Fisher-Price T4839 Baby Monitor User Manual
Contents
1. ness www fisher price com IMPORTANT To prevent electric shock do not immerse in water wipe clean with damp cloth AN WARNING To prevent strangulation with power cord never place transmitter within reach of child This product cannot replace responsible adult supervision IMPORTANT e For proper setup and use please read these instructions e Please keep this instruction sheet for future reference as it contains important information e Transmitter operates on AC current use enclosed AC adaptor or DC current four AAA batteries included e Receiver operates on AC current use enclosed AC adaptor or DC current three AAA LRO3 alkaline batteries not included Note A plastic tab is attached to the transmitter for in store demonstration purposes While the tab may have already been removed check the transmitter to be sure If the plastic tab is still attached pull and remove the tab from the transmitter Throw the plastic tab away e Adult setup is required e Tool needed for battery installation Phillips screwdriver not included e This product is not intended to be used as a medical monitor and its use should not replace adult supervision e Test sound reception of receiver before first time use and whenever you change location of the transmitter e Jo prevent entanglement Never place transmitter in a crib or playpen Keep transmitter and receiver out of baby s reach Never us2. battery power refer to the Battery Installation section e Turn the power volume dial to turn the power ON Turn the dial to adjust the volume to a comfortable listening level e Clip the receiver onto your clothes to stay in touch with baby around your house or yard Hint The receiver s range is up to 900 feet 274 m away from the transmitter The range indicator will flash and you will hear beeping when the receiver is out of range Problems amp Solutions Problem _ Sowin Receiver range indicator light flashes Receiver is out of range of transmitter Move receiver closer to transmitter and you hear beeping Note Range varies depending on surrounding conditions such as noise levels physical obstructions and signal interference Channel switch on transmitter and receiver are not the same Switch transmitter and receiver to the same channel Transmitter power is off Turn transmitter power on Batteries in receiver are weak or dead Replace all batteries with three AAA LR03 alkaline batteries or use the AC adaptor as a power source No power to wall outlet and transmitter power is off Make sure light switch that controls power flow to wall outlet is on Power is off because circuit breaker for room is off Make sure house fuses and circuit breakers are on Receiver power L E D does not light Receiver power is off Turn receiver power on at all Batteries in receiver are weak or dead Replace all ba
3. e extension cords with the AC adaptors e Adults Note Periodically examine the AC adaptors for damage to the cord housing or other parts that may result in the risk of fire electric shock or injury If an AC adaptor is damaged do not use it e Never use transmitter or receiver near water i e bathtub sink wet basement etc e Always use the transmitter and receiver where there is adequate ventilation To prevent overheating keep the transmitter and receiver away from heat sources such as radiators heat registers direct sunlight fire stoves amplifiers or other appliances which produce heat e Do not connect the transmitter or the receiver if AC adaptor is used to more than the recommended number of power supplies e An AC adaptor is not a toy e Disconnect the AC adaptor from the transmitter and receiver before cleaning e Fisher Price does not recommend the use of two monitors in one house e Always remember that you are using public airwaves when using your monitor Conversations even from rooms near your transmitter may broadcast to other nursery monitors radios cordless telephones or scanners outside your home To protect the privacy of your home always turn off the transmitter when not in use e Carrier Frequency 900 MHz e Product features and decoration may vary from photographs CONSUMER ASSISTANCE AYUDA AL CONSUMIDOR SERVICE A LA CLIENTELE 1 800 432 5437 US amp Canada service fisher price com Fish
