USER MANUAL - Shop 63 Computers and Electronics
Contents
1. 000 VU QUICK INSTALLATIONS amp OPERATION Inspection Remove UPS from its package and inspect it for damage before installation If any damage is found re pack and return the unit to the place of purchase Placement Install the UPS in a protected area that is free of excessive dust and has adequate air flow DO NOT operate the UPS where the temperature and humidity is outside the specific limits ll eee 20cm I Ml Connect to Utility amp Charging Plug in the AC input cord to the wall outlet For the best results suggest to charge the battery at least 4 hours before initial use The unit automatically charges ts battery while connecting to the utility Connect the Loads Plug in the loads to output receptacles on the rear panel of the UPS Simply turn on the power switch of UPS unit then devices connected to the UPS will be protected by the UPS CAUTION NEVER connect a laser printer or scanner to the UPS unit This may cause the damage of the unit Connect Modem Phone Line Connect a single modem phone line into surge protected IN outlet on the rear panel of the UPS unit Connect from OUT outlet to the computer with phone line cable Connect Communication Cable To allow for unattended UPS shutdown start up and status monitoring connect the communication cable one end to the USB port and the other to the communication port of your PC With the monitoring software i2. ME 650 VU 850 VU ME 1000 VU 2000 VU Thank you for purchasing this UPS To safely operate this uninterruptible power supply system please read and follow all instructions carefully Please read this manual thoroughly before attempting to unpack install or operate UPS and keep this manual for further reference IMPORTANT SAFETY INSTRUCTIONS This UPS utilizes voltages that may be hazardous DO NOT attempt to disassemble the unit The unit contains no user serviceable parts Only factory service personnel may perform repairs Internal battery voltage is 12VDC Connection to any other type of receptacle other than a two pole three wire grounded receptacle may result in shock hazard as well as violate local electrical codes Inthe event of an emergency press the OFF button and disconnect the power cord from the AC power supply to properly disable the UPS DO NOT allow liquids or any foreign object to enter the UPS Do not place beverages or any other liquid containing vessels on or near the unit This unit intended for installation in a controlled environment temperature controlled indoor area free of conductive contaminants Avoid installing the UPS in locations where there is standing or running water or excessive humidity DO NOT plug the UPS input into its own output DO NOT attach a power strip or surge suppressor to the UPS DO NOT attach non computer related items such as medical equipment life supp
3. echarge Time 4 6 hours recover to 90 capacit ALARM 10 50Hz or 60Hz 1 Hz Typical 2 6 ms 10 ms max Simulated Sine Wave i Sounding every 10 seconds Sounding every second Sounding every 0 5 second Continuously sounding ow Battery Overload Fault PHYSICAL Dimension DXWXH 350 x 146 x 397 x 146 x mm 287 x 100 x142 160 205 Net Weight kgs 425 49 80 115 ENVIRONMENT Humidity Noise Level NTERFACE Windows2000 2003 XP Vista 2008 7 Linux Unix and USB Port MAC Product specifications are subject to change without further notice ped D s lt lt oO Q D 0 90 RH 0 40 C non condensing Less than 40dB
4. nstalled you can schedule UPS shutdown start up and monitor UPS status through PC Turning On Off the Unit Turn on the UPS unit by pressing the power switch Turn off the UPS unit by pressing again the power switch You may check the front LED indicators for the status Cold Start Function When the UPS is off and there is no power utility it s still possible to cold start the UPS unit to power the loads Monitoring Software Setup Please follow steps below to install the software 1 Insert the included CD into CD ROM drive and then follow the on screen instructions If there no screen shows when inserting the CD after 1 minute please execute setup exe for initiating software installation 2 After computer restarts the monitoring software will appear as an orange plug icon amp located in the system tray TROUBLE SHOOTING to 4 hours type of battery Powercordloose___ _ Re plug the power cord fuse or there is a blackout ilure load more Battery defect due to high Replace with the same temperature operation type of battery environment or improper operation to battery SPECIFICATIONS INPUT 360W 480W 600W 1200W 110 120 VAC or 220 230 240 VAC Voltage Range 81 145 VAC or 162 290 VAC OUTPUT AC Voltage Regulation Batt Mode Frequency Range Batt Mode Transfer Time Waveform Batt Mode BATTERY Battery Type amp Number V7 An xj 12 V9 Ah x 12 v 7 Ahx2 12 VI9 Ah x 2 pical R
5. ort equipment microwave ovens or vacuum cleaners to UPS To reduce the risk of overheating the UPS do not cover the UPS cooling vents and avoid exposing the unit to direct sunlight or installing the unit near heat emitting appliances such as space heaters or furnaces Unplug the UPS prior to cleaning and do not use liquid or spray detergent DO NOT dispose of batteries in a fire as they may explode DO NOT open or mutilate the battery or batteries Released electrolyte is harmful to the skin and eyes It may be toxic A battery can present a risk of electrical shock and high short circuit current The following precautions should be observed when working on batteries 1 Remove watches rings or other metal objects from the hands 2 Use tools with insulated handles 3 Wear rubber gloves and boots 4 DO NOT lay tools or metal parts on top of batteries 5 Disconnect charging source prior to connecting or disconnecting batteries terminals Servicing of batteries should be performed or supervised by personnel Knowledgeable of batteries and the required precautions Keep unauthorized personnel away from batteries When replacing batteries replace with the same number and type of sealed lead acid battery This pluggable type A equipment with battery already installed by the supplier is operator installable and may be operated by laymen USER MANUAL During the installation of this equipment i
6. t should be assured that the sum of the leakage currents of the UPS and the connected loads does not exceed 3 5mA Attention hazardous through electric shock Also with disconnection of this unit from the mains hazardous voltage still may be accessible through supply from battery The battery supply should be therefore disconnected in the plus and minus pole at the connectors of the battery when maintenance or service work inside the UPS is necessary The mains socket outlet that supplies the UPS shall be installed near the UPS and shall be easily accessible PRODUCT OVERVIEW ME 650 VU 850 VU Fault red USB port lighting g Power switch AC mode Modem phone surge f j AN G aie sie j protection att mode yellow flashing Output receptacles AC input Modem phone surge protection Batt mode yellow flashing USB port Power switch AC mode AC input green lighting Fault red lighting Output 4 receptacles ME 2000 VU Fault red lighting AC mode indicating 92299 TE Power switch load level AG ede Batt mode indicating green lighting battery capacity Batt mode green flashing USB port Modem phone surge protection AC input Output receptacles USER MANUAL ME 650 VU 850 VU ME 1000 VU 2
Download Pdf Manuals
Related Search