Groupe SEB USA - T-FAL 912471 Baby Monitor User Manual
Contents
1. can only function if they are adjusted to the same channel There are 3 different channels select the channel which offers the best reception quality depending on the circumstances If reception is poor or if you receive neighbouring noises change the transmission channel of the receiver at the back of the device and that of the transmitter under the device 2 OPERATING THE BABYPHONE The transmitter e ON OFF 0 1 BUTTON Press the 0 1 button it will put the device into operation If the lightis blinking green the device is on standby no noise is detected in the room constantly on noise is detected and transmitted Off neither the battery nor the power network function blinking red the battery is down and the power network is not connected To stop the device press the 0 1 button again e MUSICAL FUNCTION Ithelps baby to fall asleep Press the fe button it triggers a melody which lasts 4 minutes and Stops automatically To stop press ff again e NIGHTLIGHT FUNCTION Press the X button It triggers the nightlight which turns off after 10 minutes and lights again as soon as the child cries To stop the nightlight press the 2 button again The receiver e ON OFF 0 1 BUTTON Press the 0 1 button it puts the device into operation The 1st indicator on the left blinks green as soon as the device is operating If it blinks very rapidly change the batte2. Scheme 7005 edition A undersigned M P de WASSEIGE Standards M anager declare that the equipment above mentioned is in conformity with the European directive 99 5 CE R amp TTE These products are in compliance with the EC standards EN 301 489 3 ed 00 and EN 301 357 1 ed 01 These products are in compliance with the ERC Decision of 12 March 2001 on harmonised frequencies technical characteristics and exemption from individual licensing of Short range devices used for Wireless Audio Applications operating in the frequency 863 865 Mhz ERC DEC 01 18 and the harmonised frequencies used is include the frequencies band for Babyphone 864 800 to 865 Mhz They were the subject of an opinion by the notified body n 0413 Signed at RU MILLY on June 30 2002 P de WASSEIGE Standards M anager a
3. The maximum range is 400 m without obstacles Like all devices which use radio waves the range of the BABYPHONE depends on its environment which is variably favourable to correct propagation of waves Thus in certain places its range may be greatly reduced 3 INSTRUCTIONS BATTERIES Do not throw batteries into a fire Batteries must be recycled They must not be thrown in trash cans but put in recipients to this effect e For the DIGITAL WATCH BABYPHONE model U sing batteries The receiver is powered by rechargeable AAA type LRO3 1 2 volt Ni Mh batteries Only recharge the batteries with the adapter delivered with your device Any other means of charging may damage the device Do not leave the batteries connected to the adapter at all times overcharging may shorten their service life Charging and discharging the batteries New batteries only reach their maximum performance potential after having been charged and discharged completely two or three times They may be charged and dis charged hundreds of times but they wear down with time When the operating endurance is shorter than normal you must purchase new batteries If they remain unused batteries discharge after a certain amount of time Adapter Disconnect the adapter when not in use The receiver may be used when it is being charged except when using for the first time when the device must be charged for approximately 12 hours be
4. a service life of approximately 10 days Inserting the batteries Disconnect from the power network before inserting the batteries Open the back of the device by pressing the large button at the top Insert a screwdriver in the slit of the compartment to unclip the small cover Turn the device over to remove the black box from its lodging more easily Position the batteries in the box matching the and marks indicated the negative end of the battery is always placed on the spring side Reposition the black box in its lodging Clip on the cover Reposition the back of the device and press the 2 parts together until a click is heard The transmitter must be installed at a certain height in an upright position at a distance of 1 metre minimum and 3 metres maximum from the child e Put into operation by pressing the 0 1 button Installing the receiver The WATCH BABYPHONE model operates on alkaline batteries which are not supplied The DIGITAL WATCH BABYPHONE model operates on rechargeable batteries already inserted in the device Putting the WATCH BABY PHONE model into operation Visual Loudspeaker button adjustment Inserting the batteries Open the rear shell of the receiver by removing the two screws with a screwdriver Position 3 AAA type LRO3 batteries in the box matching the and marks indicated on the batte
5. DIGITAL WATCH BABYPHONE Transmitter Emisor Npnemuuk Verici WATCH BABYPHONE Transmitter Emisor Npnemunk Verici Receiver Receptor Mepegatuuk Al c Receiver Receptor Mepegatuuk Al c DIGITAL WATCH BABYPHONE amp WATCH BABYPHONE TEFAL has created devices to simplify the lives of young mothers They combine advanced technology and practical use They are both attractive and intelligent BABYPHONE by TEFAL with its transmitter receiver duo is a high performance reliable and clever device to watch over your baby when sleeping or playing Its musical function will allow you to put baby to sleep gently With the portable receiver wrist attachment and its long functional endurance BABYPHONE is a mobile product you may thus remain in contact with your child while moving around in your home H ow to use this device BEFORE USING FOR THE FIRST TIME READ THE INSTRUCTIONS CAREFULLY SAFETY INSTRUCTIONS IN NO CASE CAN THIS PRODUCT REPLACE ADULT SUPERVISION OF A CHILD Keep the transmitter and receiver away from children Never place the transmitter in the child s bed or play pen amp Place both devices away from sources of heat or water projection amp Only use the adapter supplied with the device Any other power source may damage the product amp Do not use an extension cord Allow for space around the devices and the adapter for correct ventilation The adapter must be easily a
