it is suggested a G 1 2 movable nutis fitted at2. appropriate locations oninlet and outlet pipes respectively Find water supply location Connect inlet pipe outlet pipe andcity water piperespectively to theuse point Note To avoid heatdissipation hot water pipe shall notbe too long For easy future maintenance and repair adequate space must be reserved during installation outlet A Safety valve fi t E Cold water inlet Hot A Cold water Showerhead valve j LJ valve Mixing valve s Fig 2 For Installation Information Only Fig 3
3. to the safety valve Connect one end of the hose to the safety valve vent and the other end tothe sewage drain The hose can be cutshort or extended as necessary The hose shall be installedas inclined downward The water may drip from the discharge pipe ofthe pressure relied device and that this pipe must be installed in a continuously downward direction and in a frost free environment Check safety valve once a month as follow move the small handle of safety valve if there s water flowing out safety valve is normal if there s no water flow pleasecontact local after salesservice station The pressure relief device is tobe operated regularly to remove lime deposits and to verify that itis not blocked Connect to drain hose Fig 4 Fig 5 Attentions in Installation During installation adequate space must be reserved for future maintenance and repair Ifthe water heateris installed withindecoration boards theright board shallbe removable to facilitate removing the plasticcover during maintenance City water inlet pressure shall notbe less than0 05 Mpa O Electric water heater shall be installed indoors with ambient temperature above OC The pipes shallbe collectively laid Hot water outletshall not betoo far fromuse points In case farerthan 8 m hot water pipe shall have athermal insulation to minimize heat loss O The mounting wallshall be firm and reliable to support twi
4. Little Sea ox Haier Household Electric Water Heater User s Manual FCD JTHC40 III E FCD JTHC50O III E FCD JTHC60 III E FCD JTHC80 III E gt Haier Group Qingdao Economic and Technological Development District Haier Water Heater Co Ltd Add Haier Garden Qianwangang Road Economic DevelopmentZone Qingdao P R China ebelisnte WWW haisi com Rev Please read this manual before usage 01 Specific Number 0040501678 Retain it forfuture reference afe Care f 7 PTOIO Mark of Haier Safe Pre safe Expert This mark is the designation for Pre safe Expert of Haier Water Heater Company which indicates use of the company s patented technology inside the product It ensures you a safe bath while monitoring whether your house ground wire islive or not all thetime If this mark is lightedon it indicates your house ground wire has come live poor grounding and live In this case please immediately stop use and unplug from the power supply and remember notto touch any electric appliance shell in your house At the same time immediately contact after sales service and your property management company for Water Heaters family Contents Before Usage Features sseseess cesses ge waeeecasseeats 2 Parameters tect c ee 2 Dimensions eet eiere t tees 3 Electric circuit diagram 3 Safety precautions 4 Setting environment essi renee sees 5 Insta
5. ce the weight of water heater full of water Non load bearing walls or air brick walls must have corresponding protective measures like additional support wall through screws or back boards Electric water heater shall be locatedin a place easy for use maintenance and witha floor drainer In case the tank or pipes leak nearby or lower facilities shall not be damaged The installation location shall avoid being above toilet bowl bathtub washbasin or doorframe where will causea suppressed orunsafe feeling tousers Power socket for water heater shall be in a dry place free of water splash splash proof box is preferred Do not confuse inlet and outlet water pipes Safety valve shall be installed at designated position withno random modification O The water heatershall use a c220 V 50 Hz power supply from a separate socket no multi purpose socket and be reliably grounded The power socket shall meet national standard requirements Power plug pins shall be cleaned in time to avoid any contamination causing accidentslike fire S Power socket for water heater shall be located in adry place free of water spray Do not insert or pull the power plug with wet hands for accidents like electric shock or injurymay happen O Check if power meter and wire size are consistent with water heater rated current If necessary ask experienced qualified electricians to check ODo not use damaged wire socket or appliances w
