User Manual - produktinfo.conrad.com
Contents
1. PHONE Jack 50 meter wireless phone line User Manual 1 minute plug and play installation TECHNOLOGY SE a Ze m INSTALLATION GUIDE ENGLISH cassasasio Sadak gene a 4 DEAR CUSTOMER We would like to thank you for purchasing our Wireless Phone Jack and or an additional Extension unit We hope you will enjoy it The Wireless Phone Jack is a wireless and cable free extension of the phone socket or VoIP adapter for an ordinary phone modem fax or satellite cable set top box with integrated modem Please read the following thoroughly and observe the operating instructions and information provided Please visit our website for additional information www wireless phonejack com Conformity of the Wireless Phone Jack to EU directives is confirmed by the CE symbol Hereby we declare that the Wireless Phone Jack and or extra Extension units are in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC Ce Copyright All rights reserved All forms of copying or reproduction of the product or its associated user manual are strictly prohibited This product is manufactured for RTX Products HK Ltd UNPACKING Carefully remove units from the packaging If there is any visible damage DO NOT attempt to operate the Wireless Phone Jack Contact your dealer or shipping carrier immediately E 9 re m BOX CONTENTS Indicator light2. Light shows OPERATING MODES BASE UNIT This means Suggested fix Steady Green Base unit is ready No Extension units are in use None Normal operation handset registrations Flashing Green One or more Extension units None are in use Normal operation No Light No power to Check that the Base unit is properly Base unit connected to a power outlet and that the power is on Fast flashing Green The base unit is open for DECT The DECT handset registration mode is open after two power on off operations To terminate the registration mode either register a DECT handset or turn the base power off and then on Light shows This means EXTENSION UNIT Suggested fix Steady Green Extension unit in computer Data C is registered and in range of Base unit and ready for use None Normal operation registered to a Base unit Steady Yellow Extension unit in Speech voice None S is registered and in range Normal operation of Base unit and ready for use Flashing Green Extension unit in use None C mode Normal operation Flashing Yellow Extension unit in use None S mode Normal operation No Light No power to Extension unit Check that the Extension unit is properly connected to a power outlet and that the power is on Steady Red Extension unit is ready to be See Installation of extra Extension units Flashing Red to Yellow or Flashing Red to Green Fast flash of R
3. Phone socket Phone line 1 One Base unit Indicator light 2 One Extension unit Switch Phone socket 3 One phone line cord 4 This user manual NOTE Please read and follow carefully the instructions D BASE UNIT INSTALLATION 1 Connect the enclosed phone line cord to the Base unit and connect the other end to the phone wall socket 2 If you have a phone connected to the wall socket unplug it and connect it to the Base unit instead remove plug adapter before connecting to the Base unit 3 Connect the Base unit to a power outlet and switch power on The light on top of the Base unit should now glow green The Base unit is now installed 3 Power outlet 5 AS F 2 Da Qu a gt Phone dial up modem fax Phone wall socket 1 NOTE Works also as a wireless extension to a VoIP Terminal Adapter EXTENSION UNITINSTALLATION The Extension unit can be connected to either a normal phone dial up modem fax or satellite cable set top box 1 Plug the phone line cord from your phone dial up modem fax or satellite cable set top box into the Extension unit T Ts 3 x Phone dial up modem fax or Qe gt satellite cable set top box 1 Power supply plug 2 2A Connection of phone Turn the switch to S position for Speech voice 2B Connection of dial up modem fax or satellite cable set top box Turn the switch to C position for Computer dial
4. attached to the Extension unit when first picked up The extra extension unit is already registered to another phone jack The extra extension unit is blinking before starting a registration procedure Turn power on off 5 times in a row until the light is continuously red Hereafter continue extra extension extension unit installation A The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons Caution Main plug is used as disconnect device and it should remain readily operable during intended use In order to disconnect the apparatus from the mains completely the mains plug should be disconnected from the mains socket outlet completely The socket outlet shall be installed near the equipment and shall be easily accessible Warning Do not use this equipment in places where volatile or explosive materials may be present This equipment will be inoperable if mains power fails For indoor use only The crossed out wheeled bin symbol that can be found on your product means that the product is covered by the European Directive 2002 96 EC and it indicates mem that this product should not be disposed of via the normal household waste stream To prevent possible harm to the environment o
5. ed for 5 seconds followed by Steady Red occurring after an attempt to register an Extension unit Extension unit is registered but not locked to Base unit Four Extension units are already registered to the Base unit the max possible this fifth Extension unit cannot be added Check that Base unit is powered up Tf it is the Extension unit may be out of range of Base unit Relocate either the Extension unit or the Base unit to bring the units closer together Install an additional Base unit and register the fifth Extension unit to the new Base unit oo TROUBLESHOOTING Problem Possible cause Solution No dialing tone available Base unit power not on Cables not correctly connected The Extension unit may not be registered to the base The Extension unit is out Check all power and cable connec tions If in doubt please refer to the user manual Check that the Extension unit switch is correctly set to either S or C Relocate the Extension unit within dla a z m of reach signal reach of the Base unit max 50m Make sure that the Extension unit switch is set to C The Extension unit switch has not been set to modem functionality My dial up modem set top box fax is not working Make sure that the Extension unit switch is set to S The Extension unit switch has not been set properly Short hissing sound heard on phone
6. r human health please separate this product from other waste streams to ensure that it can be recycled in an environmentally sound manner For more details on available collection facilities please contact your local govern office or the retailer where you purchased this product 9
7. up modem fax or satellite cable set top box 3 Plug the Extension unit into a power outlet and switch the power on The light on top of the Extension unit will after a short period glow green if the switch is on C or yellow if the switch is on S The Extension unit is now installed and your Wireless Phone Jack is now ready for use Computer dial up modem fax or satellite cable set top box a 2B Speech Phone 2 Extension unit INSTALLATION OF EXTRA EXTENSION UNITS 1 Make sure the existing Wireless Phone Jack system base and extension unit is powered on 2 Unplug any cords attached to the Base unit these will be connected again later 3 Plug the extra Extension unit into a power outlet near the Base unit and switch power on This will activate a red light on the Extension unit 4 Plug one end of the supplied phone line cord into the Base unit and the other end into the extra Extension unit A red light will be activated before changing to either green if the switch is turned over to C computer for dial up modem fax or set top box or yellow if the switch is turned over to S speech for phone This can take up to a minute 5 Once the light changes on the Extension unit unplug the phone line cord between the Base unit and the Extension unit 6 Replug the cords which you have unplugged Go to page 4 Extension unit installation to finish the installation process ne 9 zj zZ m
Download Pdf Manuals
Related Search