DEHUMIDIFIER - sinclair air conditioners
Contents
1. Drainage Tank Capacity 6 0L automatic stop at about 5 5L Weight 12 5kg 14kg Dimension height X width X depth 545mm X 380mm X 261 5mm e The dehumidification capacity is the value obtained after the dehumidifier was continuously run in the room temperature of 30 C with the relative humidity 80 The amount of dehumidification is the amount per day 24 hours If specifications are changed without notice for further improvement they are data on nameplate of the unit e The work temperature is in the range 2 C to 38 C If the room temperature is beyond the range the unit can not operate normally o working temperqture range of maximum charge dehumidifying 35C DB 26 C WB 2 Structure and Principle How dehumidifying works ooling unit Re heating unit 5 5 draws room air cools it with a cooling unit J and changes the humidity to drops of water 2 The drops of water fall into a drainage tank Moist air _y Dried air 3 The dehumidified air is re heated by a heating unit and discharged Steps 1 and 3 are repeated to remove humid ity from the room Compressor 4 Drainage tank After the air passes through the re heating unit its temperature will rise a little so that the tempera ture of the room will rise appreciably This is normal phenomenon Structure and Principle Structure of dehumidifier Handle Louver Opera2. 2 1 0 switch Press the switch once to start operation press it again to stop operation 6 O switch Each time the switch is pressed the operation mode changes in the order of DEHUMIDIFY LAUN DRY and QUIET and the corresponding mode indicator lamp will change with the operation mode The default is DEHUMIDIFY when the indoor temperature is above 35 C the protection device is actuated the unit only can operate in LAUNDRY mode and pressing switch is ineffective Tee switch Press the switch to set the humidity of the room which be set in order of 50 60 70 and continuous defanlt is continuous When the relative humidity of the room is lower than your setting humidity the operation will stop automatically Operation Draining the water If the drainage tank becomes full approx 5 5 liters the t lamp lights to alert the user operation stops automatically Empty the water from the drainage tank and discard it Drainage steps Notation for drainage 1 Remove the drainage tank Do not remove the bubble packing from the float on the unit in order to prevent water from leaking fa 2 from the water tank onto household furniture This can cause electrical shock and or short circuiting If the drainage tank is dirty wash it with cold or oO lukewarm water Do not use
3. the air filter 4 Store the unit Package the unit to keep it free of dust and keep it upstanding and store it at a cool and dry place 12 Maintenance Notation for safe operation When use the unit please observe the following safety precautions 1 When the unit works in LAUNDRY mode keep it an appropriate distance away from the clothings and prevent the water from dropping onto it 2 Before clean the unit or when do not use it for along period of time unplug the power supply cord 3 Do not wash the unit with water also put the unit close to water explosive or flammable things 4 Do not set the unit close to heat generating devices or near inflammable and dangerous article 5 Never put your fingers or objects into the intake or discharge ports 6 Do not sit or stand on the unit 7 Discard water that has collected in the tank timely 8 Do not run the dehumidifier in an closed area such as inside closets or fire can take place 9 Do not use the unit for special purposes such as edible items objects of art or scientific materials are stored 10 Install drain piping in a downhill grade to make sure that condensed water can be drained continuously 11 If the supply cord is damaged it must be replaced by the manufacture or its service agent or a similarly qualified person in order to avoid a hazard 192 Maintenance Removing breakdowns If a condition listed below occurs please check the following items to
4. 15 Maintenance Removing breakdowns The following symptoms do not indicate a breakdown Symptom Reason The operation noise suddenly increases The operation noise increases when the compressor is during use activated Is the room too big for the unit Are windows or doors opened and closed frequently Is there a device in the room such as a kerosene stove which emits steam Very little dehumidifying takes place or This happens if the temperature and or humidity of the room none takes place is low Because the temperature of the head exchanger rises abruptly an unusual or musty odor may be produced for a moment The humidity do not drop When the unit is first used the dis charged air smells musty eis Maintenance The unit echoes When operation is started or the opera tion mode is changed an unusual noise is heard in main unit There are some stains left in the drain age tank The unit only can run in laundry mode and it is ineffective to press mode switch The fan is running and the compressor does not work If the unit is used in a room with wood flooring or in a small room it may echo The refrigerant may take some sound until circulation stabilizes This is water left from the dehumidifying test conducted at the factory it does not indicate a problem When the temperature of the room is above 35 C the protec tion device is actuated so that the unit only can run in LAUN D
5. RY mode the fan speed is high If the unit is started within 3 minutes after the unit stops the protection device is actuated so that the compressor is started automatically after a delay of 3 minutes or the automatic defrosting operation is activated and the compressor stops APPENDIX Electric Schematic Diagram HUMIDITY SENSOR TOA PS 220 230 50Hz POWER CORD HOSVV F IGL Omn WHATE SWITCH LED 43p05 18