4. er Price Inc 636 Girard Avenue East Aurora NY 14052 Hearing impaired consumers Clientes con problemas auditivos Pour les malentendants 1 800 382 7470 En M xico 59 05 51 00 Ext 5205 6 01 800 463 59 89 Fisher Price Inc a subsidiary of Mattel Inc East Aurora NY 14052 U S A 2010 Mattel Inc All Rights Reserved and TM designate U S trademarks of Mattel Inc PRINTED IN CHINA T4839a 0920 Features Transmitter D A w Receiver SIDE VIEW Features 1 Nightlight Button Press to turn on a soft glow 2 Nightlights 3 Power Button and L E D 4 Microphone 5 Nightlight Timer Switch Turn on for 30 minutes of light 6 Channel Switch Choose from four different channels D Power Volume Dial Power L E D and Range Indicator Lights when receiver power is ON flashes and you ll hear a tone too when the receiver is out of range of transmitter 9 Sound Lights Watch these lights to see baby s sounds Start Stop Button Press the button to start the nap timer press the button again to stop the nap timer Press and hold the button to set the clock time D Reset Button Press and hold the button to reset the nap timer Use this button in clock set mode to make selections 12 LCD Screen 13 Channel Switch Choose from four different channels Clip backside of receiver Fasten to your clothes to stay in touch with baby around the house or yard Receiver Bat
5. nd Use Power Button and L E D Channel Switch Nightlight Timer Switch Gm w Nightlight Button e Place the transmitter in the same room with child Point the microphone towards the crib or play area e Set the transmitter channel switch to the same channel as the receiver e Unwrap and fully extend the AC adaptor for best transmission Insert the AC adaptor pin into the DC Input jack on the transmitter and plug into a standard wall outlet Use the AC adaptor only in a wall outlet Do not plug into a ceiling outlet Note To use battery power refer to the Battery Installation section e Press the transmitter power button to turn the power ON The power L E D will light e Press the nightlight button for a soft glowing light Press again to turn the nightlight off e Slide the nightlight timer switch to turn the timer on When the timer is on the nightlight will automatically shut off after 30 minutes To turn the nightlight back on for another 30 minutes simply press the nightlight button again Setup and Use Power Volume Dial GO Range i j Indicator Sound Lights e Place the receiver where you can see and hear it e To use AC power unwrap and fully extend the AC adaptor cord for best reception Insert the AC adaptor pin into the DC input jack on the receiver and plug into a standard wall outlet Use the AC adaptor only in a wall outlet Do not plug into a ceiling outlet Note To use
6. ods of non use Always remove exhausted batteries from the product Dispose of batteries safely Do not dispose of this product in a fire The batteries inside may explode or leak e Never short circuit the battery terminals e Use only batteries of the same or equivalent type as recommended e Do not charge non rechargeable batteries e Remove rechargeable batteries from the product before charging e f removable rechargeable batteries are used they are only to be charged under adult supervision Testing Sound Reception Test transmitter and receiver reception each time you change location of use e Place the transmitter in the room where you intend to use it e Set the transmitter channel switch to the same channel as the receiver e Press the transmitter power button to turn the power ON The power L E D lights Turn on a radio Testing Sound Reception Power Volume Dial Sound Lights Channel Switch Range mou Indicator SIDE VIEW e Place a receiver in the room where you Intend to use it e Set the receiver channel switch to the same channel as the transmitter e Turn the power volume dial to turn the power ON Wait a few seconds to see if you have a good signal If the range indicator light blinks along with beeping you are out of range Move the receiver closer to the transmitter e When sound is picked up by the receiver the sound lights turn on One or two lights indicate q
7. proved by the manufacturer responsible for compliance could void the user s authority to operate the equipment Monitor Model Number T4839 This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation Monitor Consumer Relations Department 636 Girard Avenue East Aurora New York 14052 U S A ICES 003 NMB 003 This Class B digital apparatus complies with Canadian ICES 003 Operation is subject to the following two conditions 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation NMB 003 Cet appareil num rique de la classe B est conforme a la norme NMB 003 du Canada Lutilisation de ce dispositif est autoris e seulement aux conditions suivantes 1 il ne doit pas produire de brouillage et 2 l utilisateur du dispositif doit tre pr t a accepter tout brouillage radio lectrique regu m me si ce brouillage est susceptible de compromettre le fonctionnement du dispositif Care e Excess dirt in the transmitter microphone will hamper transmission of sound Clean the outer surface of the transmitter and the receiver with a cloth lightly dampened with a mild cleaning solution e Never immerse the transmitter recei
