Craftsman 247.29876 Tiller User Manual
Contents
1. PAN You may Flamb be burned Clean ventilating fans frequently Grease DO NOT USE WATER including wet dish should not be allowed to accumulate on fan or cloths or towels A violent explosion will result filter Use an extinguisher ONLY if Use proper pan size Alwaxs use cookware appropriate for the size of the surface element 1 You know you have a Class ABC extin guisher and you already know how to Cauition Grease left on filters can remelt and operate it move IMONE vent The fire is small and contained in the area where it started When children become old enough to use the The fire department is being called appliance it is the legal responsibility of the parents or legal guardians to ensure that they are instructed in safe practices by qualified persons You can fight the fire with your back to an exit WARNING Whenever possible do not operate blower during a cooktop fire However DO NOT REACH THROUGH FIRE TO TURN OFF BLOWER PAGE 3 SAFETY INSTRUCTIONS PAGE 4 A Carefully clean the extractor hood before switching on for the first time AN Do not place any objects on the extractor hood AN The sliding surfaces of the filter drawer must not be dirty Slide marks may occur However these will not impair function AN When moving the filter drawer do not place hand in the marked areas danger of crushing FEATURES Chimney panelling Light fan switches2. hobs and ovens PAGE 5 IMPORTANT NOTES Q The Instructions for Use apply to several versions of this appliance Accordingly you may find descriptions of individual features that do not apply to your specific appliance Q This extractor hood complies with all relevant safety regulations Repairs should be carried out by qualified technicians only Improper repairs may put the user at considerable risk Q Before using your appliance for the first time please read these Instructions for Use carefully They contain important information concerning your personal safety as well as on use and care of the appliance L1 Please retain the operating and installation instructions for a subsequent owner TRANSPORTATION PROTECTION DEVICE Q The transportation protection device prevents the filter drawer from sliding out Q Check that the fitter has removed the transportation protection device see installation manual Q Please retain the transportation protection device in case you move house GAS HOBS GAS COOKERS AN Do not use all the gas hotplates simultaneously for a prolonged period max 15 minutes at maximum thermal load otherwise there is a risk of burns if the housing surfaces are touched or a risk of damage to the extractor hood If the extractor hood is situated over a gas hob operate the hood at maximum setting if three or more gas hotplates are operated simultaneously OPERATION AN The most effecti
3. the supply circuit is energized CL Make sure that the blower speed control knob is not in the OFF position CQ The manufacturer of the extractor hoods accepts no liability for complaints which can be attributed to the design and layout of the pipework How to obtain Service For authorized service or parts information call 1 800 735 4328 We want you to be a satisfied customer If a situation arises that has not been resolved to your satisfaction please let us know Write Customer Support BSH Home Appliances Corp 5551 McFadden Ave Huntington Beach CA 92649 or call 1 800 735 4328 Please include the model number serial number and date of original purchase installation PAGE 10 CUSTOMER SERVICES Warranty What is Covered Full One Year Warranty For one year from the date of installation or date of occupancy for a new previouslyunoccupied dwelling any part which fails in normal home use will be repaired or replaced free of charge Save your dated receipt or other evidence of the installation occupancy date BSH will pay for all repair labor and replacement parts found to be defective due to materials and workmanship Service must be provide by a BSH Authorized Service Agenoy during normal working hours What is not Covered 1 Service by an unauthorized agency Damage or repairs due to service by an unauthorized agency or the use of unauthorized parts 2 Service visits to Q Teach you how to use the
4. Thermador An m oaa DOWNDRAFT USE AND CARE MANUAL MODEL HDDW 36DS i TN NC as u I AN i N i a E gt m 4 4 TABLE OF CONTENTS Safety Instructions dekani 344 Replacing the Bulbs 9 Features PPP 5 Troubleshooting guide 10 Operation 4444 TT 6 Customer Services 10111 Filters and Maintenance 7 Before Calling for Service 10 Care and Cleaning 8 Cover How to Obtain Service 10 Warranty d qb eti 11 Data Plate Information 11 Fig 1 GAZ ELECTRO PAGE 2 ZN IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE READ AND SAVE THESE INSTRUCTIONS WARNING TO REDUCE THE RISK OF A RANGE WARNING TO REDUCE THE RISK OF INJURY TOP GREASE FIRE TO PERSONS IN THE EVENT OF A COOKTOP GREASE FIRE OBSERVE THE FOLLOWING 8 Never leave surface units unattended at high settings Boilovers cause smoking and greasy a SMOTHER FLAMES with a close fitting lid spillovers that may ignite Heat oils slowly on cookie sheet or metal tray then turn off the low or medium settings burner BE CAREFUL TO PREVENT BURNS Always turn hood ON when cooking at high CURIE AND UU heat or when flamb ing food i e Crepes Suzettes Cherries Jubilee Peppercorn Beef NEVER PICK UP A FLAMING
