Sea-doo Seascooter Dolphin
Contents
1. To replace a flat battery with a fully charged battery 1 Follow the steps 1 to 4 on page 6 to open the SEASCOOTER 2 Unplug the battery at the socket by pressing the locking feature shown in fig 4 on page 7 3 Remove the flat battery 4 Install and connect the charged battery in the correct position see fig 6 Ge 5 Follow steps 11 to 12 on page 7 to close the SEASCOOTER Buying batteries Additional batteries can be purchased separately Contact your dealer to purchase them Care And Maintenance Battery Care e The battery should be recharged as soon as possible after use e If the unit is not used for extended periods the battery should be removed from the unit and charged overnight every three months e Only use the charger supplied with the SEASCOOTER e Never place the battery in a sealed container when charging e Never short circuit the battery or battery cable e Never place store the battery near a radiator fire etc To store the battery remove it from the SEASCOOTER or separate it from the charger insulate the battery terminals and keep in a place that is dry and cool e Ambient temperature for storage should be within the range 20 C to 40 C 4 F to 104 F Care after using the SEASCOOTER e Always rinse the SEASCOOTER in fresh water and allow it to dry before storage e Whenever possible rinse the SEASCOOTER in fresh water immediate2. age 5 Battery Use Charging the Battery for charging and connection CAUTION e The Battery Housing should always be ventilated during charging to allow potentially explosive gasses to dissipate Before removing attaching any Using the SEASCOOTER for swimming and snorkeling battery cables always allow two minutes for any gasses to dissipate To use the SEASCOOTER for swimming or snorkeling follow these instructions e ALWAYS connect charger jack to the battery first and then plug the charger into the mains When 1 Charge the battery see page 6 for instructions charging is complete unplug the charger from the mains first and then from the battery 2 Place the SEA DOO SEASCOOTER DOLPHIN into the water e ALWAYS ensure the charger is DRY before plugging it into a live socket 3 When ready to set off switch the Safety Lock to the On position shown in fig 2a e NEVER place the battery in a sealed container when charging 4 Pull and hold both Triggers to start the Propeller There is a short delay before the Propeller begins to Never charge battery near water rotate If in doubt of the state of the battery recharge it 5 To stop the Propeller simply release one or both until the indicator on the battery charger indicates trigger s a full charge 6 Always set the Safety Lock to the Off position when i e ALWAYS charge battery in a well ventilated place out of the water see fig 2b where unit i
3. al to get the most out of your DOLPHIN Parts Diagram A N WARNING e Not to be used by children under the age of eight 8 and must ONLY be used by children under adult supervision e Read the user manual carefully e Never stick body parts clothing or other objects in the vicinity of the propeller e Do not wear loose or flowing clothing or equipment that could be drawn into the propeller e Particular care should be exercised when using the Seascooter near anybody with long hair Users with long hair should tie it up or wear a swimming cap when using the Seascooter e Always inspect the swimming area to ensure it is free of hazards or obstacles such as boats and swimmers before using the Seascooter Nose Cone i Q Safety Switch e Always charge the battery to its fullest before using the 2 Battery leads and Connector Front Grille Seascooter Ensure sufficient battery charge to return to the shore 3 7Ah Battery 1 Nozzle Seal Propeller e The Seascooter is not a personal flotation device always wear a coast guard approved personal flotation device G Latch 3 Rear Grille when using the Seascooter ilicon Handle Silicone Ge e Do not use the Seascooter under the influence of alcohol Trigger or drugs Q o Getting Started DOLPHIN Battery Use When you buy the SEA DOO SEASCOOTER DOLPHIN the battery is disconnected and needs to be charged follow the instructions on p
4. eM Produit Autoris Licensed Product SEA DO and BRP logo are trademarks of Bombardier Recreational Products Inc or its affiliates used under license to Stallion asia For more information on SEA DOO products visit www seadoo com Patented Print in China KJ Stallion saon Product www stallionsport com User Manual Pa E SENSJOO W SEA DOO SEASCOOTER DOLPHIN Model no ZS06 CAUTION ELECTRICALLY OPERATED PRODUCT Not recommended for children under 8 years of age As with all electrical products precautions should be observed during handling and used to reduce the risk of electric shock Contents Introduction Parts diagram WARNING Getting started Battery use Care amp Maintenance Trouble Shooting Technical Specifications S 2 amp Introduction Thank you for having chosen the SEA DOO SEASCOOTER DOLPHIN The DOLPHIN adds a new dimension of fun and excitement to swimming and snorkelling Years of design and engineering have resulted in a water scooter that gives you power up to 2 mph 3 2 km h speed for up to 60 minutes of use but at the same time is compact and light The DOLPHIN weight just 12 lbs 5 4 kg The DOLPHIN features various safety features making it safe for kids ages 8 and up These are positive buoyancy protective grilles auto shut off when triggers are released and safety lock Please take a little time to study this manu