6. ccessible and the electric wire must be kept out of passageways and out of reach of children Do not pull on the wire to disconnect If not used for a long period of time disconnect the transmitter and remove the batteries from the transmitter and receiver for the WATCH BABYPHONE Model amp When the transmitter batteries are down replace all of them with new batteries Never disassemble the devices In compliance with the new regulations which no longer authorise continuous transmission of noise the transmitter is only triggered by a minimum sound level It is therefore normal that the receiver remain completely silent when the transmitter is on stand by and when its green light is blinking 1 INSTALLING THE BABYPHONE The BABYPHONE by TEFAL is composed of 2 elements a transmitter which receives and sends out sounds and which is to be placed near the baby and a receiver which restores the message at a distance and which you must keep near you Installing the transmitter e It must be connected to the power network at all times The adapter transmitter is marked on its label connects under the base of the device its wire must be fully extended To ensure the relay in case of a power failure or to occasionally use BABYPHONE where there is no electricity 4 AAA LRO3 1 5 volt alkaline batteries may be placed in the device During normal operation i e for 10 to 12 hours per day the batteries have
7. fore putting it into service MAINTENANCE Use a slightly damp cloth without detergent Do not allow any liquid to enter the inside of the devices TROUBLESHOOTING QUESTIONS There is no sound Reception is weak The receiver transmits a high pitched whistling sound Larsen effect Reception is poor or other signals are received e A beep sounds on the receiver level e On the DIGITAL WATCH BABYPHONE model the reception indicator blinks e Check that the device is turned on correctly the indicators should be lit At the transmitter level check that the adapter is connected and that the power network is operating Check that the sound volume of the receiver is not at minimum and that both devices are placed on the same channel Reduce the distance between the transmitter and the receiver or move the receiver M ove the transmitter away from the receiver Lower the volume of the receiver Change the channel of the transmitter and the receiver M ake certain they are on the same channel Reduce the distance between the transmitter and the receiver M ove the receiver away from televisions stereos video recorders No transmission check that the transmitter is in operation M ove closer to the transmitter the sound signal will stop since you moved out of the receiving field and were no longer in contact with your transmitter lost the radio connection Check that the tran
8. ries for the WATCH BABYPHONE model recharge the device for the DIGITAL WATCH BABYPHONE model To stop the receiver press the 0 1 button again All of the indicators turn off e SUPERVISING MODES There are two supervising modes sound and visual plus a vibrator function wo for the DIGITAL WATCH BABYPHONE model Visual supervision The 4 indicators light progres sively when the device receives a transmission They provide the amplitude of the noise transmitted Sound supervision The sound is adjusted using the buttons on the DIGITAL WATCH BABYPHONE model visual bars indicate the intensity of the sound e STORING THE RECEIVER IN SID E TH E TRANSMITTER To transport the device easily and to optimise its storage the transmitter may be lodged inside the receiver devices off Open the back of the transmitter by pressing the large button at the top Install the receiver on its bracelet Hook the receiver and bracelet inside the rear shell folding the bracelet carefully Close the device until you hear a click Supervising with the vibrator function Only on the DIGITAL WATCH BABYPHONE model This function offers a supervising mode which is discrete under all circumstances Press the w button it activates the vibrator function which appears on the screen As soon as a sound is received the device vibrates To stop press the button again
9. ry box the negative end of the battery is always placed on the spring side Close and screw the rear shell back down Warning after the batteries have been inserted your device turns on automatically e Putting the DIGITAL WATCH BABYPHONE model into operation Digital Loudspeaker display Visual monitoring Sound volume adjustment Reception indicator Vibrator Batteries function indicator When using for the first time the device must be recharged for 12 hours Connect the adapter receiver is indicated on its label on the left side of the receiver Connect to the power network When putting the device into Operation the battery indicator of the digital display indicates the battery charge level when using for the first time it is important that they be fully charged O perating possibilities BABYPHONE is a portable product which offers several operating possibilities to meet your needs with regards to mobility or discretion may be installed preferably in an elevated position may be attached to your belt may be worn on your wrist with the bracelet delivered with the device Imply clip the receiver to the plastic support and position on your wrist attach the bracelet using the pin on the plastic support e Put into operation by pressing the 0 1 button Selecting the channels The transmission principle is that of radio waves the two devices
10. smitter and the receiver are on the same channel TROUBLESHOOTING The light indicator of the e Check that the adapter is transmitter 0 1 button correctly connected to the blinks red power network and or change the batteries e On the receiver the 1 light e The batteries are down they indicator on the left blinks must be changed WATCH rapidly BABY PHONE e The battery indicator blinks Recharge your device for and or the vibrator no 10 hours DIGITAL WATCH longer operates on the BABY PHONE DIGITAL WATCH BABYPHONE model The sound lever cannot be adjusted 2 YEAR GUARANTEE as of the date of purchase against any defect in manufacturing The guarantee does not cover deterioration due to abnormal or abusive use nor to disassembly of the device The power and voltage are indicated on the device If a power supply cable is damaged it must only be replaced by a repair workshop recognised by the manufacturer since special tools are necessary The Tefal company reserves the right to modify the characteristics or components of the product at any time in the interest of the consumer DECLARATION OF CONFORMITY AT THE EUROPEAN DIRECTIVE 99 5 CE PRESENTER SNAME TEFALS A BP 89 ZI des Granges 74156 RUMILLY CEDEX FRANCE MANUFACTURER S NAME TEFALS A BP 89 ZI des Granges 74156 RU MILLY CEDEX FRANCE DESCRIPTION OFTHE EQUIPMENT Edition scheme n Digital Watch Babyphone and Watch Babyphone
Download Pdf Manuals
Related Search