Clifford 11CX 562C Automobile Alarm User Manual
Contents
1. for 1 5 seconds to enter Panic Mode In Panic Mode the horn will honk and the parking lights optional will flash for 30 sec onds To stop Panic Mode at any time press cd or A on the transmitter NOTE In order for Panic Mode to be effective the vehicle s horn as well as the vehicle s parking lights must be connected 8 2004 Directed Electronics Inc Rapid Resume Logic This Directed Electronics system will store its current state to non volatile memory If power is lost and then reconnected the system will recall the stored state from memory This means if the unit is in Valet Mode and the battery is disconnected for any reason such as servicing the car when the battery is reconnected the unit will still be in Valet Mode This applies to all states of the system including arm disarm and Valet Mode Programming Options Programming options control your systems normal operational set up Most options do not require additional parts but some may require additional installation labor This system s programming options are listed below with the factory default settings in bold M Passive Mode or Active Mode In Passive Mode the Failsafe Starter Kill will automatically activate 30 seconds after the ignition has been turned off M The horn honk confirmations for locking and unlocking can be programmed on or off In order for this feature to be pro grammed on the horn must be connected to the system 202. 04 Directed Electronics Inc 9 Glossary of Terms Control Unit The brain of your system Usually hidden under neath the dash area of the vehicle It houses the microprocessor which monitors your vehicle and controls all system functions Failsafe Starter Kill An automatic switch controlled by your sys tem which prevents the vehicle s starter from cranking whenever the system is armed The vehicle is never prevented from cranking when the system is disarmed in Valet Mode or if the starter kill switch itself fails Your system has feature ready circuitry for the starter kill however installation may require additional labor LED A red light mounted at a discretionary location inside the vehicle It is used to indicate the status of your system Transmitter A hand held remote control which operates the var ious functions of your system Valet Switch A small push button mounted at a discretionary location inside the vehicle It is used to override the Failsafe Starter Kill when a transmitter is lost or damaged or to enter or exit Valet Mode 10 2004 Directed Electronics Inc Convenience Expansions Listed below are some of the many expansion options available for use with your system Some options may require additional parts and or labor Please consult with your dealer for a complete list of options available for use with this system Domelight Supervision The domelight will illuminate
3. 1 This device may not cause harmful interference and 2 This device must accept any interference re ceived including interference that may cause undesired operation Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate this device 4 2004 Directed Electronics Inc Transmitter Functions The receiver uses a computer based learn routine to learn the transmitter buttons This makes it possible to assign any specific transmitter button or combination of buttons to any receiver function The transmitter initially comes programmed with the Standard Configuration but may also be customized by an autho rized dealer The transmitter buttons indicated in all of the instructions in this manual correspond to a Standard Configuration transmitter Standard Configuration Configuration A Button The lock and panic functions are controlled by pressing A on the transmitter for one second d Button The unlock function is controlled by pressing d on the trans mitter for one second gb Button Silent Mode and an optional auxiliary function are controlled by pressing mk Silent Mode works by pressing af for less than one second 2004 Directed Electronics Inc 5 Using Your System EE Z Z Pressing A for one second arms the system by activating the starter kill The horn will honk and the parking lights optional will flash once to c
4. ARTICIPATING IN THE STREAM OF COM MERCE THEREWITH THIS EXCLUSION INCLUDES BUT IS NOT LIMITED TO THE EXCLU SION OF ANY AND ALL WARRANTY OF MERCHANTABILITY AND OR ANY AND ALL WAR RANTY OF FITNESS FOR A PARTICULAR PURPOSE AND OR ANY AND ALL WARRANTY OF NON INFRINGEMENT OF PATENTS IN THE UNITED STATES OF AMERICA AND OR ABROAD NEITHER THE MANUFACTURER OR ANY ENTITIES CONNECTED THEREWITH SHALL BE RESPONSIBLE OR LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING BUT NOT LIMITED TO ANY CONSEQUENTIAL DAMAGES INCIDENTAL DAMAGES TOWING REPAIR REPLACEMENT DAMAGES FOR LOSS OF TIME LOSS OF EARNINGS COMMERCIAL LOSS LOSS OF ECONOMIC OPPORTUNITY AND THE LIKE NOTWITHSTANDING THE ABOVE MANUFACTURER DOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE AS DESCRIBED ABOVE Some states do not allow limitations on how long an implied warranty will last or the exclusion or limitation of incidental or consequential damages This warranty gives you specific legal rights and you may also have other rights which vary from state to state IMPORTANT NOTE This product warranty is automatically void if its date code or serial number is defaced missing or altered This warranty will not be valid unless you have com pleted the warranty card and mailed it to Directed Electronics Inc within 10 days after purchase to the address listed on the warranty registration card Make sure you have all of the following information from your dealer A clear copy