8. tery Installation Optional Hint We recommend using alkaline batteries for longer battery life e Locate the battery compartment door on the back of each receiver e Loosen the screw in each battery compartment door with a Phillips screwdriver Remove each battery compartment door e Insert three AAA LR03 alkaline batteries into each battery compartment e Replace each battery compartment door Tighten the screw with a Phillips screwdriver Do not over tighten Transmitter Battery Replacement _ 1 5V x4 AAA LRO3 For best performance we recommend replacing the batteries that came with the transmitter with four new AAA LRO3 alkaline batteries e Locate the battery compartment door on the bottom of the transmitter Loosen the screws in the battery compartment door Remove the door e Insert four AAA LR03 alkaline batteries into the battery compartment e Replace the battery compartment door and tighten the screws Hint You can also use the included AC adaptor to power the transmitter Battery Safety Information In exceptional circumstances batteries may leak fluids that can cause a chemical burn injury or ruin your product To avoid battery leakage e Do not mix old and new batteries or batteries of different types alkaline standard carbon zinc or rechargeable nickel cadmium Insert batteries as indicated inside the battery compartment e Remove batteries during long peri
9. tteries with three AAA LR03 alkaline batteries or use the AC adaptor as a power source Power is off because circuit breaker for room is off Make sure house fuses and circuit breakers are on No power to wall outlet and power is off Make sure light switch that controls power flow to wall outlet is on Receiver 1 transmitter 2 battery Batteries are weak or dead Replace all batteries with new AAA LR03 indicator is only partially filled alkaline batteries or use the AC adaptor as a power source Receiver screen is fading Batteries are weak or dead Replace all batteries with new AAA LR03 alkaline batteries or use the AC adaptor as a power source Transmitter power L E D does not Transmitter power is off Turn transmitter power on light at all Batteries in transmitter are weak or dead Replace all batteries with four AAA LR03 alkaline batteries or use the AC adaptor as a power source Check transmitter power cord plug to outlet connection No power to wall outlet and transmitter power is off Make sure light switch that controls power flow to wall outlet is on Power is off because circuit breaker for baby s room is off Make sure house fuses and circuit breakers are on You can hear conversations or There is signal interference due to other nursery monitors on same channel sounds from other homes or cordless telephone use Change channel switches on both transmitter and receiver to eliminate so
10. uieter sounds Three or more lights indicate louder sounds e f the range indicator begins fl ashing you may be experiencing interference Try selecting a different channel on both the receiver and transmitter If the range indicator continues to fl ash move the receiver closer to the transmitter Setup and Use Nap Timer Clock Set e Turn receiver power ON e Press and hold the start stop button gt to choose 12 hour or 24 hour clock format Press the reset button lt to make a choice e Press the start stop button gt The hour number on the clock will flash Press the reset button to scroll through hour choices e Press the start stop button The minute numbers on the clock will flash Press the reset button to scroll through minute choices e Press the start stop button gt to confirm your selections and complete the clock setup Receiver Battery Indicator Transmitter Battery Indicator Nightlight Indicator Clock Nap Timer Note The nap timer will move to the top of the LCD screen when it is in use e Press the start stop button to start the nap timer Press again to stop the time e Press and hold the reset button gt to clear the timer Battery Indicator e Displays the battery charge level of the receiver 1 and the transmitter 2 When battery power is low the battery icon will appear partially filled Nightlight Indicator e Indicates the transmitter nightlight is on Setup a
11. urce of interference Clock nap timer is not working or is Reset the receiver by removing the batteries and replacing them in functioning erratically the receiver Hint If after checking all of these solutions you believe that your transmitter power cord or AC adaptor are damaged please contact Fisher Price 14 FCC Statement united States only This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Note Changes or modifications not expressly ap
12. ver or AC adaptors e Protect the environment by not disposing of this product with household waste 2002 96 EC Check your local authority for recycling advice and facilities Europe only
Download Pdf Manuals
Related Search