printing temperature recorder User Manual
Contents
1. 5 7 mm 230 mm maximum 2000 approx O30 mm roll 12 7 mm LCD amp 12 character alphanumeric 54x 110 x 183 mm 630 grams IP2X If the equipment is used in a manner not specified by the manufacturer the protection provided by the equipment may be impaired be THE QUEEN S AWARDS C FOR ENTERPRISE manufactured by Electronic Temperature Instruments Ltd Easting Close Worthing West Sussex BN 14 8HQ tel 01903 202151 fax 01903 202445 email sales etilfd com www etilid com 13 06 142. 1 Un clip the printer cover handle fig 1 2 Pull the printer cover handle until the cover un clips To avoid damage to the handle do not use excessive force Fig 2 3 Litt the lid until completely open tig 3 4 Remove any existing paper or the plastic tube from the previous roll The easiest way to do that is to turn the PTR upside down so the printer contents tall out tig 4 5 Prepare a new paper roll remove the outer packaging and the holding sticker Place into printer as shown in Fig 5 The glossy side ot the paper should be against the printing mechanism 6 Push the paper fully into the printer housing tig 6 7 Close the lid leaving a short strip of the paper roll protruding from the printer fig 7 8 Lock the cover by pressing shut Push the printer cover handle shut fig 8 SPECIFICATION range operating temp range resolution accuracy battery battery lite battery charging temp range battery charging cycles charging power supply sensor type connector type printer type paper width paper roll diameter print lines per roll display dimensions weight IP rating 200 to 1372 C 328 to 2051 F 5 to 50 C amp 10 to 80 rh 0 1 C F 1 F above 1999 9 F 0 4 C 0 1 of reading Ni MH 3 6V approximately 500 prints from a full charge 5 to 40 C gt 500 INPUT 100 240V 47 63Hz OUTPUT 12V 3 3A 40Watt thermistor 1 1AMax miniature thermocouple thermal
3. button is pressed the current temperature is measured and then a ticket is printed with this information along with any alarm activations If there is no paper loaded or the printer cover is open Paper out will be displayed tor five seconds but the reading will still be stored The LIMITS START STOP button is used to start and stop logging To start logging press the START STOP button once To stop logging press the START STOP button Stop Log will be displayed Press the START STOP button again to confirm the log is to be stopped The log MUST be stopped before the instrument can be switched off LOGGING PRINT LOG SUMMARY AND CURRENT TEMPERATURE USING PRINT BUTTON MODE When the print button is pressed the current temperature is measured the alarm limits and the number of alarm activations per input will be printed lf there is no paper loaded or the printer cover is open Paper out will be displayed tor five seconds but the reading will still be stored The LIMITS START STOP button is used to start and stop logging To start logging press the START STOP button once To stop logging press the START STOP button Stop Log will be displayed Press the START STOP button again to confirm the log is to be stopped The log MUST be stopped before the instrument can be switched off BATTERIES The PTR is titted with a 3 cell rechargeable 3 6V NiMh battery pack It is NOT user replaceable Please return to the ETI Service Department for ba
4. PTR printing temperature recorder User Manual order code 226 275 CONTENTS Introduction probes functions display PTR overview PTR operation switching the PTR on or off changing input displaying limits feeding paper modes of operation on demand mode summary mode log mode batteries recharging the PTR connecting device to the PC reset cleaning paper loading procedure specification INTRODUCTION The PTR Printing Temperature Recorder is a hand held temperature measuring device that prints and logs temperature readings The PTR measures temperature across the range of 200 C 328 F to 1372 C 2501 F with a resolution 0 1 C F above 1999 9 C F When the PTR is tully charged up to 500 prints can be achieved Up to 8000 readings can be stored in memory PROBES The PTR can be used with the standard range ot ETI thermocouple probes fitted with a miniature thermocouple plug The probes are connected via the 4 miniature thermocouple sockets at the top of the instrument FUNCTIONS The PTR control panel consists of five buttons ON OFF Switches the PTR On Off INPUT Changes selected input LIMITS START STOP Displays High or Low Limit in on demand mode Starts and stops logging in log and summary modes FEED Feeds the paper PRINT Takes a reading prints a ticket and logs the reading date and time in memory DISPLAY The display consists of a 12 character alphanume