5. L THE SCIENCE OF SECURITY CUFFORD Security system and convenience CLIFFORD 11CX 562C Series L LISER GUIDE I Limited Consumer Warranty For a period of one calendar year from the date of purchase of this device Directed Electronics Inc promises to the ORIGINAL PURCHASER to repair or replace with a comparable reconditioned model free of cost any electronic control module which proves to be defective in workmanship or material under normal use SO LONG AS THE SYSTEM WAS SOLD INSTALLED AND SERVICED BY A PROFESSIONAL AUTO INSTALLER AND REMAINS IN THE CAR IN WHICH THE SYSTEM WAS ORIGINALLY INSTALLED If war ranty service is necessary you must have a clear copy of your sales receipt contain ing all of the information shown on the following page After the first calendar year from the date of purchase of this device Directed Electronics Inc promises to the ORIGINAL PURCHASER to repair or replace with a comparable reconditioned model any electronic control module which proves to be defective in workmanship or material under normal use FOR A CHARGE OF 45 00 SO LONG AS THE SYSTEM WAS SOLD INSTALLED AND SERVICED BY A PROFESSIONAL AUTO INSTALLER AND REMAINS IN THE CAR IN WHICH THE SYSTEM WAS ORIGINALLY INSTALLED If warranty service is necessary you must have a clear copy of your sales receipt containing all of the information shown on the following page This warranty contains the entire agreement relating to
6. and release the Valet switch within 10 seconds The status LED will light steadily if you have entered Valet Mode To exit Valet Mode repeat the steps above The LED will turn off when exiting Valet Mode To activate Panic Mode M Press and hold A for 1 5 seconds Location of Shutdown Switch 2004 Directed Electronics Inc 15 The company behind this system is Directed Electronics Inc Since its inception Directed Electronics Inc has had one purpose to provide con sumers with the finest vehicle security and car stereo products and accessories available The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology Directed Electronics Inc is ISO 9001 registered Quality Directed Electronics products are sold and serviced throughout North America and around the world Call 800 361 7271 for more information about our products and services Directed Electronics is committed to delivering world class quality products and services that excite and delight our customers driven to excel Dxected ELECTRONICS INC Directed Electronics Inc 188 St Fran ois Xavier Delson Qc www directed ca 2004 Directed Electronics Inc All rights reserved 11CX 562C 9 4
7. for 30 seconds each time the system is disarmed using the transmitter This is useful for seeing inside the vehicle at night prior to entering it 2004 Directed Electronics Inc 11 12 2004 Directed Electronics Inc 2004 Directed Electronics Inc Notes 13 14 2004 Directed Electronics Inc Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet QUICK REFERENCE GUIDE To lock using your remote M To arm the system press A for one second The doors will Lock if con nected The LED will begin to flash The Failsafe Starter Kill will pre vent the vehicle s starter from cranking if it has been installed The ve hicle s horn if connected will honk and the parking lights will flash once to confirm arming of the system To unlock using your remote W To disarm the system press for one second The doors will unlock if connected The Failsafe Starter Kill will be deactivated and the vehicle s horn if connected will honk twice and the parking lights will flash twice Disabling the Failsafe Starter Kill without a transmitter M Turn on the ignition Press and release the Valet switch within 10 sec onds The LED will stop flashing and the vehicle should start Be sure to check with the installer for the location of the Valet switch To enter or exit Valet Mode WE Turn the ignition to the ON position Turn the ignition back off Press
8. n Disabling the Starter Kill Without a Transmitter If your remote transmitter is lost or damaged you can manually override the starter kill To do this you must have the vehicle s ignition key and know where the Valet switch is located Be sure to check with the installer for the location of the Valet switch To override the starter kill turn OFF the ignition on and press the 4 No 2 5 Valet switch within 10 seconds The status LED will stop flashing and the vehicle should start If it does not start you may have waited too long turn the ignition off and repeat the process LOCATION OF VALET SWITCH 2004 Directed Electronics Inc 7 Valet Mode You can prevent your system from automatically activating the Failsafe Starter Kill by using Valet Mode This is very useful when washing the vehicle or having it serviced In Valet Mode the starter kill cannot be activated even with the transmitter but all convenience functions will continue to work normally To enter or exit Valet Mode 1 Turn the ignition on 2 Turn the ignition off 3 Press and release the Valet switch within 10 seconds The status LED will light steadily if you are entering Valet Mode and will turn off if you are exiting Valet Mode Panic Mode If you are threatened in or near your vehicle you can attract attention by triggering the system with your transmitter Just press A