6. d hot water quantity can meetuse demand temperature setting shall be possibly low It can minimize heat dissipation high temperature corrosion and sedimentation ensuring a longerservice life 6 Regularly ask servicemen to make safety inspection remove sediment on heating elements and check consumption of anode bar Toomuch consumed anode bar shall be replaced Cleaning and Maintenance Statement This water heater shall only be repaired and maintained by qualified servicemen Improper maintenance may cause severe injury or damage Before opening orrepairing water heater please dopull out the power plug Note Before asking for service please refer to troubleshooting section to resolve easy problems External Cleaning Disconnect power supply before cleaning Gently wipe with wet cloth dipped with a little of mild detergent Do not use gasoline or other solvents Finally dry with dry cloth Keep water heater dry Do not use cleansers containing grinding agent e g toothpaste acids chemical solvents e g alcohol or polishers to clean Installation Connection and Useof Safety Valve The safety valve should be connected to the cold water inlet pipe Please check carefully if the direction is correct after installation The correct direction of installation is thatthe arrowhead onthe safety valve should point tothe water heater If your water heater is notinstalled in abathroom with sewage drain please connect the drain hose
7. ith loose plug otherwise accidents like electric shock short circuit and fire may occur Make sure power plug closely fits with power socket O For first use after installation the tank must be full of water before connecting the power Otherwise heating element overheat may cause troubles Children taking shower mustbe attended by adults OPlease do not point the showerhead towards human body when turning on or off the faucet avoiding to bescalded by a small stream ofhot water Damaged power cord must be replaced by after service technicians with special cable factory provided Other persons shall not dismantle or repair In addition do not place flammable matters nearby the water heater In winter in cold regions for long term out of use please liftthe safety valve handle to empty the water avoiding ice formation damaging the waterheater The product adopts Haier Safe Care patented technology In normal installation even in severe case that ground wire is live due to wrong connection the product Safe Care technology can filter and efficiently ensure your safety However whenever your feel a sensory current please pull out the power plug and notify local after service men in time Do not dismantle by yourself Description of the Symbols OQ Never do that Q Be sure to act as per instructions Setting Environment No Jove Do not locate in freezing places If
8. llation Installation 2 22 24 2 625666 a 6 7 professional repair untilthe mark goes off Pre safe Expert will become the electric safeguard for your Attentions in installation 7 Operation Operation instructions 8 Attentions in operation 8 FAQ After service Cleaning and maintenance 8 9 FAQ sis rinite nE TECE E A 9 Packing list ceee 9 Friendly hints 055520 03 10 See to the physical product forthe appearance color or pattern Friendly Hints 1 If water supply cutoff occurs in your home please disconnect the power Before connecting power again please open mixing valve to the mostest pitch ofthe hot water watch the showerhead until water comes out indicating tank is full and close mixing valve This can ensure alonger life ofheating element 2 If you live in high rise apartment with water pressure beyond rated range e g more than 0 75 MPa it is suggested you purchase a pressure reducing valve which can ensure reliable operationand normal service life of the water heater Note Abovehints only applyto electric waterheaters 10 Cleaning and Maintenance O Internal Cleaning To ensure high working efficiency heating elements and tank liner of water heater shall be cleaned once in three years Take care not to damage protection layer on heating elements and tank liner inner surface If maintenance is needed please contactlocal service s
