EN - User`s manual ()
Contents
1. 56321 N TRAINTIODULES Track occupation feedback LocoNet User s manual lt 998975130093 2011 BioDigit Ltd All rights reserved It is forbidden to reproduce and or publish the contents of the present document in any form including electronic and mechanical design without the written permission of BioDigit Ltd A Safety warning During the operation of the device the specified technical parameters shall always be met At the installation the environment shall be fully taken into consideration The device must not be exposed to moisture and direct sunshine A soldering tool may be necessary for the installation and or mounting of the devices which requires special care During the installation it shall be ensured that the bottom of the device should not contact with a conductive e g metal surface Contents Safety WARNING srk 1 2 Technical parameters 2 Short 8508 2 AT a 2 PROQFAMMING 2 Guarantee and legal 4 2 4 Properties e LocoNet system e Individual input addressing e Quick programming possibility e Integrated interference suppression on inputs e High current capacity e2. No need of external power source Technical parameters Idle mode current consumption 20 mA Max current consumption 35 mA Max load current of the outputs 1A section Dimensions 63x56 mm Short description The module connected to the rail sections reports the occupation of the given track section by usual Feedback commands towards the digital centre Due to the integrated interference filtering the possible contact faults of the vehicle passing along the section will not cause false occupation feedback Wiring The module senses track occupation on the basis of the current passing along it thus the supply current of each section shall be passed through a feedback module Figure 1 If wiring is correct in case the B1 B4 sections shown in the drawing are occupied the B1 B4 LEDs will light indicating the section occupation Programming The feedback address belonging to the section outputs can be selected between 1 and 2047 During programming the feedback module can be addressed by means of usual switch operating commands Programming steps 1 Keep the PROG button pressed for two seconds 2 Flashing of the LED B1 indicates waiting for feedback address 3 In the digital centre set the switch address equal to the feedback address 4 In the digital centre send the switch operating command to any direction 5 After successful address acceptance the LED B2 will flash Repeat the steps in 3 and 4 also
3. for LEDs 4 7 At the programming of the last address each LED will automatically dark Programming was successful If the address belonging to the given section B1 B4 need not be modified it is possible to skip to the address setting of the next section if the PROG button is shortly pressed Guarantee and legal statement Each parameter of the device was submitted to comprehensive testing prior to marketing The manufacturer undertakes one year guarantee for the product Defects occurred during this period will be repaired by the manufacturer free of charge against the presentation of the invoice The validity of the guarantee will cease in case of improper usage and or treatment Attention By virtue of the European EMC directive the product can be used solely with devices provided with CE marking The mentioned standards and branch names are the trademarks of the firms concerned TrainModules BioDigit Ltd Kerepesi street 92 H 1144 Budapest Made in Hungary Tel 36 1 46 707 64 http www trainmodules hu Figure 1 LocoNet LocoNet
Download Pdf Manuals
Related Search