5. nt and the printer cover is closed the stored readings will be retrieved and printed in sequence When log mode is first set up with the PC software the instrument will display ready All button functions are retained The LIMITS START STOP button is used to start and stop logging To start logging press the START STOP button once To stop logging press the START STOP button Stop Log will be displayed Press the START STOP button again to confirm the log is to be stopped Once a log has been started the log MUST be stopped before the instrument can be switched off All stored readings can be retrieved later using the Printing thermometer PC software LOGGING PRINT LOG SUMMARY USING PRINT BUTTON MODE When the print button is pressed the alarm limits and the number of alarm activations per input will be printed It there is no paper loaded or the printer cover is open Paper out will be displayed tor five seconds but the reading will still be stored In summary mode all button functions are retained except the on off button The LIMITS START STOP button is used to start and stop logging To start logging press the START STOP button once To stop logging press the START STOP button Stop Log will be displayed Press the START STOP button again to confirm the log is to be stopped The log MUST be stopped before the instrument can be switched off Y LOGGING PRINT CURRENT TEMPERATURE USING PRINT BUTTON MODE When the print
6. on print current temperature using print button and print log summary and current temperature using print button ON DEMAND MODE Untick logging When the print button is pressed a temperature measurement will be taken from all selected inputs and a ticket containing the current temperature values along with whether the current readings exceeded limits will be printed It there is no paper loaded or printer cover is open Paper out will be displayed for tive seconds but the reading will still be stored Atter a ticket has been printed the display will show Copy for five seconds 6 Pressing the Print button during this time prints a copy of the last ticket In on demand mode all button functions are retained LOGGING DO NOT PRINT MODE The print button is disabled and the LIMITS START STOP button is used to start and stop logging To start logging press the START STOP button once lo stop logging press the START STOP button Stop Log will be displayed Press the START STOP button again to confirm the log is to be stopped The log MUST be stopped before the instrument can be switched off LOGGING PRINT EACH LOG AUTOMATICALLY MODE The print button is disabled and the printing is automatically timed at set intervals selected by the user If there is no paper loaded or the printer cover is open Paper out will be displayed but the reading will still be stored When a roll of paper is placed in the instrume
7. ric section and a four and a halt digit temperature section Low battery indication is shown by Lo Bat PTR OVERVIEW probe sockets O EE vinn PTR Printing Temperature Recorder printer cover cover handle LCD reset button charge indicator USB socket power socket control panel PTR OPERATION SWITCHING THE PTR ON OR OFF The On Off button switches the PTR on or off Switch off will be displayed tor two seconds before shut down is complete The unit cannot be switched oft using the On OYf button during a log The log must be stopped first CHANGING INPUT To scroll through the four inputs press the Input button The selected input will be displayed on the screen Inputs change in a continuous loop Up to four inputs can be selected using the PC software DISPLAYING LIMITS In on demand printing mode the high or low limit for the selected input can be viewed by pressing the Limits button When the high or low limit is selected the temperature value displayed represents the corresponding limit and the name of the input alternates with High Limit or Low Limit respectively FEEDING PAPER Press the Feed button to feed the paper It there is no paper loaded or the printer cover is open Paper out will be displayed for five seconds MODES OF OPERATION The instrument has six modes of operation on demand log do not print Logging print log summary using print butt
8. ttery replacement When the PTR power is low the Lo Bat segment of the LCD is lit Print and feed operations are inhibited when Lo Bat is indicated Pressing the Print or Feed buttons will result in Recharge being displayed tor a short time in the display RECHARGING THE PTR To recharge the PTR remove the rubber cap and plug the power cable into the socket on the right of the instrument A flashing Charging LED indicates that the device is being charged A slow flashing LED once second indicates normal charging A fast flash rate four times second indicates a charging fault probably the batteries are too cold to charge 8 The PTR should only be recharged in an ambient temperature between 5 and 40 C 41 and 104 F Charge only with an ETI PTR power supply 12V 3 3A 40Watt Damage may occur if other power supplies are used CONNECTING DEVICE TO THE PC To connect the PTR to a PC remove the rubber cap and plug the USB cable into the socket on the lett side ot the instrument Use the Printing Thermometer PC software to customise PTR settings and ticket layout and to download stored reading RESET If the PTR tails to respond press the reset button on the front of the instrument which is situated to the lett of the display CLEANING Clean only the outside of the instrument with a damp cloth or anti bacterial wipe PAPER LOADING PROCEDURE To reload the printer with a new paper roll follow the steps below
Download Pdf Manuals
Related Search