9. roduct The water heater you purchased may not full comply with the manual due to the improvement of product We apologize forthe inconvenience occurredtherefrom Features 1 Safe High quality importedheat resistant stainless steelheating element corrosionresistant and more reliable Over temperature protection tank liner over pressure protection and Safe Care patented design together with the function of monitoring and displaying of live ground wire have become areal safeguard forfamily safety 2 Durable Specially treated shell Elegant and durable Tankliner produced with 3 layer liner enameling technology More reliable quality 3 Easy to use Heating temperature adjustable Easy and flexible operation Water temperature adjustable between inlettemperature 75C 4 Multi purpose Closed structure suitable to connect several outlets for water use in locations like washroom and kitchen outlet water is not suitable to drink Suitable for use in homes enterprises and institutions and service tradelike hair amp beauty saloons 5 Horizontal installation elegantstyle and spacesaving Yourwater heater isan improved productof this series Please use itas instructed in this manual Parameters Rated voltage 220V 50Hz Power 1500 W Rated pressure 0 75 Mpa Waterproof grade IPX 4 A Dimensions see to Fig 1 Weight see to Fig 1 Volume see to Fig 1 Tap water pressure not less than0 05 MPa Dimension
10. s Fig 1 Front View al z j en0608 b1 Cutaway View d1 Bottom View 5 isl Si a T z Ji as A A B C1 Model voume wernt a1 b1 c1 d1 e1 f1 AHotwater outlet B Cold water inlet FeDz40 m 40L 18 Ske 702mm 380mm 100mm 220mm 350mm 261mm C Heating element Fco D Enamel tank JTHO50 II E SOL 20 Okg 680mm 435mm 100mm 200mm 400mm 240mm E AOIN OTACKET TEE 6OL 22 8kg 780mm 435mm 100mm 300mm 400mm 240mm JTHC80 I E 80L 28 Okg 900mm 459mm 100mm 282mm 432mm 240mm Remarks the permitted error limit of above parameters is 10 Electric Circuit Diagram BT L L Brown wire N ay N Blue wire MT High temperature limiter BT Thermostat HL Heating indicator EH Heating element E Yellow green wire GHL Uitte tt Operation Instructions O For the first use after installation due to there s no water within the tank first the city water inlet valve and any water outlet valve of the water heater must be opened Close the water outlet valve when water flows out continuously from the showerhead or other outlets the tank is full Check connections are free of water leakage and insert the power plug Turn the knob to set your desired water heating temperature which can be s
11. tation FAQ Problems Possible Causes to be Confirmed Corrective Measures If water supply is stopped or water pressure is too low Check No outlet water If use point is blocked or if hot water Check and clean valve is open Heating lamp lighted If heating element is damaged Contact service station Outlet water is cold Heating lamp not Connect power lighted If power is connected If thermostat is out of work Contact service station Heating lamp keep lighted Water hasn t reached temperature setting Continue heating for long If thermostat is out of work Contact service station Outlet water flow and temperature is not steady If city water pressure is steady Check Packing List Electric Name water Safety Expansion Expansion User s heater valve Drain hose bolt hook manual set pes ply pes pcs copy Quantity 1 1 1 2 2 1 9 Before Usage Dear User Thanks for choosing Haier waterheater product Haier products have good quality and excellent performance To facilitate youto use the product please read the manual and operate accordingly Please retain it for future reference The international star service of Haier Group willalways accompany you Nomatter what kind of problems you meet in usage please contact with the local after sales service agent We are at your serviceall the time Thanks again for choosing Haier P
12. tepless changed between cold water inlet temperature and 75 C In heating mode heating lamp is lighted on Normally the knob shall be positioned at highest temperature This machine has athermostat function which automatically switches off the water heater when temperature reaches the setting value and switch on again when water temperature decreases tocertain value City water pressure 20 75 MPa will cause much water flowing out from safety valve pressure relief vent This is due to too big water pressure Please ask after sales service for correction Attentions in Operation 1 To avoid causing machine troubles do not connect power before tank is full of water 2 Adjust a suitable temperature before use for water temperature above 50 C may burn your skin 3 This product isclosed water heater which cansupply hot waterthrough pipe connection to several points like bathroom bathtub washbasin showerhead andkitchen 4 Heating adjustment can be made flexibly all year round adapting to climate changes In long term out of use or maintenance you canclose city water pipe valve open mixing valve and moveup safety valve handle to drainthe tank Toavoid injury before nextuse it is suggested to first open hot water valve before switching on the water heater exhausting gas possibly retained in the pipeline In this case no smoke or fire is permitted near the open valve Carefully check and confirm all parts are in good condition 5 Provide
Download Pdf Manuals
Related Search