9. of the sales receipt showing the following M Date of purchase W Your full name and address W Authorized dealer s company name and address E Type of system installed W Year make model and color of the automobile M Automobile license number W Vehicle identification number E All security options installed on automobile M Installation receipts ii 2004 Directed Electronics Inc Table of Contents Limited Lifetime Consumer Warranty 1 Standard Configuration What is Included Important Information System Maintenance essences scrutin are 4 Your Warranty FCC ID Notice Transmitter Functions Standard Configuration Using Your System Disabling the Starter Kill Without Valet Mode Panic Mode Rapid Resume Logic Programming Options Glossary of Terms Convenience Expansions Notes od Quick reference guide 6 46 emesccscomecesusemeserecuoscouueseccese 15 2004 Directed Electronics Inc Standard Configuration a controls the Lock Panic ON Panic OFF function controls the Disarm function controls Silent Mode and an Auxiliary Output 2 2004 Directed Electronics Inc What is Included The control module An receiver antenna Two four button transmitters The status LED indicator light A push button Valet switch Your warranty registration A shut down toggle switch Important Information Congratulations on the purchase of your
10. onfirm arming of the system While the system is armed the status LED will flash once per second The Failsafe Starter Kill will also prevent the vehicle s starter from cranking The system can also be programmed to arm the optional Failsafe Starter Kill automatically called Passive Mode If the system has been programmed for Passive Mode the Failsafe Starter Kill will automatically activate 30 seconds after the ignition has been turned off After the ignition has been turned off the status LED will flash rapidly to indicate that the system is in Passive Mode If Passive Mode has been programmed on then it is also possible to program the system for Passive Locking With Passive Locking the vehicle doors lock automatically at the same time that the Failsafe Starter Kill is activated If Passive Locking is programmed on care must be taken to prevent the keys from being locked in the vehicle 6 2004 Directed Electronics Inc CESI Pressing d for one second disarms the system The horn will honk twice and the parking lights optional will flash twice to confirm disarming of the system The optional Failsafe Starter Kill will be deactivated The status LED will turn off unless the system is pro grammed for Passive Mode In Passive Mode the status LED will flash rapidly when the system is disarmed This indicates that the system will re engage the starter kill in 30 seconds unless the igni tion is turned o
11. remote start keyless entry system Due to the complexity of this system it must be installed by an authorized dealer only Installation of this product by any one other than an authorized dealer voids the warranty Al deal ers are provided with a preprinted dealer certificate to verify that they are authorized By carefully reading this Owner s Guide prior to using your system you will maximize the use of this system and its features You can print additional or replacement copies of this manual by accessing the Directed Electronics internet website at www directed ca 2004 Directed Electronics Inc 3 System Maintenance Maintenance The system requires no specific maintenance Your remote is powered by a small lightweight 3 volt lithium battery that will last approx imately one year under normal use When the battery begins to weaken operating range will be reduced and the LED on the remote will dim Your Warranty ES Your warranty registration must be completely filled out and returned within 10 days of purchase Your product warranty will not be validated if your warranty registration is not returned Make sure you receive the warranty registration from your dealer It is also necessary to keep your proof of purchase which reflects that the product was installed by an authorized dealer FCC ID Notice Notice This device complies with Part 15 of FCC rules Operation is subject to the following conditions
12. warranty and supersedes all previous and contemporaneous representations or understandings whether written or oral IN ANY EVENT DIRECTED ELECTRONICS INC IS NOT LIABLE FOR THE THEFT OF THE VEHICLE AND OR ITS CONTENTS This warranty is void if the product has been damaged by accident unreasonable use neglect improper service or other causes not arising out of defects in materials or construction This warranty is nontransferable and does not apply to any unit that has been modified or used in a manner contrary to its intended purpose and does not cover batteries The unit in question must be returned to the manufacturer postage prepaid This warranty does not cover labor costs for the removal diagnosis trou bleshooting or reinstallation of the unit For service on an out of warranty product a flat rate fee by model is charged Contact your authorized dealer to obtain the ser vice charge for your unit These systems are a deterrent against possible theft Directed Electronics Inc is not offering a guarantee or insuring against the theft of the automobile or its contents and disclaims any liability for the theft of the vehicle and or its contents Directed Electronics does not authorize any person to create for it any other obligation or lia bility in connection with this security system 2004 Directed Electronics Inc i TO THE MAXIMUM EXTENT ALLOWED BY LAW ANY AND ALL WARRANTIES ARE EXCLUD ED BY THE MANUFACTURER AND EACH ENTITY P
Download Pdf Manuals
Related Search