5. in or washers 7 Remove the blockage from the Propeller 8 Replace the drive pin if removed see fig 9 and Propeller Turn the Propeller slowly until you locate the pin and push the Propeller fully on o Drive Pin In Position 9 Replace the washer and nut and tighten with the socket whilst holding the Propeller making sure it is securely fastened See fig 10 10 Replace the Rear Grille 11 Replace the battery and connect and replace the Nose Cone Propeller hub DA Nut Drive pin Washer Technical Specifications Sand or Grit on Seal Unit Dimensions 285 x 283 x 483 mm Sand or grit is the enemy of seals Correct maintenance Unit Weight 12 Ibs 5 4 kg with rechargeable battery and care is essential To remove sand or grit from the seal rinse the seal in fresh water and apply fresh 5 3 Ibs 2 4 kg without rechargeable battery lubricant If there is sand inside the Battery Housing Battery Type 1x 12v 7 5Ah rechargeable battery gently brush the sand from the unit taking care not to Battery Life Approximately 1 5 hours scratch the sealing surfaces Depth rating 15ft 5m SEASCOOTER cuts out Up to 2 0 mph 3 2km h To protect the electronic circuit of your SEASCOOTER from damage a safety mechanism has been built in that cuts the power if a wall or rock or other immovable object is hit lf this occurs simply wait for a short period to allow the SEASCOOTER to reset itself and resume
6. ly after use O e To clean the SEASCOOTER do not use detergents only use a damp cloth to wipe the unit clean e The Battery Housing interior should be kept dry at all times If the Battery Housing interior ever gets wet see page 14 Accidental Flooding for steps to take e When storing the SEASCOOTER for extended periods of time open and remove the Nose Cone e ALWAYS store your SEASCOOTER vertically when not in use to prevent deformation of the Propeller Nozzle Trouble Shooting Unit does not function If the motor does not start when both triggers are pressed make sure 1 The battery is properly connected 2 The battery is fully charged see page 6 charging the battery 3 The Safety Lock is in the On position see fig 2a page 4 4 There is no water in the battery compartment see page 14 accidental flooding Blocked Propeller If the Propeller becomes blocked the Rear Grille and Propeller can be removed to remove the obstacle Removing rear grille and Propeller to remove obstruction 1 Remove the SEASCOOTER from the water 2 Make sure the Safety Lock is in the Off position 3 Disconnect and remove the battery 4 Unscrew the eight Rear Grille screws as shown in fig 7 on page 12 9 5 Whilst holding the Propeller use an M6 socket to remove the nut from the Propeller shaft See fig 8 6 Slide the Propeller off the shaft taking care not to loose the drive p
7. s out of reach of children On Position Off Position e ALWAYS ensure the unit is dried thoroughly before opening the Nose Cone for charging or changing the battery O Charging the battery For battery charging follow these instructions 1 Always ensure that the Safety Lock in the Off position is Off see fig 2b 2 Always ensure that the SEA DOO SEASCOOTER DOLPHIN is out of the water and placed in a dry area 3 Pull the latches down and remove the Nose Cone as shown in fig 3 4 Allow two minutes for any gasses to dissipate 5 Disconnect the battery cable from the housing cable if not already disconnected the cable will be disconnected when you buy your SEASCOOTER by pressing the locking feature as shown in fig 4 Press here to release and pull to disconnect 6 Connect the battery cable to the charger cable 7 Plug charger into mains and turn on the supply Do not replace the Nose Cone 8 Charging will take 13 14 hours for a fully discharged battery When the battery is charging the red LED is lit remains on when the battery is charged the green LED is lit 9 Unplug the adapter from the mains 10 Unplug the battery cable from the charger cable and reconnect to the housing cable 11 Make sure the seal and sealing surfaces are clean and lubricated before replacing the Inner Nose Cone See fig 5 Ensure sealing surface is clean and seal is lubricated
8. use Accidental Flooding Be sure to keep the seal sand and grit free to ensure they keep water out and to close the latches fully after accessing the battery chamber However should the seal not be clean or the latches not fully closed and water enter the battery chamber your SEASCOOTER will not be damaged as it is designed for protection against accidental flooding If water enters the battery chamber 1 Remove the unit from the water 2 Open the battery chamber remove the battery and if salt water has entered rinse it out with fresh water 3 Dry the battery chamber and battery thoroughly and reassemble ready for use 5
Download Pdf Manuals
Related Search