5. appliance Q Correct the installation You are responsible for providing electrical wiring and other connecting facilities Q Reset circuit breakers or replace home fuses 3 Damage resulting from accident alteration misue abuse improper installation or installation not in accordance with local electrical codes or plumbing codes or improper storage of the appliance 4 Repairs due tro other than normal home use Warranty Application This warranty applies to appliances used in normal family households It does not cover their use in commercial situations This Warranty is for products purchased and retained in the 50 states of the U S A the District of Columbia and Canada The warranty applies even if you should move during the warranty period Should the appliance be sold by the original purchaser during the warranty period the new owner continues to be protected until the expirationm date of the original purchaser s warranty period BSH DOES NOT ASSUME ANY RESPONSIBILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you This warranty gives you specific legal rights and you may also have other rights which may vary from state to state or province to province Service Data For handy reference the serial tag information has been affixed below Keep your invoice for warranty va
6. dirt but wipe off with a damp cloth PAGE 8 REPLACING THE BULBS 1 Switch off the extractor hood and pull out the mains 3 Replace the halogen light bulb conventional halogen plug or switch off the electricity supply at the fuse box bulb 12 Volt max 20 Watt G4 bulbholder Caution Plug in bulbholder When switched on the halogen bulbs become very Take hold of the bulb with a clean cloth hot Even for some time after the bulbs have been switched off there is still a risk of burns 2 Remove the bulb ring with a screwdriver or similar tool 4 Re insert the bulb ring 5 Restore the power by inserting the mains plug or Switching on the fuse Note If the light does not function check that the bulbs have been inserted correctly PAGE 9 TROUBLESHOOTING GUIDE Problem Possible Cause Remedy Nothing vvorks display is not Control button board has become Contact qualified appliance service illuminated disconnected technician If an or appears in the display Filters saturated See Filters and Maintenence Section If is not possible to operate the Power failure Disconnect the extractor hood from extractgor hood the mains electricity supply by pulling out the plug or switching it off at the main fuse box Wait for approx 1 minute and then Switch it on again CUSTOMER SERVICES Before Calling for Service If the blower does not operate Q Ensure that the electrical cord is properly connected and
7. eooehoo Filter grille Lighting EXHAUST AIR MODE Q The extractor hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere Q The grease filter absorbs the solid particles in the kitchen vapours O The kitchen is kept almost free of grease and odours When the extractor hood is operated in exhaust air mode simultaneously with a different burner which also makes use of the same chimney such as gas oil or coal fired heaters continuous flow heaters hot water boilers care must be taken to ensure that there is an adequate supply of fresh air which will be needed by the burner for combustion Safe operation is possible provided that the underpressure in the room where the burner is installed does not exceed 4 Pa 0 04 mbar This can be achieved if combustion air can flow through non lockable openings e g in doors windows and via the air intake exhaust air wall box or by other technical measures such as reciprocal interlocking etc If the air intake is inadequate there is a risk of poisoning from combustion gases which are drawn back into the room An air intake exhaust air wall box by itself is no guarantee that the limiting value will not be exceeded Note When assessing the overall requirement the combined ventilation system for the entire household must be taken into consideration This rule does not apply to the use of cooking appliances such as
8. iance from the power supply before servicing Do not clean the extractor hood with abrasive Q When cleaning the grease filters remove grease sponges or with cleaning agents which contain sand deposits from accessible parts of the housing soda acid or chlorine This prevents the risk of fire and ensures that the extractor hood continues operating at maximum To facilitate cleaning pull out the filter dravver efficiency ser Nand Q Note Do not use alcohol spirit on plastic surfaces as dull marks may appear Caution Ensure that the kitchen is adequately ventilated Avoid naked flames Clean the operating buttons with a mild soapy solution and a soft damp cloth only Do not use stainless steel cleaner to clean the operating buttons Stainless steel surfaces Q Use a mild non abrasive stainless steel cleaner Q Clean the surface in the same direction as it has been ground and polished Q We recommend our stainless steel cleaner Fantastike or Formula 409 sprayed onto a paper towel Do not insert the filter drawer while cleaning it Aluminium and plastic surfaces Danger of crushing QO Do not use dry cloths Q Use a mild window cleaning agent Q Do not use aggressive acidic or caustic cleaners Observe the warranty regulations in the enclosed service booklet Q Clean the extractor hood with a hot soap solution or a mild window cleaner Q Do not scrape off dried on