6. USER S MANUAL CFO 12E CFO 20E Before using your dehumidifier please read this user s manual carefully in order to ensure cor rect and safe use After reading the manual make sure it is stored in a safe place for future refer ence if necessary Features Specifications How dehumidifying works Structure of dehumidifier Operation steps Operation panel Draining the water Caring for the dehumidifier Storing the dehumidifier Notation for safe operation Removing breakdowns Electric Schematic Diagram Structure and Principle Features Taking advantage of refrigeration principle the de humidifier powerfully removes partial moisture from air to drop the humidity of the room and keep indoor air dry and comfortable When the dehumidifier operates in QUIET mode the value of its noise is so low and makes your room quiet The dehumidifier uses the no CFC refrigerant for protecting environment to reduce to pollute environment The dehumidifier dries laundry quickly This can prevent laundry and furniture from becoming damp and musty in a rainy season The drainage tank capacity is large to 6 liter this will reduce the times of your discarding water The power consumption is low Structure and Principle Specifications Power Supply 220 230V 50Hz Dehumidifying Capacity 12L day 20L day Power Consumption 220W 400W
7. detergent scouring pads chemically treated dustcloths gasoline benzene thinner or other solvents to clean it as these can scratch and damage the tank and cause water to leak When place back the drainage tank press the tank firmly into place with both hands If the tank is not Take hold of the handle and then remove the tank positioned properly the O Tank FullO sensor will be activated and the dehumidifier will not operate Check to make sure the guards are firmly attached to the tank If they are not the drainage tank will be harder to remove e Wait at least 30 minutes before removing the drain age tank in order to prevent the water which still in the cooling unit from dripping out on the base plane If water has dripped wipe it up discard the water Draining the water Continuous drainage of water The unit has a continuous drainage port Using a commercial hose with an inner diameter of 15mm the water in the drainage tank can be continuously drained out of the continuous port of the unit When setting up the equipment for continuous drainage always stop operation first and unplug the power supply plug 1 Disconnect the drainage tank and open the con tinuous drainage port Use nippers or a similar tool to cut away the continuous drainage port in the side of the main unit 2 Push the hose into the continuous drainage port Pass a commercial hose with an inner diameter
8. help you to save your time and cost Has the power supply cord been Plug the power supply cord into the disconnected outlet The unit does not Is the 127 lamp blinking The Discard the water in the drainage operate tank is full or in a wrong position tank and then reposition the tank The protection device is actuated and the unit can not be started in case operation is under the bad environment in that case please do not use the dehumidifier Is the temperature of the room above 38 C or below 2 C 14 Maintenance The dehumidifying function does not work No air is discharged Operation is noisy Is the air filter clogged Is air intake port or discharge port obstructed Is the air filter clogged Has the unit been poorly installed so it is tilted or unsteady Is the air filter clogged Clean the air filter as instructed un der Caring for the dehumidifier Remove whatever is obstructing the discharge port or intake port Clean the air filter as instructed un der Caring for the dehumidifier Use the unit in a stable sturdy location Prompt Put a cushion under the unit and help to reduce operation noise Clean the air filter as instructed un der Caring for the dehumidifier e After the above condition has occurred and corresponding step is used but the breakdown can not be removed or other breakdown occurs please contact the authorized service centers
9. of 15mm through the continuous drainage port and press it firmly into the drainage port in the main unit make sure water does not leak The level height of drain piping should al ways be not higher than the one of the drainage port also drain piping should always be not plugged up so the con densed water can be drained out successfully 3 Return the drainage tank to its original position Check the hose periodically to make sure it is still connected and has not been obstructed 210 Make sure at lease some place is provided around it when the unit is operating At least 50 cm At least 20 cm At least 20 cm At least 20 cm IJ At least 20 cm Note Please stop working and discard the water before move the dehumidifier Tilt it within range of 30 degrees 11 Maintenance Caring for the dehumidifier Clean the air filter The air filter should be cleaned approximately once two week First Remove the air filter then run a vacuum cleaner lightly over the surface of the air filter to remove dirt If the air filter is very dirty wash it with warm water and a neutral cleaning solvent and dry it thoroughly attach the airfilter Storing the dehumidifier When the unit is not to be used for a long period of time 1 Fold up the power supply cord and secure it to the holder 2 Discard any water left in the drainage tank and wipe away any remaining drops with a cloth 3 Clean
10. tion panel Discharge port Plastic film Float Water level gauge Drainage tank NOTE Please take off the plastic film before using 4 Structure and Principle Air filter Air intake port do not obstruct Continuous drain age port Power supply plug Operation steps 1 Plug the power supply plug into the outlet 2 Open the louver by hand 3 Press the power suitch 4 Select operation mode or let it run in the default mode 5 Press the power switch once again to stop operation Operation panel 4 50 60 70 3 6 Indicator lamp Bi 1 Tank full indicator lamp It will light when the drainage tank is full or positioned incorrectly Empty the water out of the drainage tank and make sure the tank is positioned properly 2 Power indicator lamp It will light when the unit is plugged in 3 mode indicator lamp When y lamp or TP lamp or 7 lamp is lighted it respectively indicates that operation is DEHUMI DIFY LAUNDRY or QUIET mode 4 Humidity indicator lamp When 50 lamp 60 lamp or 70 lamp is lighted it respectively indicates that the current setting humidity is 50 60 or 70 CON Continuously dehumidity indicator lamp When CON lamp is lighted it indicates that the operation is in CONTINUOUS mode Operation Switch function
Download Pdf Manuals
Related Search