DM615N Series
Contents
1. DM615N 650 and DM615N 850 UPS are equipped with Green Power Function For saving power and protecting battery the method of deep discharging protection is adopted on inverter mode Trouble shooting Use the table below to solve minor problems If any abnormal situations occur that are not listed above please call service technician for assistance Possible Cause No LED display on Powe Ghane the UPS at least 6 hours the front panel Battery fault Replace the battery with the same type of battery The UPS is not turned on Press the power switch again to turn on the UPS Alarm continuously The UPS is overload Remove some loads first Before reconnecting sounds when the equipment please verify that the load matches mains is normal the UPS capability specified in the specs When power fails The UPS is overload Remove some critical load back up time is Battery voltage is too low Charge the UPS at least 6 hours shortened Battery defect It might be due to high Replace the battery with the same type of temperature operation environment or battery improper operation to battery The mains is normal Power cord is loose Reconnect the power cord properly but LED blinks Specifications 6o 8o 1000 1500 2000 INPUT Voltage 110 120 VAC or 220 230 240 VAC Voltage Range 81 145 VAC 162 290 VAC OUTPUT Voltage Regulation 10 Transfer Time Typical 2 6 ms 10 ms max Waveform Simulated Sine Wave BATTERY Ty2. d for installation in a controlled environment temperature controlled JL eee oL USB com port indoor area free of conductive contaminants Avoid installing the UPS in location where 4 Modem Phone Network surge there is standing or running water or excessive humidity protection DO NOT plug the UPS input into its own output QHH ME WEIG DO NOT attach a power strip or surge suppressor to the UPS a a SN DO NOT attach non computer related items such as medical equipment life support equipment microwave ovens or vacuum cleaners to UPS To reduce the risk of overheating the UPS do not cover the UPS cooling vents and avoid exposing the unit to direct sunlight or installing the unit near heat emitting appliances such Installation amp Operation as space heaters or furnaces Unplug the UPS prior to cleaning and do not use liquid or spray detergent 1 Placement x x NE DO NOT dispose of batteries in a fire as they may explode Install the UPS in a protected area that is free of an DONOT open or mutilate the battery or batteries Released electrolyte is harmful to the excessive dust and has adequate air flow Please place the UPS away from other units at least 20 cm to avoid interference DO NOT operate the UPS where the temperature and humidity is outside the specific limits Please check the specs for the limitations 2 Charging Plug in the AC input cord to the wall outlet For the best results suggest char
3. ging the battery at least 4 hours before initial use The unit charges its battery while connecting to the utility 3 Connection of Equipment Plug in the loads to output receptacles on the rear panel of the UPS 4 hours Simply turn on the power switch of UPS unit then devices connected to the UPS will be protected by UPS unit 4 Connection of Network To surge protect a network connection connect a network cable from the wall jack outlet to the IN jack of the UPS Then connect a network cable from the OUT jack of the UPS to the network device 5 Connection of Communication UPS equipped with communication port allows monitoring and controlling from computer screen Connect one end of a communication cable to your PC and the other to the com port at the rear of the UPS ViewPower is an UPS power management software allowing users to control and monitor UPS straightly from PC monitor Insert ViewPower software CD or download ViewPower software from http www power software download com to your hard drive Follow on screen instructions to complete the software installation After computer is restarted ViewPower is geared and presents as an orange plug icon located in the system tray at the right bottom corner Viewpower configuration UPS setting Control View Format Language Heip 6 Turn On Off To turn on the UPS press power switch lightly To turn off the UPS please press power switch again 7 Green Power Function
4. nd phoneline surge production System Description v Built in RS 232 communication port p 5 l v Compact size light weight k fee ee AC Mode green lighting Important Safety Instructions O Battery Mode green flashing To safely operate this uninterruptible power supply system please read and follow all instructions l2 3 AC mode indicator green lighting carefully Please read this manual thoroughly before attempting to unpack install or operate UPS O 4 Battery mode indicator yellow and keep this manual for further reference O flashing 5 Fault mode indicator red lighting This UPS utilizes voltages that may be hazardous Do not attempt to disassemble the unit 6 AC Mode indicating load level The unit contains no user replaceable parts Only authorized service personnel may Batt Mode indicating battery perform repairs L J A capacity Internal battery voltage is 12V DC Sealed lead acid 6 cells battery Connection to any other type of receptacle other than a two pole three wire grounded receptacle may result in shock hazard as well as violate local electrical codes Inthe event of an emergency press the OFF button and disconnect the power cord from p N the AC power supply to properly disable the UPS 3 6 Eil DO NOT allow liquids or any foreign object to enter the UPS Do not place beverages or Ne 2P Ho 3 Para any other liquid containing vessels on or near the unit Os ala 3 p p This unit intende
5. onnel This UPS is specially aimed for use with multi function personal computer It is equipped with away from batteries _ l l l boost amp buck AVR to stabilize the wide input voltage range It also comes with high efficient When replacing batteries replace with the same number of the sealed lead acid batteries switch mode battery charger This charger design minimizes power loss to save charging time e The socket outlet shall be installed near the equipment and easily accessible The built in DC start function enables the UPS to be started up without a supply of AC power The With the installation of the UPS it should be prevented that the sum of UPS and the main features of this UPS are listed below connected load leakage current exceeds 3 5mA E This pluggable type A equipment with battery installed by the supplier is operator installable a and may be operated by laymen Microprocessor control guarantees high reliability Attention Hazardous through electric shock Also with disconnection of this unit from the Built in enhanced boost amp buck AVR mains hazardous voltage still may be accessible through supply from battery The battery Fast charger supply should be therefore disconnected in the plus and minus pole at the connectors of the Green power function for energy saving battery when maintenance or service work inside of the UPS is necessary v DC start function v Auto restart during AC recovery os v Provide Modem a
6. pe amp Number Charging Time 4 6 hours recover to 90 capacity Dimension DxWxH mm 397x146x205 Net Weight kgs 425 49 so m 11 5 Humidity Noise Level USB Product specifications are subject to change without further notice
7. skin and eyes It may be toxic A battery can present a risk of electrical shock and high short circuit current The following precautions should be observed when working on batteries 1 Remove watches rings or other metal objects from the hands DM61 5N Series i 2 Use tools with insulated handles 3 Wear rubber gloves and boots User s Man ual 4 Do not lay tools or metal parts on top of batteries 5 Disconnect charging source prior to connecting or disconnecting battery terminal Servicing of batteries should be performed or supervised by personnel knowledgeable of Introduction batteries and the required precautions should be taken Keep unauthorized pers
Download Pdf Manuals
Related Search