9. lidation To obtain service see previous page Serial Number Data Plate Location Are to be found on the name plate inside the appliance after removal of the filter frame We reserve the right to change specifications or design without notice Some models are certified for use in Cananda BSH is not responsible for products which are transported form the U S for use in Canada Check with your local Canadian distributor or dealer PAGE 11 Thermador BA American Seon 5551 McFadden Avenue Huntington Beach CA 92649 800 735 4328 www thermador com 9000173706 10013 RevB 07 06 BSH Home Appliances Corporation Litho in U S A
10. nal is sounded for 6 seconds after the fan has switched off and an appears in the display The grease filters should be cleaned straight away Cleaning the metal grease filters Q In normal operation 1 to 2 hours daily the metal grease filter must be cleaned 1 x a month Q The filters can be cleaned in a dishwasher It is however possible that they will become slightly discoloured O The filter must be placed loosely and NOT wedged in the dishwasher Important Metal filters that are saturated with grease should not be washed together with other dishes etc Q When cleaning the filters by hand soak them in hot soapy water first of all Do not use aggressive acidic or caustic cleaners Then brush the filters clean rinse them thoroughly and leave the water to drain off Removing and inserting the metal grease filters Warning The halogen bulbs must be switched off and cool AN Before changing the grease filters ensure that the fil ter drawer has been pushed in 1 Press the catches on the front grease filters and fold down the grease filters 2 Press the catches on the rear grease filters and fold down the grease filters 3 Clean the grease filter 4 Insert the clean filters back into the hood 5 Cancel the in the display Q Press the button 0 CARE AND CLEANING AN WARNING To avoid risk of fire and explosion do not use flammable liquids or solvents Always unplug or disconnect the appl
11. s at setting 1 At the same time a dot flashes in the display Then the fan switches off automatically Lighting Q Briefly press the amp button to switch the light on and off Q The light can be switched on at any time even though the fan is switched off Q Adjusting the brightness Hold down the 4 button until the desired brightness is obtained Switching on the light automatically e g via a timer Fan and light must be switched off Switching on Simultaneously press the and 9I buttons Q After approx 3 seconds the light switches on to acknowledge the setting Switching off Repeat the process with the light switched on Q After approx 3 seconds the light Switches off to acknowledge the setting FILTERS AND MAINTENANCE GREASE FILTERS Metal filters are used to trap the greasy element of the vapours that develop during cooking The filter mats are made from non combustible metal Caution As the filter becomes more and more saturated with grease not only does the risk of it catching fire increase but the efficiency of the extractor hood can also be adversely affected Important By cleaning the metal grease filters at appropriate intervals the possibility of them catching fire as a result of a build up of heat such as occurs when deep fat frying or roasting is taking place is reduced Saturation indicator When the grease filters reach saturation point an acoustic sig
12. ve method of removing vapours produced during cooking is to Q Switch the ventilator ON as soon as you begin cooking Q Switch the ventilator OFF a fevv minutes after you have finished cooking Fan follovv on Display for fan setting Reduce fan Fan ON and speed increase speed Fan OFF Acoustic Signal QO When a button is pressed this is verified by an acoustic signal Switching off the acoustic signal Q Simultaneously press buttons 0 and until a signal is emitted after approx 3 seconds Switching on the acoustic signal QO Repeat the process Switching the fan ON Q Press the button or pull out the filter drawer Setting the required fan speed Q Press the button The fan speed is increased by one step Q Press the button The fan speed is reduced by one step PAGE 6 Switching the fan OFF Q Press the 0 button The displayed Li goes out shortly afterwards Or Q Keep pressing the button until the fan switches off The displayed Li goes out shortly afterwards Intensive setting Maximum power is obtained at the intensive setting It is only required for short intervals Q Keep pressing the button until appears in the display OQ If the intensive setting is not cancelled by hand the fan will automatically switch back to step after 10 minutes Fan follow on Q Press the gt I button or push in the filter drawer The fan runs for 10 minute
Download Pdf Manuals
Related Search