Avital 3100L Remote Starter User Manual
Contents
1. SwitchView SC 220 and 240 series switches are equipped with a front panel USB card reader port to support Common Access Card CAC functionality Front panel push buttons allow you to switch KVM sessions and the card reader together A yellow LED indicates the target device to which the KVM session and card reader port is connected Mechanical H x W x D 1 72 x 10 36 x 5 68 Weight 2 3 Ibs To Contact Avocent Technical Support Visit www avocent com Avocent the Avocent logo The Power of Being There the Cybex logo and SwitchView are registered trademarks of Avocent Corporation or its affiliates 2007 Avocent Corporation All rights reserved Environmental Operating Temperature 32 0 C to 104 40 C Storage Temperature 4 20 C to 122 50 C Input Power 8A Operating Voltage 100 240 VAC Power Frequency 50 60 Hz Supported hardware and specifications Servers IBM Sun PC AT USB PS 2 and 100 compatibles Video Modes VGA SVGA XGA SXGA UXGA WVGA WSVGA WXGA WSXGA WUXGA and HDTV Maximum Resolution 2048 x 1536 85Hz Peripherals USB and or PS 2 keyboard and mouse USB Common Access Card readers 590 718 5014 USA Notification Caution Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate this equipment Note This equipment has been tested and found to comply with the limits for a Class B digital devic2. ou gt Avocent The following will help you install your SwitchView SC switch easily Should you require further assistance please contact Avocent Technical Support 4 Connecting local peripherals Turn off all servers that will be part of your SwitchView SC switching system Plug your VGA monitor keyboard and mouse cables into the appropriate CONSOLE ports on the back of your SwitchView SC switch Powering your system Plug one end of the power cord into the SwitchView SC switch power supply Then plug the power supply into the SwitchView SC switch Next plug the other end of the powercord into an AC wall outlet Turn on your switch first then all attached servers ae Connecting your servers Using the SwitchView SC switch s peripheral cable set USB or PS 2 plug the cables into the corresponding ports on your server Plug the other end into any of the available server ports on your SwitchView SC switch Repeat this process until all servers are attached to the SwitchView SC switch A green LED indicates the target device is turned on Quick Installation Guide For models 120 140 220 240 The Power of Being There SwitchView SC Switch To install the SwitchView SC switch SwitchView SC240 switch shown O Switching your servers Press the appropriate numbered front panel button to access servers via your SwitchView SC switch Q Using the front panel card reader port
3. e pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures e Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver e Consult the dealer or an experienced radio TV technician for help e Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Canadian Notification This Class B digital apparatus complies with Canadian ICES 003 Cet appareil num rique de la classe B est conforme a la norme NMB 003 du Canada Japanese Approval ee Be LOB PRE R SRR A ERa VCCI Oe HOC PPABPTRERRERRCT OBB RE CHATSOL RHE LCWEDTM OBR Yates LEV as Se ELT AanNoL SMSe stole DN ET HRA ito TE LVR RV SLO PAY Safety and EMC Approvals and Markings UL FCC cUL ICES 008 CE C Tick VCCI Safety certifications and EMC certi
4. fications for this product are obtained under one or more of the following designations CMN Certification Model Number MPN Manufacturer s Part Number or Sales Level Model designation The designation that is referenced in the EMC and or safety reports and certificates are printed on the label applied to this product To Contact Avocent Technical Support Visit www avocent com Avocent the Avocent logo The Power of Being There the Cybex logo and SwitchView are registered trademarks of Avocent Corporation or its affiliates 2007 Avocent Corporation All rights reserved 590 718 5014
Download Pdf Manuals
Related Search