M１５５ - sakamoto model corporation
Contents
1. M155 S Intramuscular Injection model of Upper arms SAKAMOTO MODEL CORPORATION User s Manual 120618 a l INDEX Introduction Table of Contents 1 Purpose Content 2 Precautions concerning handling 3 Usage Storage method 4 Please open your parcel and check the main unit and accessories of the product immediately upon receipt If the products are delivered damaged or with parts missing please contact our company or the distributor AARTI WAE TIL Introduction Thank you for purchasing our product Intramuscular Injection simulator of Upper arms Read this user s manual carefully in order to use the product for a long time appropriately This product is closely checked before factory shipment However when this product arrives open it soon and check if anything on the main unit and accessories are missing or broken Table of contents Introduction Table of Contents ccceceeeeeeeeees 1 Purpose Content rient unr EE ean 2 Precautions concerning hand ling cceeeeeeeeeees 3 Usage Storage method ccccccecececeeseseeeseesesess 4 Purpose Training can be performed for the following items 1 Judgment of intramuscular injection of Upper arms Contents 1 Main unit including the drainage bag 1 set 2 Battery cells four AA alkali cells Y Ip a Precautions concerning handling L 10 When performi2. er whether intramuscular injection has succeeded or not If training was performed in a proper position including depth the green lamp will light up If the injected site was not appropriate the red lamp will light up and the buzzer will sound If that position was correct but the needle was inserted too deep both the red and green lamps will light up and the buzzer will sound Storage method 1 After the fluid is drained stand the model and store it 2 Most of the water injected in an appropriate position will be drained after a while Water drops left in the injected sites or the drain tube will not leak out but dry soon because the material allows air to pass through 3 Do not store the product in a place exposed to direct sunlight or hot and humid air 4 Be sure to take out the battery cells before storing the model Be careful as the battery cells might corrode and cause a power fault if not removed SAKAMOTO MODEL CORPORATION Head office 34 Higashitakagicho Shimogamo Sakyo ku KYOTO 606 0865 JAPAN Phone 81 75 701 1135 Fax 81 75 722 5638 E mail info sakamoto model com URL http sakamoto model co jp Overseas Sales Department 9 29 Senbahigashi Minoh City Osaka 562 0035 JAPAN Phone 81 72 729 8350 Fax 81 72 729 8385 E mail trade sakamoto model com
3. ng practice using this product use a fresh needle tip Otherwise the epidermis and or sensor might be degraded Use water tap water only for training Do not use any fluids other than water Pay sufficient attention to handling the product because it is fragile Do not apply a load on the transparent section Doing so might damage the product When the model gets dirty wipe off the dirt using a soft cloth with a neutral detergent Do not use benzine thinners or polishing powders Since the cover might drop if raising the model by holding it on the cervix hold the model under both arms to raise it Use four AA alkali battery cells Set them while paying attention to polarity When the volume of the buzzer becomes smaller or the lamp becomes darker than before replace them with new ones If anything strange is detected when this model is being used stop using it and notify the dealer or us as soon as possible This product is a simulator for users to perform advanced training Nonetheless it does not guarantee that a similar effect can be obtained by actual treatment Note in advance that this product is subject to change without notice to improve it Usage 1 Set four AA alkali battery cells in the battery box while paying attention to polarity 2 Turn on the power switch 3 The injection site can be confirmed by palpating the acromion 4 Perform training 5 It is judged by the embedded lamp and buzz
Download Pdf Manuals
Related Search